Abstract
ANNEALED aluminum/silicon carbide (Al/SiC) composites exhibit a relatively high density of dislocations, which are frequently decorated with fine precipitates, in the Al matrix. This high dislocation density is the major reason for the unexpected strength of these composite materials. The large difference (10:1) between the coefficients of thermal expansion (CTE) of Al and SiC results in sufficient stress to generate dislocations at the Al/SiC interface during cooling. In thisin situ investigation, we observed this dislocation generation process during cooling from annealing temperatures using a High Voltage Electron Microscope (HVEM) equipped with a double tilt heating stage. Two types of bulk annealed composites were examined: one with SiC of discontinuous whisker morphology and one of platelet morphology. In addition, control samples with zero volume percent were examined. Both types of composites showed the generation of dislocations at the Al/SiC interface resulting in densities of at least 1013 m-2. One sample viewed end-on to the whiskers showed only a rearrangement of dislocations, whereas, the same material when sectioned so that the lengths of whiskers were in the plane of the foil, showed the generation of dislocations at the ends of the whiskers on cooling. The control samples did not show the generation of dislocations on cooling except at a few large precipitate particles. The results support the hypothesis that the high dislocation density observed in annealed composite materials is a result of differential thermal contraction of Al and SiC. The SiC particles act as dislocation sources during cooling from annealing temperatures resulting in high dislocation densities which strengthen the material.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
M. R. Piggott:Loading Bearing Fibre Composites, Pergamon Press, Oxford, 1980.
R. J. Arsenault:Mat. Sci. and Eng., 1984, vol. 64, p. 171.
R. J. Arsenault and R.M. Fisher:Scr. Metall., 1983, vol. 17, p. 67.
A. Taylor and R. M. Jones:Silicon Carbide, J. R. O’Connor and J. Smiltens, eds., Pergamon Press, Oxford, 1960, pp. 147–54.
K.K. Chawla and M. Metzger:J. of Mat. Sci., 1972, vol. 7, p. 34.
K. F. Hale, M. Henderson-Brown, and Y. Ishida:Proc. 5th European Congress on Electron Microscopy, 1972, p. 350.
D. Caillard and S.L. Martin:Acta Metall., 1983, vol. 31, p. 813.
J. K. Kivilahti, V. K. Lindroos, and B. Lehtinen:Proc. 3rd Int. Conf. on HVEM, P. R. Swann, C. J. Humphreys, and M. J. Goringe, eds., Academic Press, London, 1974, p. 19.
M. Shimotomori and R.R. Hasiguti:J. Japan Inst. Met., 1979, vol. 43, p. 4.
A. Wolfenden:Radiat. Eff., 1972, vol. 14, p. 225.
J.O. Stiegler and K. Farrell:Proc. 3rd Int. Conf. on HVEM, P. R. Swann, C. J. Humphreys, and M. J. Goringe, eds., Academic Press, London, 1974, p. 341.
G.C. Weatherly:Met. Sci. J., 1968, vol. 2, p. 237.
M.F. Ashby, S.H. Gelles, and L.E. Tanner:Phil. Mag., 1969, vol. 19, p. 757.
J.C. Williams and G. Garmong:Metall. Trans. A, 1975, vol. 6A, p. 1699.
J. K. Lee, Y. Y. Earmme, H. I. Aaronson, and K. C. Russell:Metall. Trans. A, 1980, vol. 11A, p. 1837.
M.F. Ashby:Phil. Mag., 1970, vol. 21, p. 399.
A. Szirmae and R. M. Fisher: “Techniques of Electron Microscopy, Diffraction, and Microprobe Analysis”, Special Technical Publ. #372, ASTM, 1965.
L.E. Samuels:Metallographic Polishing Methods, Sir Issac Pitman & Sons, Ltd., Melbourne, 1971, p. 79.
D. G. Howitt:Analytical Electron Microscopy, Roy H. Geis, ed., San Francisco Press, San Francisco, CA, 1981, p. 252.
P. D. Townsend, J. C. Kelly, N. E. W. Hartley:Ion Implantation, Sputtering, and Their Applications, Academic Press, London, 1976, p. 311.
G. Dupuoy: “Megavolt Electron Microscopy”,Proc. 3rd Int. Conf. on HVEM, P.R. Swann, C.J. Humphreys, and M. J. Goringe, eds., Academic Press, London, 1974, p. 447.
H. Fujita, T. Tabata, N. Sumida, and K. Yoshida:Proc. 3rd Int. Conf. on HVEM, P. R. Swann, C. J. Humphreys, and M. J. Goringe, eds., Academic Press, London, 1974, p. 427.
K. F. Hale and M. Henderson-Brown:Micron, 1973, vol. 4, p. 69.
J. Feng: Master’s Thesis, Univ. of Maryland, College Park, MD, 1981.
B. Hirsch, R.B. Nicholson, A. Howie, D.W. Pashley, and M.J. Whelan:Electron Microscopy of Thin Crystals, Butterworth & Co., London, 1965, p. 423.
J. Lee: private communications, Michigan Technological University, Houghton, MI, 1984.
E. P. Butler and K. F. Hale: “Dynamic Experiments in the Electron Microscope”, inPractical Methods in Electron Microscopy, Audrey M. Glauert, ed., Elsevier/North Holland Biomedical Press, Amsterdam, 1981, vol. 9.
G.M. Seamans and E. P. Butler:Metall. Trans. A, 1975, vol. 6A, p. 2055.
S.B. Fisher:Radiat. Eff., 1970, vol. 5, p. 239.
Y. Flom and R. J. Arsenault:Mater. Sci. and Eng., 1985, vol. 75, p. 151.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Vogelsang, M., Arsenault, R.J. & Fisher, R.M. Anin situ HVEM study of dislocation generation at Al/SiC interfaces in metal matrix composites. Metall Trans A 17, 379–389 (1986). https://doi.org/10.1007/BF02643944
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF02643944