Abstract
A novel Young’s modulus measurement scheme based on fiber Bragg gratings (FBG) is proposed and demonstrated experimentally. In our method, a universal formula relating the Bragg wavelength shift to Young’s modulus is derived and metal wires are loaded strain by using the static stretching method. The Young’s modulus of copper wires, aluminum wires, nickel wires, and tungsten wires are separately measured. Experimental results show that the FBG sensor exhibits high measurement accuracy, and the measurement errors relative to the nominal value is less than 1.0%. The feasibility of the FBG test method is confirmed by comparing it with the traditional charge coupled device (CCD) imaging method. The proposed method could find the potential application in the material selection, especially in the field that the size of metal wires is very small and the strain gauges cannot be qualified.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
K. O. Hill and G. Meltz, “Fiber Bragg grating technology fundamentals and overview,” Journal of Lightwave Technology, 1997, 15(8): 1263–1276.
M. M. Elgaud, M. S. D. Zan, A. Abushagur, and A. A. A. Bakar, “Improvement of signal to noise ratio of time domain mutliplexing fiber Bragg grating sensor network with Golay complementary codes,” Optical Fiber Technology, 2017, 36: 447–453.
G. Guo, D. A. Hackney, M. Pankow, and K. Peters, “Interrogation of a spectral profile division multiplexed FBG sensor network using a modified particle swarm optimization method,” Measurement Science and Technology, 2017, 28: 055204-1‒055204-9.
K. Tian, Y. L. Liu, and Q. M. Wang, “Temperature-independent fiber Bragg grating strain sensor using bimetal cantilever,” Optical Fiber Technology, 2005, 11(4): 370–377.
L. Jin, W. G. Zhang, H. Zhang, B. Liu, C. J. Zhao, Q. C. Tu, et al., “An embedded FBG sensor for simultaneous measurement of stress and temperature,” IEEE Photonics Technology Letter, 2006, 18(1): 54–156.
Y. K. Chamorovskiy, O. V. Butov, A. O. Kolosovskiy, S. M. Popov, V. V. Voloshin, I. L. Vorob′ev, et al., “Metal-coated Bragg grating reflecting fiber,” Optical Fiber Technology, 2017, 34: 30–35.
G. Allwood, G. Wild, A. Lubansky, and S. Hinckley, “A highly sensitive fiber Bragg grating diaphragm pressure transduce,” Optical Fiber Technology, 2015, 25: 25–32.
W. Liang, Y. Y. Huang, Y. Xu, R. Lee, and A. Yariv, “Highly sensitive fiber Bragg grating refractive index sensors,” Applied Physics Letters, 2005, 86(15): 151122-1‒151122-3.
J. H. R. Oliveira, S. Aristilde, G. Chesini, M. A. R. Franco, R. N. Nogueira, and C. M. B. Cordeiro, “Bragg gratings in surface-core fibers: refractive index and directional curvature sensing,” Optical Fiber Technology, 2017, 34: 86–90.
Y. S. Zhang, W. G. Zhang, Y. X. Zhang, S. Wang, L. Yu, and T. Y. Yan, “Simultaneous measurement of curvature and temperature based on LP 11 mode Bragg grating in seven-core fiber,” Measurement Science and Technology, 2017, 28(5): 055101-1‒055101-6.
G. Allwood, G. Wild, A. Lubansky, and S. Hinckley, “A highly sensitive fiber Bragg grating diaphragm pressure transducer,” Optical Fiber Technology, 2015, 25: 25–32.
X. Y. Deng, G. H. Chen, Q. X. Peng, Z. R. Li, J. H. Meng, and J. Liu, “Research on the fiber Bragg grating sensor for the shock stress measurement,” Review of Scientific Instrument, 2011, 82(10): 103109-1‒103109-4.
M. M. J Treacy, T. M. J. Ebbesen, and J. M. Gibson, “Exceptionally high Young′s modulus observed for individual carbon nanotubes,” Nature, 1996, 381: 678–681.
A. Krishnan, E. Dujardin, T. W. Ebbesen, P. N. Yianilos, and M. M. J. Treacy, “Young′s modulus of single-walled nanotubes,” Physical Review B, 1998, 58(20): 14013–14019.
I. Maruyama, H. Sasano, Y. Nishioka, and G. Igarashi, “Strength and Young′s modulus change in concrete due to long-term drying and heating up to 90,” Cement and Concrete Research, 2014, 66: 48–63.
W. W. Quan, J. Kang, L. Yang, and J. H. Hu, “Young′s modulus measurement of metal beams based on fiber Bragg grating,” Laser & Optoelectronics Progress, 2016, 53: 040604-1‒040604-6.
Y. Zou, X. P. Dong, G. B. Lin, and R. Adhami, “Wide range FBG displacement sensor based on twin-core fiber filter,” Journal of Lightwave Technology, 2012, 30(3): 337–343.
D. J. Hill and G. A. Cranch, “Gain in hydrostatic pressure sensitivity of coated fiber grating,” Electronics letters, 1999, 35(15): 1268–1269.
A. Kersey, M. A. Davis, H. J. Patrick, M. Leblanc, K. Koo, C. G. Askins, et al., “Fiber grating sensors,” Journal of Lightwave Technology, 1997, 15(8): 1442–1463.
W. Z. Huang, W. T. Zhang, and F. Li, “Swept optical SSB-SC modulation technique for high-resolution large-dynamic-range static strain measurement using FBG-FP sensors,” Optics Letters, 2015, 40(7): 1406–1409.
M. A. Davis and A. Kersey, “All-fiber Bragg grating strain-sensor demodulation technique using a wavelength division coupler,” Electronics Letters, 1994, 30(1): 75–77.
Acknowledgement
This work was supported by the National Natural Science Foundation of China under Grant No. 61565002, and Guangxi Province Key Research and Development Program under Grant Nos. AB17129027 and AB18221033.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
Open Access This article is distributed under the terms of the Creative Commons Attribution 4.0 International License (https://doi.org/creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made.
About this article
Cite this article
Chen, C., Liang, L., Quan, W. et al. Young’s Modulus Measurement of Metal Wires Using FBG Sensor. Photonic Sens 9, 277–283 (2019). https://doi.org/10.1007/s13320-019-0531-3
Received:
Revised:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s13320-019-0531-3