Abstract
The friction and wear properties of the nylon coating, prepared by hot-extrusion, used to protect the surface of the flexible continuous sucker rod were studied by using a pin-on-disc wear tester in the simulated oil well environment. The effects of sliding speed and load were considered. The wear mechanism was also studied by using a scanning electron microscope (SEM). The result shows that the friction coefficients of both kinds of materials, JKPA and ZZ7024B, used to protect the surface of the flexible continuous sucker rod decrease with sliding speed increase, but change little with load increase in the simulated oil well environment. The value of friction coefficient of ZZ7024B is smaller than that of JKPA. The minimum value of friction coefficient of ZZ7024B is about 0.05. The wear volume of ZZ7024B is smaller than that of JKPA under the same conditions of experimentation.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Mo Yimin, Cheng Shichun,et al. An Investigation on Full Sets of Protection Technologies for Flexible Continuous Oil Pumping Rod and Its Industrialization.Proceedings of The Second International Conference on Surface Engineering, 1999.
J Bijwe, C M Logani and U S Tewari. Influence of Fillers and Fiber Reinforcement on Abrasive Wear Resistance of Some Polymeric Composites.Wear, 138, 1990:77–92
J H Bye and C Allen. Dry Sliding Wear Behavior of Polyamide 66 and Polycarbonate Composites.Tribology International, 25, 1992:237–246
S Bahadur, Q Fu, D Gong. The Effect of Reinforcement and the Synergism Between CuS and Carbon Fiber on the Wear of Nylon.Wear, 178, 1994:123–130
C J Hooke, S N Kukureka, P Liao, M Rao, Y K Chen. Wear and Friction of Nylon-glass Fibre Composites in Non-conformal Contact Under Combined Rolling and Sliding.Wear, 197, 1996:115–122
S N Kukureka, C J Hooke, M Rao, P Liao, Y K Chen. The Effect of Fibre Reinforcement on the Friction and Wear of Polyamide 66 Under Dry Rolling and Sliding Contact.Tribology International, 32, 1999:107–116
M Palabiyik, S Bahadur. Mechanical and Tribological Properties of Polyamide 6 and High Density Polyethylene Polyblends with and Without Compatibilizer.Wear, 246, 2000(1–2):149–158
Xiangguo Hu. Friction and Wear Behaviors of Toughened Polyoxymethylene Blend Under Water Lubriction.Polymerplastics Technology and Engineering, 39, 2000(1):137–150
C Z Liu, L Q Ren, J Tong. Statistical Wear Analysis of PA-6/UHMWPE Alloy, UHMWPE and PA-6.Wear, 249, 2001(1–2):31–36
Author information
Authors and Affiliations
Additional information
MO Yi-min: Born in 1960
Funded by Key Scientific and Technological Project of Wuhan (No. 991002036G)
Rights and permissions
About this article
Cite this article
Yi-min, M., Yun-ping, P. & Xiu-mei, W. The tribological properties of the hot-extrusion nylon coating in the oil well environment. J. Wuhan Univ. Technol.-Mat. Sci. Edit. 18, 58–60 (2003). https://doi.org/10.1007/BF02838393
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF02838393