Abstract
The effects of the fineness and shape of fly ash on the porosity and air permeability of cement pastes were investigated. Pulverized coal combustion (PCC) fly ash and fluidized bed coal combustion (FBC) fly ash classified into three different finenesses were used. River sand with particle size distribution similar to that of fly ash was also used for comparison. Portland cement was replaced with fly ash and ground sand at the dosages of 0, 20wt%, and 40wt%. A water-to-binder ratio (w/b) of 0.35 was used throughout the experiment. The results show that the porosity and air permeability of the pastes are influenced by the shape, fineness, and replacement level of fly ash. The porosity and air permeability of FBC fly ash pastes are higher than those of PCC fly ash pastes. This is due to the higher irregular shape and surface of FBC fly ash compared to the spherical shape and relatively smooth surface of PCC fly ash. The porosity increases with the increase in fly ash replacement level and decreases with the increase in its fineness. The permeability of PCC fly ash pastes decreases with the increase in replacement level and fineness, while for FBC fly ash, the permeability increases with the increase in replacement level. Decreases in porosity and permeability are due to a combined effect of the packing of fine particles and the reaction of fly ash.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
N.S. Martys, NISTIR 5592 Survey of Concrete Transport Properties and Their Measurement, US Department of Commerce, 1995.
E.J. Garboczi, Computation materials science of cement-based materials, Mater. Struct., 26(1993), p.191.
E.J. Garboczi, Permeability, diffusivity and microstructural parameters: A critical review, Cem. Concr. Res., 20(1990), p.591.
J. Payá, J. Monzó, E. Peris-Mora, M.V. Borrachero, R. Tercero, and C. Pinillos, Early-strength development of Portland cement mortars containing air classified fly ash, Cem. Concr. Res., 25(1995), No.6, p.449.
K. Erdogdu and P. Turker, Effect of fly ash particle size on compressive strength of Portland cement fly ash mortars, Cem. Concr. Res., 28(1998), No.9, p.1217.
P. Chindaprasirt, S. Homwuttiwong, and V. Sirivivatnanon, Influence of fly ash fineness on strength, drying shrinkage and sulfate resistance of blended cement mortar, Cem. Concr. Res., 34(2004), p.1087.
P. Chindaprasirt, C. Jaturapitakkul, and T. Sinsiri, Effect of fly ash fineness on microstructure of blended cement paste, Constr. Build. Mater., 21(2007), p.1534.
K. Kiattikomol, C. Jaturapitakkul, and J. Tangpagasit, Effect of insoluble residue on properties of Portland cement, Cem. Concr. Res., 30(2000), p.1209.
M.I. Khan, Permeability of high performance concrete, J. Mater. Civ. Eng., 15(2003), No.1, p.84.
S.G. Patil and B. Bhattacharjee, Size and volume relationship of pore for construction materials, J. Mater. Civ. Eng., 20(2008), No.6, p.410.
J.J. Koller, The determination of the permeability of concrete to oxygen by the cembureau method — a recommendation, Mater. Struct., 22(1989), p.225.
S. Tsivilis, J. Tsantilas, G. Kakali, E. Chaniotakis, and A. Sakellariou, The permeability of Portland limestone cement concrete, Cem. Concr. Res., 33(2003), p.1465.
S. Tsivilis, E. Chaniotakis, G. Batis, C. Meletiou, V. Kasselouri, G. Kakali, A. Sakellariou, G. Paulakis, and C. Pseimidas, The effect of clinker and limestone quality on the gas permeability, water absorption and pore structure of limestone cement and concrete, Cem. Concr. Compos., 21(1999), No.2, p.139.
A. Abbas, M. Carcasses, and J.P. Ollivier, Gas permeability of concrete in relation to its degree of saturation, Mater. Struct., 32(1999), p.3.
M. Carcasses, A. Abbas, T.P. Ollivier, and J. Verdier, An optimised precondition procedure for gas permeability measurement, Mater. Struct., 35(2002), p.22.
R.K. Dhir, P.C. Hewlett, and Y.N. Chan, Near surface characteristics of concrete: intrinsic permeability, Mag. Concr. Res., 41(1989), p.87.
P. Chindaprasirt, C. Jaturapitakkul, and T. Sinsiri, Effect of fly ash fineness on compressive strength and pore size of blended cement paste, Cem. Concr. Compos., 27(2005), No.4, p.425.
R.F.M. Bakker, Permeability of blended cement concretes, [in] V.M. Malhotra ed., Proceeding of the First International Conference on Fly Ash, Silica Fume, Slag, and other Mineral By-products in Concrete, Montebello, 1983, p.589.
Author information
Authors and Affiliations
Corresponding author
Additional information
This work was financially supported by the Thailand Research Fund (TRF) under TRF Senior Research Scholar Contact (No.RTA5080020) and the Ministry of Education of Thailand through Commission on Higher Education under the Ministry Staff Development Project.
Rights and permissions
About this article
Cite this article
Sinsiri, T., Chindaprasirt, P. & Jaturapitakkul, C. Influence of fly ash fineness and shape on the porosity and permeability of blended cement pastes. Int J Miner Metall Mater 17, 683–690 (2010). https://doi.org/10.1007/s12613-010-0374-9
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12613-010-0374-9