Abstract
Environmentally conscious hard turning and technology has placed more importance on the machining process. In this research, the possibility of environmentally conscious hard turning of cemented carbides was studied. The effects of cutting methods of dry and wet (vegetable oil mist, and mineral oil) and work material on cutting resistance and wear characteristics of cutting tools were experimentally investigated. The turning and micro-cutting process in SEM was carried out by using four kinds of tungsten carbides with the PCD cutting tools. Specifically, an emphasis was put on the effect of WC and Co additives in four kinds of cemented carbides on machinability and tool wear characteristics. The tool wear width and the cutting resistances were measured, and the worn flank was observed.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Technical Research Institute, Cutting Data Files 86-097 (edited by Japan Society for the Promotion of Machine Industry), Tokyo, Japan, (1988).
Technical Research Institute, Cutting Data Files 92-0298 (edited by Japan Society for the Promotion of Machine Industry), Tokyo, Japan, (1995).
Technical Research Institute, Cutting Data Files 95-0321 (edited by Japan Society for the Promotion of Machine Industry), Tokyo, Japan, (1997).
Technical Research Institute, Cutting Data Files 95-0323 (edited by Japan Society for the Promotion of Machine Industry), Tokyo, Japan, (1997).
Technical Research Institute, Cutting Data Files 95-0325, (edited by Japan Society for the Promotion of Machine Industry), Tokyo, Japan, (1997).
S. J. Heo, T. Miyamoto, S. Hanasaki and J. Fujiwara, Study on Cutting of Cemented Carbides-Wear Mechanism of PCD Tool and Cutting Force in Turning, J. of the Japan Society for Precision Engineering, 69(12) (2003) 1724–1728.
S. J. Heo, Micro-Cutting of Tungsten Carbides with SEM Direct Observation Method, KSME International Journal, 18(5) (2004) 770–779.
S. J. Heo, Study on Cutting Characteristics of WC-Co with Micro-Cutting in SEM, J. of the Korean Society of Precision Engineering, 20(10) (2001) 74–81.
S. J. Heo, Micro-Cutting of Cemented Carbides with SEM, J. of the Korean Society of Precision Engineering, 20(9) (2003) 55–62
S. J. Heo, Machining Characteristics of Cemented Carbides in Micro Cutting within SEM, International Journal of Precision Engineering and Manufacturing, 5(3) (2004) 35–42.
S. J. Heo, T. Miyamoto, J. Fujiwara and S. Hanasaki., Study on Micro-Cutting of Cemented Carbides with SEM Direct Observation Method, Proc. of the Sixth International Conference on Progress of Cutting Technology, Xian, China. (2002) 218–223.
S. J. Heo, T. Miyamoto, S. Hanasaki and J. Fujiwara, Micro-Cutting of Wear and Impact Resistant Cemented Carbides in SEM, J. of the Japan Society for Precision Engineering, 71,(7) (2005) 926–930.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Heo, S.J. Environmentally conscious hard turning of cemented carbide materials on the basis of micro-cutting in SEM: stressing four kinds of cemented carbides with PCD tools. J Mech Sci Technol 22, 1383–1390 (2008). https://doi.org/10.1007/s12206-008-0411-z
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12206-008-0411-z