Abstract
The results of experimental studies of the effect of the shape of an organic water–coal fuel (OCWF) particle on its ignition delay time and the time of its complete burnout in a hot air flow are reported. Three most common shapes of real particles, such as spherical, ellipsoidal, and irregular-polyhedron-like, are considered. It is shown that the shortest ignition delay time and the time of complete burnout correspond to polyhedron- shaped OCWF particles. Conditions are identified under which this factor significantly influences the ignition characteristics. The experiments were carried out at initial particle sizes (averaged maximum values) of 0.5–5 mm and temperatures and velocities of the oxidant flow of 600–900 K and 0.5–5 m/s, respectively. The main components of the studied fuels were coal processing wastes and waste motor, turbine, and transformer oils.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Presidential Decree number 899 of July 7, 2011, On approval of the priority directions of science, technology, and engineering development in the Russian Federation and the list of critical technologies of the Russian Federation; http://www.kremlin.ru/acts/bank/33514
P. A. Shchinnikov, E. A. Yevtushenko, Yu. V. Ovchinnikov, et al., Therm. Eng., No. 7, 30 (2001).
E. G. Gorlov, Khim. Tverd. Topl., No. 6, 50 (2004).
G. S. Khodakov, E. G. Gorlov, and G. S. Golovin, Khim. Tverd. Topl., No. 6, 15 (2005).
G. S. Khodakov, E. G. Gorlov, and G. S. Golovin, Khim. Tverd. Topl., No. 4, 22 (2006).
A. I. Borzov and M. P. Baranova, Khim. Tverd. Topl., No. 4, 40 (2006).
G. S. Khodakov, Therm. Eng. 54, 36 (2010).
E. G. Gorlov, A. I. Seregin, and G. S. Khodakov, Solid Fuel Chem. 41, 364 (2007).
K. N. Trubetskoi, V. E. Zaidenvarg, A. C. Kondrat’ev, V. I. Murko, G. A. Kassikhin, and I. Kh. Nekhoroshii, Therm. Eng. 45, 413 (2010).
E. G. Gorlov, A. I. Seregin, and G. S. Khodakov, Solid Fuel Chem. 42, 208 (2008).
I. I. Lishtvan, P. L. Falyushin, E. A. Smolyachkova, and S. I. Kovrik, Solid Fuel Chem. 43, 1 (2009).
A. I. Tsepenok, Yu. V. Ovchinnikov, Yu. V. Strizhko, and S. V. Lutsenko, Energetik, No. 7, 45 (2011).
A. Kijo-Kleczkowska, Fuel 90, 865 (2011).
N. I. Red’kina, G. S. Khodakov, and E. G. Gorlov, Solid Fuel Chem. 47, 306 (2013).
A. P. Burdukov, V. I. Popov, M. Y. Chernetskiy, A. A. Dekterev, and K. Hanjalic, Appl. Therm. Eng. 74, 174 (2015).
S. Beloševic, I. Tomanovic, V. Beljanski, D. Tucakovic, and T. Živanovic, Appl. Therm. Eng. 74, 102 (2015).
D. O. Glushkov, G. V. Kuznetsov, and P. A. Strizhak, Solid Fuel Chem. 49, 73 (2015).
D. O. Glushkov, G. V. Kuznetsov, and P. A. Strizhak, Russ._J. Phys. Chem. B 9, 242 (2015).
Yu. F. Patrakov, N. I. Fedorova, and A. I. Efremov, Vestn. Kuzbas. Tekh. Univ., No. 2, 81 (2006).
Yu. V. Ovchinnikov, A. I. Tsepenok, A. V. Shikhotinov, and E. V. Tatarnikova, Dokl. Akad. Nauk Vyssh. Shkoly RF, No. 1, 117 (2011).
V. A. Arkhipov, A. M. Sidor, and V. G. Surkov, Tekh. Teplofiz. Prom-sti Teploenerget., No. 5, 39 (2013).
L.-P. Hsiang and G. M. Faeth, Int. J. Multiphase Flow 19, 721 (1993).
E. H. Trinh, R. G. Holt, and D. B. Thiessen, Phys. Fluids 8, 43 (1996).
A. K. Flock, D. R. Guildenbecher, J. Chen, P. E. Sojka, and H.-J. Bauer, Int. J. Multiphase Flow 47, 37 (2012).
W. Gajewski, A. Kijo-Kleczkowska, and J. Leszczynski, Fuel 88, 221 (2009).
J. Zhu, G. Zhang, G. Liu, Q. Qu, and Y. Li, Fuel Proc. Technol. 118, 187 (2014).
L. Bartonová, Fuel Proc. Technol. 134, 136 (2015).
R. S. Volkov, G. V. Kuznetsov, and P. A. Strizhak, Int. J. Heat Mass Transfer 79, 838 (2014).
D. O. Glushkov, D. P. Shabardin, P. A. Strizhak, and K. Yu. Vershinina, Fuel Proc. Technol. 143, 60 (2016).
D. O. Glushkov, P. A. Strizhak, and K. Yu. Vershinina, Appl. Therm. Eng. 96, 534 (2016).
R. S. Volkov, G. V. Kuznetsov, and P. A. Strizhak, Int._J. Therm. Sci. 88, 193 (2015).
B. V. Novozhilov, Non-Stationary Combustion of Solid Rocket Fuels (Nauka, Moscow, 1973) [in Russian].
L. K. Gusachenko, V. E. Zarko, V. Ya. Zar’yanov, and V. P. Bobryshev, Simulation of Solid Fuel Combustion Processes (Nauka, Novosibirsk, 1985) [in Russian].
K. Hanjalic, R. van de Krol, and A. Lekic, Sustainable Energy Technologies: Options and Prospects (Springer, Dordrecht, London, 2008).
J. Janiszewski, Metrol. Meas. Syst. 19, 797 (2012).
J. Janiszewski, Int. J. Sol. Struct. 49, 1001 (2012).
C. del Pino, L. Parras, M. Felli, and R. Fernandez-Feria, Phys. Fluids 23, 013602 (2011).
F. Corvaro, M. Paroncini, and M. Sotte, Int. J. Therm. Sci. 50, 1629 (2011).
J. V. Simo Tala, S. Russeil, D. Bougeard, and J.-L. Harion, Exp. Therm. Fluid Sci. 50, 45 (2013).
T. Hadad and R. Gurka, Exp. Therm. Fluid Sci. 45, 203 (2013).
N. Takagaki and S. Komori, Int. J. Multiphase Flow 60, 30 (2014).
L. G. Loitsanskii, Mechanics of Gases and Liquids (Nauka, Moscow, 1970; Pergamon, Oxford, 1975).
D. G. Pazhi and V. S. Galustov, Principles of Liquid Spraying (Khimiya, Moscow, 1984) [in Russian].
V. I. Terekhov and M. A. Pakhomov, Heat Mass Transfer and Hydrodynamics in Gas–Droplet Flows (Novosib. Gos. Tekhnol. Univ., Novosibirsk, 2009) [in Russian]
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © D.O. Glushkov, A.V. Zakharevich, P.A. Strizhak, S.V. Syrodoy, 2016, published in Khimicheskaya Fizika, 2016, Vol. 35, No. 11, pp. 14–25.
Rights and permissions
About this article
Cite this article
Glushkov, D.O., Zakharevich, A.V., Strizhak, P.A. et al. Effect of the shape of an organic water–coal fuel particle on the condition and characteristics of its ignition in a hot air flow. Russ. J. Phys. Chem. B 10, 935–945 (2016). https://doi.org/10.1134/S199079311606004X
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S199079311606004X