Abstract
Coating of alumina powders with tetragonal zirconia grains in the nanometric size range was obtained from a modified zirconium n-propoxide sol.
Powder sedimentation observations and washing experiments were performed to show modifications of particles surface. Amorphous precursor film formation and crystalline zirconia coating were characterized by transmission electron microscopy. Crystallographic relationships between zirconia and alumina particles were also observed.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Garvie, R.C., Hannink, R.H., and Pascoe, R.T., “Ceramic steel?” Nature 258[5537]703(1975).
Lange, F.F., “Transformation toughening” J. Mater. Sci. 24, 225–263 (1982).
Wang, J. and Stevens, R., “Zirconia-toughened alumina (ZTA) ceramics.” J. Mater. Sci. 24, 3421–3440 (1989).
Guinebretière, R., Trolliard, G., Marchais, T., Soulestin, B., and Dauger, A., “Mullite-zirconia composite obtained by sintering of sol-gel coated mullite powder.” Submitted to the J. Am. Ceram. Soc. (1992).
Green, D.J., “Critical microstructures for microcracking in Al2O3-ZrO2 composite.” J. Am. Ceram. Soc. 65 [12] 610–614 (1982).
Sacks, M.D., Lee, H.W., and Pask, J.A., “A Review of powder preparation methods and densification procedures for fabricating high density mullite” pp. 167–207 in Ceramics Transactions Mullite and Mullite Matrix Composites. Vol. 6. Ed. S. Somiya, R.F. Davis and J.A. Pask, American Ceramic Society, Inc. Westerville Ohio, (1990).
Wallace, J.S., Claussen, N., Ruhle, M., and Petzow, G., “Development of phases in in situ reacted mullite zirconia composites” pp. 155–65 in Surfaces and Interfaces in Ceramic and Ceramic Metal Systems. Ed. by J. Pask and A. Evans, Plenum Publishing Corporation, (1981).
Brodhag, C., Bach, J.P., Thevenot, F., and Deletter, M., “Microstructure of Zirconia-toughened Alumina obtained through Different Precursor Routes.” Materials Science and Engineering, A109 53–59 (1989).
Cortesi, P., Bowen, H.K., “Continuous coating of alumina particles with alkoxide-derived zirconia particles.” Geramics International 15, 173–177 (1989).
Fegley, B., White, P., Bowen, H.K., “Preparation of Zirconia-Alumina powders by Zirconium Alkoxide Hydrolysis.” J. Am. Ceram. Soc. 68 [2] C60-C62 (1985).
Guinebretière, R., Ruin, P., Lecomte, A., and Dauger, A., “Fabrication and sintering of zirconia sol-gel coated cordierite powder” pp. 929–936 in Ceramic Powder Science III, Vol. 12, Ed. G.L. Messing, S.I. Hirano and H. Hausner, American Ceramic Society, Inc. Westerville Ohio, (1990).
Guinebretière, R. “Elaboration d'un matériau composite cordierite-zircone. Enrobage d'une poudre ceramique par voie sol-gel” Thesis, Limoges University France (1991).
Kimura, T., Kaneko, Y., and Yamaguchi, T., “Consolidation of Alumina-Zirconia Mixtures by a Colloidal Process.” J. Am. Ceram. Soc. 74 [3] 625–32 (1991).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Ruin, P., Melin, G., Guinebretiere, R. et al. Coating of oxide powders with alkoxide derived zirconia. J Sol-Gel Sci Technol 2, 539–544 (1994). https://doi.org/10.1007/BF00486305
Issue Date:
DOI: https://doi.org/10.1007/BF00486305