Abstract
Permeable pavements benefits are large and well-studied all over the world by the scientific community however they are still not yet frequently used in urban projects. In order to explore permeable pavement benefits an Agent-Based-Model (ABM) was built. The model addresses the impact of the soil occupation of an urban catchment on its hydrological response. Specifically, it aims at quantifying the impacts of permeable pavement on runoff. ABM allows for exploring global phenomena by the integration of local processes. In this model, a simple micro-scale rule (move to the adjacent cell with the lowest piezometric level) performed by all the agents Drops gives a very relevant flow simulation at catchment-scale. This conceptual model is GIS-based and does not require important hydraulic data. Results show that turning 2.5% of the impervious cover into permeable pavements can reduce the runoff by 8.3%. Model exploration highlights where and in which proportion permeable pavements should be used to be the most efficient.
Access provided by Autonomous University of Puebla. Download conference paper PDF
Similar content being viewed by others
Keywords
1 Introduction
The long term process of urbanization, hand in hand with the demographic growth, have resulted in the alteration of the natural hydrological cycle. Indeed, the increase of impervious surfaces in urban catchment leads to the increase of surface runoff through the decreased of infiltration and evaporation capacity (Braud et al. 2013; Haase 2009; Jacobson 2011; Miller et al. 2014). Meanwhile, climate change is likely to lead to an increase of the frequency of extreme rainfall events that will be accompanied by a more frequent occurrence of short duration floods (Yin et al. 2016). Over the past decades, alternative approaches known as Low Impact Development (LID) have been developed to address these issues. Among them, permeable pavements are particularly well adapted for urban planning in dense urban areas. They are well studied all over the world by the scientific community (Brunetti et al. 2016; Illgen et al. 2007). However, permeable pavements are still not yet frequently used in urban projects. The development of a new pervious concrete formulation at the ESITC laboratory (Nguyen et al. 2014) highlighted the need for tools to help local authority and stakeholder to use these techniques. In this context, modeling permeable pavement benefits on runoff in an urban setting, is increasingly relevant given their high potential benefits. Authors underline also the need for model that integrated the individual component and the urban water cycle at catchment scale (Fletcher et al. 2013; Salvadore et al. 2015). However, building an integrated model at a fine space and temporal resolution is often compromised by the complexities of urban environment and the hydraulic data needed (Chen et al. 2009). One solution is the use of simplified approaches based on cellular automata (Webber et al. 2018). This paper describes the development and test of an Agent-Based-Model (ABM). The model is GIS-based and is applied to an urban catchment in Normandy. This model will help to explore the benefits of permeable pavements on surface runoff with high spatial (1 m2) and time (1 min) resolution. The final goal of this work is to give recommendations on where and in which proportion permeable pavements should be used to be the most efficient.
2 Materials and Methods
2.1 Catchment Description
Ouistreham is located in the North-West of France, in the region of Normandy (49°17′ N 0°16′ W). The climate is oceanic with rainfalls all year long and a little seasonality variability. The average annual temperature is 11.6 °C and the average annual precipitation is 679 mm. The catchment consists of a district of Ouistreham, named Riva Bella, built by the sea from the year 1960. This 48.3 ha catchment is built on a dune, sandy soil, and has the particularity of not having any storm water sewage network. Indeed rainfalls were historically infiltrated into the dune as all sidewalks and parts of the road were not covered. In the past few years, with the waterproofing of roads and sidewalks, flooding started to occur during heavily rainfall events. To deal with the runoff infiltration wells have been dug at strategic localizations but they require regular maintenance as the sand clogs them quickly.
Topography was obtained from a Lidar database (Litto3D®) with a horizontal resolution of 1 m and a vertical precision of 20 cm. Land use was defined from aerial photography and field observation, Fig. 1.
2.2 Model Development
Entities, State Variables, and Scales
The model is developed with NetLogo which is a multi-agent programmable modeling environment. ABM consists of two major elements: cellular automata (cells) and agents. First ArcGIS is used to develop land use and topography rasters. Next, NetLogo applies the rasters information to a grid of cells of 1 m2 dimension. Then, from its land use attribute, each cell gets hydrological attributes in terms of interception (in mm) and infiltration (in mm/min). Two other attributes are used in case the cell is turned into permeable pavement, the flow in (in mm/min) giving the maximum water flow that can enter into the pavement, and the storage (in litres) giving the maximum storage allowed inside the pavement before the drainage. These attributes are obtained from a previous physical-based-modeling of hydrological processes of permeable pavements (Cortier et al. 2017). Two agents are used in the model, Drops and Waters. They are used respectively to simulate the water flow at the surface and inside the permeable pavement structure. They have one attribute, their size. Four parameters are used for the permeable pavement generation: the ratio of permeable pavement surfaces other impervious surface (in %), their surface area (in m2), the land use localization (car park, road, sidewalk, etc.) and the elevation localization (top, bottom). Finally the user selects the rainfall profile and return period and the evapotranspiration value.
Process Overview and Scheduling
After a setup process, the model runs the simulation following the same processes at each step (one step corresponds to one minute) and for each cell, Fig. 2. These processes are repeated until the end of the simulation corresponding to the end of the runoff discharge.
