Abstract
An investigation to study the development and propagation of microcracks in plain concrete was conducted. Cored and sawn cylindrical specimens were strained to predetermined stress levels at different strain rates and then after unloading polished and stained sections of axially sliced specimens were analysed under a microscope at times 30 magnification. Crack orientation and the contributions of the upper and lower halves of aggregates (with respect to the direction of compaction) towards total crack density were observed.
Résumé
Après déformation sous charges de carottes et d'éprouvettes cylindriques sciées, des sections polies et traitées au colorant ont été examinées au microscope. Les caractéristiques de cette étude qui diffèrent de celles fournies par des recherches antérieures sont: a) les fissures ont été marquées sur toute la section de coupes longitudinales suivant l'axe de l'éprouvette, et b) les examens ont été faits en tenant compte à la fois du niveau de contrainte et de la vitesse de déformation.
Non seulement on pense obtenir une meilleure compréhension du mécanisme de rupture, mais on espère que l'étude décrite ici contribuera à dégager une appréciation et une définition meilleures des paramètres à partir et une définition meilleures des paramètres à partir desquels on pourra élaborer une théorie satisfaisante.
L'étude des fissures d'adhérence a été faite en posant que chaque grain de granulat pouvait être divisé en deux moitiés (supérieures ou inférieures par rapport à la direction du compactage). L'origine première de la microfissuration résidait dans la perte d'adhérence; jusqu'à la contrainte de dilatation, il ne s'est produit qu'une légère augmentation de la perte d'adhérence qui correspondait aux moitiés supérieures des grains. On note pour le rapport des fissures d'adhérence se rapportant aux moitiés supérieures et inférieures des grains une valeur minimale d'approximativement 50% de la contrainte maximale. La concentration des fissures était plus grande dans la direction horizontale pour tous les niveaux de contrainte, bien qu'on ait constaté une augmentation continue de la quantité correspondante de fissures verticales. En opposition aux études précédentes, on n'a pas noté d'augmentation significative des fissures du mortier d'enrobage jusqu'à la valeur de la contrainte maximale; on a simplement observé qu'elles augmentaient rapidement tandis que la charge s'exerçait après la ruine. L'augmentation de la vitesse de déformation déterminait un accroissement de la fissuration du mortier d'enrobage, bien que la concentration moyenne des fissures demeurait approximativement constante.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Robinson G.S.—Methods of determining the formation and propagation of microcracking in concrete. The Structure of Concrete (Editors A.E. Brooks and K. Newman), Cement and Concrete Association, London, 1968, p. 131–145.
Slate F.O., Olsefski S.—X-rays for study of internal structure and microcracking of concrete. Journal of the American Concrete Institute, Proc. Vol. 60, 1963, p. 575–588.
Hsu T.T.C., Slate F.O., Sturman G.M., Winter G. —Micro-cracking of plain concrete and the shape of the stress-strain curve. Journal of the American Concrete Institute, Proc. Vol. 60, 1963, p. 770–781.
Shah S.P., Chandra S.—Critical stress, volume change, and microcracking of concrete Journal of the American Concrete Institute, Proc. Vol. 65, 1968, p. 770–781.
Hoek E.—Rock failure under static stress conditions. CSIR Report MEG383, Pretoria, 1965.
McCreath D.—The fracture mechanics of concrete. Ph. D. Thesis, Imperial College, London, 1968.
Dhir R.K.—A study of photoelastic stressmeters. Ph. D. Thesis, University of Sheffield 1966.
Hargreaves J.A.—Investigation of strain distribution and mode of fracture around openings in rock using photoelastic coating technique. Honours Thesis, University of Dundee, 1969.
Hsu T.T.C..—Mathematical analysis of shrinkage stresses in a model of hardened concrete. Journal of the American Concrete Institute, Proc. Vol. 60, 1963, p. 371–390.
Theocaris P.S., Koufopoulos T.—Photoelastic analysis of shrinkage microcracking in concrete. Magazine of Concrete Research, Vol. 21, 1969, p. 15–22.
Krishnaswamy Z.T.—Strength and microcraking of plain concrete under triaxial compression. Journal of the American Concrete Institute, Proc. Vol. 65, 1968, p. 856–862.
Dhir R.K., Sangha C.M.—A study of the relationships between time, strength, deformation and fracture of plain concrete. Magazine of Concrete Research, Vol. 24, 1972, p. 197–208.
Alexander K.M., Wardlaw J.—Dependence of cement-aggregate bond-strength on size of aggregate. Nature, Vol. 187, 1960, p. 230–231.
Moavenzadeh F., Bremmer T.W.—Fracture of Portland cement concrete. Int. Conf. on Structure, Solid Mechanics and Engineering Design in Civil Engineering, Southampton University, 1969.
Sangha C.M., Dhir R.K.—Strength and complete stress-strain relationships for concrete tested in uniaxial compression under different test conditions. Materials and Structures. No. 30, 1972, p. 361–370.
Meyers B.L., Slate F.O., Winter G.—Relationship between time-dependent deformation and microcracking of plain concrete. Journal of the American Concrete Institute, Proc. Vol. 66, 1966, p. 60–68.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Dhir, R.K., Sangha, R.M. Development and propagation of microcracks in plain concrete. Mat. Constr. 7, 17–23 (1974). https://doi.org/10.1007/BF02482676
Issue Date:
DOI: https://doi.org/10.1007/BF02482676