Abstract
Known criteria for the optimization of cutting processes are appraised. A new criterion for determining the optimal conditions in metal cutting is proposed.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Mukherjee, I. and Ray, P.K., A review of optimization techniques in metal cutting processes, Comput. Ind. Eng., 2006, vol. 50, nos. 1–2, pp. 15–34.
Koval’, M.I. and Korobko, A.V., Improvement of efficiency of multipurpose machines by cutting automated control, Stanki Instrum., 1987, no. 2, pp. 13–17.
Grigor’ev, S.N., Sinopal’nikov, V.A., and Tereshin, M.V., Operational diagnostics and control of cutting by maximum temperature, Kontrol’. Diagn., 2012, no. 1, pp. 18–21.
Velikanova, K.M., Raschety ekonomicheskoi effektivnosti novoi tekhniki: spravochnik (Calculation of Economic Efficiency of a New Technique: Handbook), Leningrad: Mashinostroenie, 1990.
Kapustina, O.M. and Novozhilov, I.V., Metody rascheta, proektirovaniya i optimizatsii upravlyaemykh system, mashin i mekhanizmov (The Methods of Calculation, Design, and Optimization of the Control Systems, Machines, and Mechanisms), Moscow: Mosk. Energet. Inst., 1983, pp. 36–42.
Zhmurin, V.V. and Sal’nikov, V.S., Evaluation criteria for efficiency of cutting regimes, Izv. Tulsk. Gos. Univ., Tekh. Nauki, 2011, no. 3, pp. 309–315.
Silin, S.S., Metod podobiya pri rezanii materialov (The Resemblance Method in Cutting of Materials), Moscow: Mashinostroenie, 1979.
Hoang, V.C., Practical problems of the study of cutting temperature during turning, Izv. Tulsk. Gos. Univ., Tekh. Nauki, 2015, no. 6, part 1, pp. 386–395.
Sal’nikov, V.S. and Hoang, V.C., Mathematical models of thermal processes in the cutting zone, Izv. Tulsk. Gos. Univ., Tekh. Nauki, 2012, no. 5, pp. 56–62.
Makarov, A.D., Optimizatsiya protsessov rezaniya (Optimization of Cutting Processes), Moscow: Mashinostroenie, 1976.
Hasnul Hadi, Liyana Tajul, Zailani, Z.A., Hamzas, M.F.M.A., and Hussin, M.S., “The Parametric Effect and Optimization on JIS S45C Steel Turning,” Int. J. Eng. Sci. Technol., 2011, vol. 3, no. 5.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © V.S. Sal’nikov, V.C. Hoang, 2015, published in STIN, 2015, No. 11, pp. 33–36.
About this article
Cite this article
Sal’nikov, V.S., Hoang, V.C. Optimization of cutting processes. Russ. Engin. Res. 36, 508–510 (2016). https://doi.org/10.3103/S1068798X16060186
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X16060186