Abstract
The use of copper-coated aluminum electrodes in the electrical discharge machining of 38X2H2MA steel is assessed. Such electrodes prove effective. The use of coated electrodes improves the economics of electrical discharge machining by permitting the use of cheaper materials in the electrode core.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Ablyaz, T.R., Khanov, A.M., and Khurmatullin, O.G., Sovremennye podkhody i tekhnologii elektroerozionnoi obarabotki materialov (Modern Approaches and Technologies of EDM Processing of the Materials), Perm: Perm. Nats. Issled. Politekh. Univ., 2012.
Serebrenitskii, P.P., Sovremennye elektroerozionnye tekhnologii i oborudovanie: uchebnoe posobie (Modern Electroerosion Technologies and Equipment: Manual), St. Petersburg: Balt. Gos. Tekh. Univ., 2007.
Ablyaz, T.R. and Zhurin, A.V., Influence of wire-cut electrical discharge machining on surface quality, Russ. Eng. Res., 2016, vol. 36, no. 2, pp. 156–158.
Ablyaz, T.R., Simonov, M.Y., Schlykov E.S., et al., Surface analysis of bimetal after EDM machining using electrodes with different physical and mechanical properties, Res. J. Pharm., Biol. Chem. Sci., 2016, vol. 7, no. 5, pp. 974–981. http://www.rjpbcs.com/ pdf/2016_7(5)/[119].pdf.
Lyubimov, V.V. and Salomatnikov, M.S., Electrodes with double-layer copper coatings on polymer prototyping mandrels for electrophysical-chemical formation, Uprochnyayushchie Tekhnol. Pokrytiya, 2015, no. 3, pp. 30–36.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © T.R. Ablyaz, E.S. Shlykov, S.S. Kremlev, 2017, published in STIN, 2017, No. 5, pp. 20–21.
About this article
Cite this article
Ablyaz, T.R., Shlykov, E.S. & Kremlev, S.S. Copper-coated electrodes for electrical discharge machining of 38X2H2MA steel. Russ. Engin. Res. 37, 910–911 (2017). https://doi.org/10.3103/S1068798X17100033
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X17100033