Abstract
The author studied and demonstrated the various modeling aspects of long period fiber grating (LPFG) such as the core effective index, cladding effective index, coupling coefficient, coupled mode theory, and transmission spectrum of the LPFG using three-layer fiber geometry. Actually, there are two different techniques used for theoretical modeling of the long period fiber grating. The first technique was used by Vengsarkar et al who described the phenomenon of long-period fiber gratings, and the second technique was reported by Erdogan who revealed the inaccuracies and shortcomings of the original method, thereby providing an accurate and updated alternative. The main difference between these two different approaches lies in their fiber geometry. Venserkar et al used two-layer fiber geometry which is simple but employs weakly guided approximation, whereas Erdogan used three-layer fiber geometry which is complex but also the most accurate technique for theoretical study of the LPFG. The author further discussed about the behavior of the transmission spectrum by altering different grating parameters such as the grating length, ultraviolet (UV) induced-index change, and grating period to achieve the desired flexibility. The author simulated the various results with the help of MATLAB.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
S. W. James and R. P. Tatam, “Optical fiber long period grating sensors: characteristics and applications,” Measurement Science and Technology, 2003, 14(5): 49–61.
M. Vengsarkar, P. J. Lemaire, J. B. Judkins, V. Bhatia, T. Erdogan, and J. E. Sipe, “Long-period fiber gratings as band-rejection filters,” Journal of Lightwave Technology, 1996, 14(1): 58–65.
V. Bhatia, “Applications of long-period gratings to single and multi-parameter sensing,” Optics Express, 1999, 4(11): 457–466.
A. Singh, S. B. Rana, M. Singh, and A. Sharma, “Study and investigation of long period grating as refractive index sensor,” Optik — International Journal for Light and Electron Optics, 2014, 125(7): 1860–1863.
Q. Huang, Y. Yu, Z. Ou, X. Chen, J. Wang, P. Yan, et al., “Refractive index and strain sensitivities of a long period fiber grating,” Photonic Sensors, 2014, 4(1): 92–96.
K. R. Cooper, J. Elster, M. Jones, and R. G. Kelly, “Optical fiber-based corrosion sensor systems for health monitoring of aging aircraft,” in IEEE Systems Readiness Technology Conference, Valley Forge, pp. 847–856, 2001.
J. A. Besley, T. Wang, and L. Reekie, “Fiber cladding mode sensitivity characterization for long-period gratings,” Journal of Lightwave Technology, 2003, 21(3): 848–853.
A. Singh, D. Engles, A. Sharma, and M. Singh, “Temperature sensitivity of long period fiber grating in SMF-28 fiber,” Optik — International Journal for Light and Electron Optics, 2014, 125(1): 457–460.
T. Erdogan, “Cladding-mode resonances in short- and long-period fiber grating filters,” Journal of the Optical Society of America A, 1997, 14(8): 1760–1773.
W. V. Etten and J. V. D Plaats, Fundamentals of optical fiber communications. New York: Prentice Hall, 1991.
J. A. Buck, Fundamentals of optical fibers. New York: John Wiley and Son Inc., 1995.
K. W. Chung and S. Yin, “Analysis of a widely tunable long-period grating by use of an ultra thin cladding layer and higher-order cladding mode coupling,” Optics Letters, 2004, 29(8): 812–814.
T. Erdogan, “Fiber grating spectra,” Journal of Lightwave Technology, 1997, 15(8): 1277–1294.
Y. Yang and Z. Gu, “Comparing and analysis of calculation methods of long period fiber gratings transmission spectra,” Optik — International Journal for Light and Electron Optics, 2013, 124(15): 2234–2240.
A. van Brakel, “Sensing characteristics of an optical fibre long-period grating Michelson refractometer,” DIng. Thesis, Rand Afrikaans University, 2004.
Author information
Authors and Affiliations
Corresponding author
Additional information
This article is published with open access at Springerlink.com
Rights and permissions
Open Access This article is distributed under the terms of the Creative Commons Attribution 4.0 International License (https://creativecommons.org/licenses/by/4.0), which permits use, duplication, adaptation, distribution, and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made.
About this article
Cite this article
Singh, A. Study of modeling aspects of long period fiber grating using three-layer fiber geometry. Photonic Sens 5, 32–42 (2015). https://doi.org/10.1007/s13320-014-0188-x
Received:
Revised:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s13320-014-0188-x