Abstract
The commercial scale production of Fe-6.5wt% Si sheet has been successfully developed. Fe-6.5wt% Si sheets ranging in thickness from 0.1 to 0.5 mm can be manufactured in coil form with a maximum width of 400 mm.
The following magnetic properties have been achieved.
-
1.
The maximum permeability is about 10 times higher than that of the conventional nonoriented silicon steel, and could be doubled by magnetic field annealing.
-
2.
The core losses are less than half of the conventional nonoriented silicon steel’s, and even less than the grain oriented silicon steel’s at a frequency range of over 400 Hz.
-
3.
The coefficient of magnetostriction is extremely small (6 x 10-7). It is less than one-tenth of the conventional nonoriented silicon steel’s.
Fe-6.5wt% Si sheet should be used extensively as an electric and electronic material, owing to its own supreme soft magnetic properties. For example, this sheet is good for use in motor cores or high frequency transformer cores, supreme magnetic shields, and so on.
The details of the magnetic properties of Fe—6.5wt% Si sheet and some applications to electric devices are described.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
R.M. Bozorth,Ferromagnetism, D. Van Nostrand Co., p. 30, 1951.
G. Facaros and R.G. Aspden,J. Appl. Phys., 33, p. 1220, 1962.
K. Narita and M. Enokizono,IEEE Trans. on Magnetics, vol. Mag. 14, p. 258, 1978.
N. Tsuya and K.I. Arai, 3M Conf., Cleveland, p. 6A-1, 1978.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Abe, M., Takada, Y., Murakami, T. et al. Magnetic properties of commercially produced Fe-6.5wt% Si sheet. J. Materials Engineering 11, 109–116 (1989). https://doi.org/10.1007/BF02833761
Issue Date:
DOI: https://doi.org/10.1007/BF02833761