Abstract
In this present study the effect of adding silicon coupling grafted ferric oxide and E-glass fibre in thermal stability, wear and fatigue behaviour of epoxy resin hybrid composite was investigated. The principal aim of this research was explicating the importance of silicon coupling grafted E-glass fibre and ferric oxide particle in thermal stability, wear and fatigue properties of epoxy hybrid composite. Ferric oxide particles of 800, 200 and < 100 nm and E-glass fibre of 600 GSM was used as second phase additions in epoxy resin with surface grafted condition. The surface grafting was done using 3-Aminopropyletrimethoxylane via aqueous solution method with acetic acid as pH adjuster. The improvement of 80% was observed in initial thermal stability of surface grafted E-glass fibre epoxy composite on comparing with un-modified glass-epoxy composite. Similar improvements were noted in rapid and final decomposition stages also. The lower specific wear rate of 0.002 was observed for surface grafted E-glass and ferric oxide added composite designation EGFI11. The worn surface frcatograph explicated flat and smooth wear track surface for surface grafted composite designations. A highest fatigue life cycle of 18,724 is observed for surface modified composite designation EGFI21. These thermally stable and high wear resistance and fatigue strengthened composites could be used in automobile, aircrafts and domestic applications.
Article PDF
Similar content being viewed by others
Explore related subjects
Discover the latest articles, news and stories from top researchers in related subjects.Avoid common mistakes on your manuscript.
References
Arun Prakash VR, Rajadurai A (2016) Thermo-mechanical characterization of siliconized E-glass fibre/hematite particles reinforced epoxy resin hybrid composite. Appl Surf Sci 384(16):99–106
Senthil Kumar R, Senthil Kumar A, Asha Melba V (2014) Processing of 45 degree stitched mat GLARE laminate and analyzing tensile and flexural properties. J Appl Chem 7:54–62
Domun N, Hadavinia H, Zhang T, Sainsbury T, Liaghat GH, Vahid S (2015) Improving the fracture toughness and the strength of epoxy using nanomaterials – a review of the current status. Nanoscale 7:10294–10329
Arunprakash VR, Jaisingh J (2018) Mechanical strength behaviour of silane treated E-glass fibre/Al6061 & SS-304 wire mesh-reinforced epoxy resin hybrid composite. Silicon 10:2279–2286
Arun PVR, Rajadurai A, Jayaseelan V, Dass SJ, Murali M (2019) Role of silanized magnetic Fe2O3 particle in heat dissipation and microwave shielding behavior of E-glass fibre-reinforced epoxy resin composite. Mater Res Express 6:076113
Ramesh C, Manickam C, Maridurai T, Arun Prakash VR (2017) Dry sliding wear characteristics of heat treated and surface modified hematite particles-epoxy particulate composite. Romanian Journal of Materials 47(3):401–405
Dinesh T, Kadirvel A, Arunprakash (2018) Effect of silane modified E-glass fibre/Iron (III) oxide reinforcements on UP blended epoxy resin hybrid composite. Silicon 10(3):1–12
Manikandan V, Jappes JTW, Kumar SMS, Amuthakkannan P (2012) Investigation of the effect of surface modifications on the mechanical properties of basalt fibre reinforced polymer composites. Compos Part B 43:812–818
Sokolova OA, Kuhn M, Palkowski H (2012) Deep drawing properties of light weight steel/polymer/steel sandwich composites. Arch Civ Mech Eng 12:105–112
Bandyopadhyay A (2011) Molecular modeling of cross-linked epoxy polymers: the effect of crosslink density on thermomechanical properties. Polymer 52(11):2445–2452
Vincent A, Ramesh G, Kumar SM (2018) Microwave shielding behaviour of surface treated MWCNT-epoxy composites in I & J band-A note. Colloid Interfac Sci Commun 24:89–92
Guo Z, Lei K, Li Y, Hahn T (2008) Fabrication and characterization of iron oxide nanoparticls reinforced vinyl-ester resin nanocomposites. Compos Sci Technol 68:1513–1520
Julyes Jaisingh S, Selvam V, Suresh Chandra Kumar M, Thigarajan K (2013) Thermomechanical behaviour of unsaturated polyester toughened epoxy silane treated iron (III) oxide nano composite. Indian J Eng Mater Sci 1:241–245