3 Results and Discussion
3.1 Model Sensitivity Analysis
A sensitivity analysis was conducted on each model parameters to both asses the model robustness and identify the key attributes. First, the number of agents Waters and Drops created at each step was tested from 1 to 9 (per cell). Results show, first that using only 1 agent per cell does not allow for accurate runoff and storage simulation, second that using from 2 to 9 agents only slightly increases the model accuracy. These parameters were set to 4 as a compromise between accuracy and computation time. Second, the hydrological parameters were tested in a range of realistic value for each. A multi-linear regression analysis was run on the results. This analysis shows that soil permeability is the most influent parameter (normalized coefficient of −0.44 and +0.87 on runoff and infiltration respectively). Interception parameters only have a significant impact on interception, and permeable pavement storage parameter only impacts the repartition between storage and drain outflow.
3.2 Main Results on Permeable Pavements Benefits
In order to explore the influence of permeable pavement ratio, size and localization on their benefits 72 simulations were conducted combining the four permeable pavement generation parameters. Results, obtained for a 100 years return period event, reveal that the ratio of permeable surface is the most influential parameter (Table 1). Results also highlighted that; (a) permeable pavement area does not have a significant impact, (b) permeable pavement are slightly more efficient when located at the bottom than at the top of the catchment and (c) they are more efficient when located on car parks than on roads (for this specific catchment).
4 Conclusions
This study presents an agent-based-model built for the quantification of permeable pavement impacts on urban runoff. Sensitivity analysis revealed that the soil permeability is the most influent parameter on the runoff. An exploration of permeable pavement benefits according to their ratio, size and localization was conducted. Results reveal that, with the right localization, ratio of 2.5% and 10% of permeable surface can respectively reduce the runoff peak by 8.3% and 24.4% and increase the infiltration by 8.8% and 30.3% (for a 100 years return period event). Further model exploration will allow for better understanding permeable pavement impacts. Such study could help promote a widespread and right use of this LID technique.
References
Braud, I., Breil, P., Thollet, F., Lagouy, M., Branger, F., Jacqueminet, C., Kermadi, S., Michel, K.: Evidence of the impact of urbanization on the hydrological regime of a medium-sized periurban catchment in France. J. Hydrol. Hydrol. Peri-urban Catchments Process. Modell. 485, 5–23 (2013)
Brunetti, G., Šimůnek, J., Piro, P.: A comprehensive numerical analysis of the hydraulic behavior of a permeable pavement. J. Hydrol. 540, 1146–1161 (2016)
Chen, J., Hill, A.A., Urbano, L.D.: A GIS-based model for urban flood inundation. J. Hydrol. 373, 184–192 (2009)
Cortier, O., Boutouil, M., Maquaire, O.: Modeling of the hydrological behaviour of pervious pavements, a physically based approach with FlexPDE. Presented at the 14th ICUD, Prague, pp. 2562–2567 (2017)
Fletcher, T.D., Andrieu, H., Hamel, P.:. Understanding, management and modelling of urban hydrology and its consequences for receiving waters: a state of the art. Adv. Water Resour. 51, 261–279 (2013)
Haase, D.: Effects of urbanisation on the water balance – a long-term trajectory. Environ. Impact Assess. Rev. 29, 211–219 (2009)
Illgen, M., Harting, K., Schmitt, T.G., Welker, A.: Runoff and Infiltration characteristics of permeable pavements – review of an intensive monitoring program. Presented at the Novatech, p. 8 (2007)
Jacobson, C.R.: Identification and quantification of the hydrological impacts of imperviousness in urban catchments: a review. J. Environ. Manage. 92, 1438–1448 (2011)
Miller, J.D., Kim, H., Kjeldsen, T.R., Packman, J., Grebby, S., Dearden, R.: Assessing the impact of urbanization on storm runoff in a peri-urban catchment using historical change in impervious cover. J. Hydrol. 515, 59–70 (2014)
Nguyen, D.H., Sebaibi, N., Boutouil, M., Leleyter, L., Baraud, F.: A modified method for the design of pervious concrete mix. Constr. Build. Mater. 73, 271–282 (2014)
Salvadore, E., Bronders, J., Batelaan, O.: Hydrological modelling of urbanized catchments: a review and future directions. J. Hydrol. 529, 62–81 (2015)
Webber, J.L., Gibson, M.J., Chen, A.S., Savic, D., Fu, G., Butler, D.: Rapid assessment of surface-water flood-management options in urban catchments. Urban Water J. 15, 210–217 (2018)
Yin, J., Yu, D., Yin, Z., Liu, M., He, Q.: Evaluating the impact and risk of pluvial flash flood on intra-urban road network: a case study in the city center of Shanghai. China. J. Hydrol. 537, 138–145 (2016)
Acknowledgement
Authors wish to thanks the Normandy Regional Council for the funding provided
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2019 Springer Nature Switzerland AG
About this paper
Cite this paper
Cortier, O., Boutouil, M., Maquaire, O. (2019). Quantifying Benefits of Permeable Pavement on Surface Runoff, An Agent-Based-Model with NetLogo. In: Mannina, G. (eds) New Trends in Urban Drainage Modelling. UDM 2018. Green Energy and Technology. Springer, Cham. https://doi.org/10.1007/978-3-319-99867-1_126
Download citation
DOI: https://doi.org/10.1007/978-3-319-99867-1_126
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-319-99866-4
Online ISBN: 978-3-319-99867-1
eBook Packages: EnergyEnergy (R0)