Abstract
The corrosion behavior of 5wt%Cr steel tempered at different temperatures was investigated by immersion testing and electrochemical testing in a CO2 aqueous environment. When the tempering temperature exceeded 500°C, the corrosion rate increased. The corrosion layers consisted of Cr-rich compounds, which affected the corrosion behaviors of the steels immersed in the corrosive solution. The results of electrochemical experiments demonstrated that 5wt%Cr steels with different microstructures exhibited pre-passivation characteristics that decreased their corrosion rate. Analysis by electron back-scattered diffraction showed that the frequency of high-angle grain boundaries (HAGBs) and the corrosion rate were well-correlated in specimens tempered at different temperatures. The corrosion rate increased with increasing HAGB frequency.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
J.B. Sun, W. Liu, and M.X. Lu, Investigation progress of effect of alloying elements and microstructure on CO2 corrosion behavior of steel, J. Chin. Soc. Corros. Prot., 28(2008), No. 4, p. 246.
W. Li, L.N. Xu, L.J. Qiao, and J.X. Li, Effect of free Cr content on corrosion behavior of 3Cr steels in a CO2 environment, Appl. Surf. Sci., 425(2017), p. 32.
W. Liu, S.L. Lu, P Zhang, J.J. Dou, and Q.H. Zhao, Effect of silty sand with different sizes on corrosion behavior of 3Cr steel in CO2 aqueous environment, Appl. Surf. Sci., 379(2016), p. 163.
X.Q. Lin, W. Liu, F. Wu, C.C. Xu, J.J. Dou, and M.X. Lu, Effect of O2 on corrosion of 3Cr steel in high temperature and high pressure CO2–O2 environment, Appl. Surf. Sci., 329(2015), p. 104.
C. Sun, Y. Wang, J.B. Sun, X.Q. Lin, L.D. Li, H.F. Liu, and X.K. Cheng, Effect of impurity on the corrosion behavior of X65 steel in water-saturated supercritical CO2 system, J. Supercrit. Fluids, 116(2016), p. 70.
G.A. Zhang, M.X. Lu, and Y.S Wu, Morphology and microstructure of CO2 corrosion scales, Chin. J. Mater. Res., 19(2005), No. 5, p. 537.
Z.G. Liu, X.H. Gao, L.X. Du, J.P. Li, C. Yu, R.D.K. Misra, and Y.X. Wang, Comparison of corrosion behaviors of low-alloy pipeline steel exposed to H2S/CO2-saturated brine and vapour-saturated H2S/CO2 environments, Electrochim. Acta, 232(2017), p. 528.
H. Yu, D.D. Zhang, R.T. Xiao, P. Zhou, J.J. Dong, and X.B. Du, Effect of tempering temperature on low angle grain boundaries in Q960 steel, J. Univ. Sci. Technol. Beijing, 33(2011), No. 8, p. 952.
R. Hunag and Y. Han, The effect of SMAT-induced grain refinement and dislocations on the corrosion behavior of Ti-25Nb-3Mo-3Zr-2Sn alloy, Mater. Sci. Eng. C, 33(2013), No. 4, p. 2353.
D. Song, A.B. Ma, J.H. Jiang, P.H. Lin, D.H. Yang, and J.F. Fan, Corrosion behaviour of bulk ultra-fine grained AZ91D magnesium alloy fabricated by equal-channel angular pressing, Corros. Sci., 53(2011), No. 1, p. 362.
C. Örnek and D.L. Engelberg, SKPFM measured Volta potential correlated with strain localisation in microstructure to understand corrosion susceptibility of cold-rolled grade 2205 duplex stainless steel, Corros. Sci., 99(2015), p. 164.
J.M. Liang, D. Tang, H.B. Wu, P.C. Zhang, W. Liu, H.Y. Mao, and X.T. Liu, Corrosion behaviors of Cr low-alloy steel in bottom plate environment of cargo oil tanks, J. South China Univ. Technol. Nat. Sci., 41(2013), No. 10, p. 72.
J.M. Liang, D. Tang, H.B. Wu, and L.D. Wang, Environment corrosion behavior of cargo oil tank deck made of Cr-contained low-alloy steel, J. Southeast Univ. Nat. Sci., 43(2013), No. 1, p. 152.
H.E. Townsend, Effects of alloying elements on the corrosion of steel in industrial atmospheres, Corrosion, 57(2001), No. 6, p. 497.
T. Nishimura, H. Katayama, K. Noda, and T. Kodama, Effect of Co and Ni on the corrosion behavior of low alloy steels in wet/dry environments, Corros. Sci., 42(2000), No. 9, p. 1611.
L.N. Xu, B. Wang, J.Y. Zhu, W. Li, and Z.Y. Zheng, Effect of Cr content on the corrosion performance of low-Cr alloy steel in a CO2 environment, Appl. Surf. Sci., 379(2016), p. 39.
Y.H. Qian, C.H. Ma, D. Niu, J.J. Xu, and M.S. Li, Influence of alloyed chromium on the atmospheric corrosion resistance of weathering steels, Corros. Sci., 74(2013), No. 4, p. 424.
C. Ghosh, V.V. Basabe, J.J. Jonas, Y.M. Kim, I.H. Jung, and S. Yue, The dynamic transformation of deformed austenite at temperatures above the Ae3, Acta Mater., 61(2013), No. 7, p. 2348.
M. Yamashita, H. Miyuki, Y. Matsuda, H. Nagano, and T. Misawa, The long-term growth of the protective rust layer formed on weathering steel by atmospheric corrosion during a quarter of a century, Corros. Sci., 36(1994), No. 2, p. 283.
B. Wang, L.N. Xu, J.Y. Zhu, H. Xiao, and M.X. Lu, Observation and analysis of pseudo-passive film on 6.5%Cr steel in CO2 corrosion environment, Corros. Sci., 111(2016), p. 711.
S.Q. Guo, L.N. Xu, L. Zhang, W. Chang, and M.X Lu, Corrosion of alloy steels containing 2% chromium in CO2 environments, Corros. Sci., 63(2012), p. 246.
Z.G. Liu, X.H. Gao, L.X. Du, J.P. Li, Y. Kang, and B. Wu Corrosion behavior of low-alloy steel with martensite/ferrite microstructure at vapor-saturated CO2 and CO2-saturated brine conditions, Appl. Surf. Sci., 351(2015), p. 610.
L.N. Xu, B. Wang, and M.X. Lu, Corrosion behavior of 6.5%Cr steel in high temperature and high pressure CO2 environment, Acta Metall. Sinica, 52(2016), No. 6, p. 672.
Acknowledgements
This work was financially supported by the National Key R & D Program of China (No. 2017YFB0304900) and the National Science and Technology Major Project of China (No. 2014E-3604).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Wu, Hb., Wu, T., Niu, G. et al. Effect of the frequency of high-angle grain boundaries on the corrosion performance of 5wt%Cr steel in a CO2 aqueous environment. Int J Miner Metall Mater 25, 315–324 (2018). https://doi.org/10.1007/s12613-018-1575-x
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12613-018-1575-x