Arun Prakash VR, Viswanathan R (2018) Microwave shielding behavior of silanized Cu and Cu-Fe3O4 compound particles reinforced epoxy resin composite in E, F,I and J band frequencies. Polym Bull 75:4207. https://doi.org/10.1007/s00289-017-2262-1
Ramesh G, Jayabalakrishnan D, Rameshkumar C (2018) Mechanical and thermal characterization of heat/surface treated egg shell particle diffused natural rubber green composite. J Optoelectron Biomed Mater 10(1):21–28
Saravanan R, Suresh Babu A, Maridurai T (2016) Influence of surface-modified MWCNT on mechanical and thermal properties of carbon fibre/epoxy resin hybrid nano composite. Digest J Nanomater Biostruct 11(4):1303–1309
Parivendhan I, S R (2017) Mechanical, wear and thermal behaviour of hemp fibre/egg shell particle reinforced epoxy resin bio composite. Trans Can Soc Mech Eng. https://doi.org/10.1139/tcsme-2017-0079
Arunprakash VR, Viswanathan R (2019) Fabrication and characterization of Echinoidea spike particles and Kenaf natural fibre-reinforced Azadirachta-Indica blended epoxy multi-hybrid bio composite. Composites: A 118:317–326
Chakradhar KVP, Venkata Subbaiah K, Ashok Kumar M, Ramachandra RG (2011) Epoxy/polyester blend nano composites: effect of nano clay on mechanical, thermal and morphological properties. Malays Polym J 6:109–118
Arun Prakash VR, Rajadurai A (2016) Mechanical, thermal and dielectric characterization of Iron oxide particles dispersed glass fiber epoxy resin hybrid composite. Digest J Nanomater Biostruct 11(2):373–380
Peerapan D, Pearson Raymond A, Paisan K (2017) Thermo-mechanical behavioursand moistureabsorption of silica nanoparticle reinforcement in epoxy resin. Inter J Adhesion Adhes 78:74–82
Suresha B, Chandramohan G, Prakash JN, Balusamy V, Sankaranarayanasamy K (2006) The role of particles on friction and slide wear characteristics in glass-epoxy composite systems. J Min Mater Character Eng 5(1):87–101
Shalwan A, Yousif B (2014) Influence of date palm fibre and graphite particle on mechanical and wear characteristics of epoxy composites. Mater Des 59:264–273
Singla M, Chawla V (2010) Mechanical properties of epoxy resin – Fly ash composite. Journal of composite 9(3):199
Suresha B, Chandramohan C, Jawali ND, Siddaramaiah (2007) Effect of short glass fiber content on three-body wear behaviour of polyurethane composites. J Compos Mater 41:2701–2713
Poomali, Siddaramaiah BS, Lee J-H (2008) Mechanical and three body abrasive wear behavior of PMMA/TPU blends. Material Sci Eng A:1–5
Kishore P, Sampathkumaran S, Seetharamu PT, Janardhana M (2005) A study on the effect of the type and content of filler in epoxy-glass composite system on the friction and wear characteristics. Wear 259(1–6):634–641
Suresha B, Chandramohan G, Sampathkumaran P, Sethuramu S (2007) Investigation of the friction and wear behavior of glass-epoxy composite with and without graphite filler. J Reinf Plast Comp 26:81
Maragoni L, Carraro PA, Peron M, Quaresimin M (2016) Fatigue behavior of glass/epoxy laminates in the presence of voids. Int J Fatigue 95:18–28
Manjunatha CM, Taylor AC, Kinloch AJ (2010) The tensile fatigue behavior of a silica nanoparticle-modified glass fibre-reinforced epoxy composite. Compos Sci Technol 70:193–199
Navaneetha Krishnan G, Selvam V, Saravanan C (2015) Effect of CNTs-Fe2O3 hybrids on mechanical studies of glass fibre/epoxy nanocomposites. J Chem Pharm Sci 6:196–201
Jumahat A, Kasolang S, Bahari MT (2015) Wear properties of nanosilica filled epoxy polymers and FRP composites. J Tribol 6:34–36
Karsli NG, Yesil S, Aytac A (2014) Effect of hybrid carbon nanotube/short glass fibre-reinforcement on the properties of polypropylene composites. Compos Part B 63:154–160
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher’s Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
V R, A.P., V, J., T, M. et al. Effect of Silicon Coupling Grafted Ferric Oxide and E-Glass Fibre in Thermal Stability, Wear and Tensile Fatigue Behaviour of Epoxy Hybrid Composite. Silicon 12, 2533–2544 (2020). https://doi.org/10.1007/s12633-019-00347-7
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12633-019-00347-7