Abstract
The influences of boundary layer thickness on the aerodynamic characteristics of a high-speed train head car were investigated with an 1:8 scaled model in an 8 m × 6 m wind tunnel at CARDC. Boundary layer thicknesses at different positions on the ballast surface were measured under the wind velocity range of 40 to 70 m/s and the Reynolds number range of 1.25 × 106 to 2.19 × 106. It was found that the effect of Reynolds number on the head car was small. The boundary layer thickness increased significantly along the ballast and decreased gradually with the increase of the wind velocity. A linearly fitted model was employed to calculate the boundary layer thickness under different wind velocities. The changing patterns of the drag and lift force coefficients with the boundary layer thickness were complex. The drag and lift coefficients increased by 5.57% and 21.97% respectively, when the boundary layer thickness was larger than 118 mm. The effects of boundary layer on lift coefficients were more prominent than on the drag coefficients.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Bell JR, Burton D, Thompson MC (2020) The boundary-layer characteristics and unsteady flow topology of full-scale operational inter-modal freight trains. Journal of Wind Engineering & Industrial Aerodynamics 201:104164, DOI: https://doi.org/10.1016/j.jweia.2020.104164
Bell JR Burton D, Thompson MC, Herbst AH, Sheridan J (2014) Wind tunnel analysis of the slipstream and wake of a high-speed train. Journal of Wind Engineering & Industrial Aerodynamics 134:122–138, DOI: https://doi.org/10.1016/j.jweia.2014.09.004
CEN European Standard (2008) EN 14067-6:2008, Railway applications aerodynamics Part 6: Requirements and test procedures for crosswind assessment. CEN-CENELEC Management Centre, Brussels, Belgium
CEN European Standard (2009) EN 14067-6:2009, Railway applications-aerodynamics Part 6: Requirements and test procedures for crosswind assessment. CEN-CENELEC Management Centre, Brussels, Belgium
CEN European Standard (2010) EN 14067-6:2010, Railway applications-aerodynamics Part 6: Rquirements and test procedures for cross wind assessment. CEN-CENELEC Management Centre, Brussels, Belgium
Charuvisit S, Kimura K, Fujino Y (2004) Effects of wind barrier on a vehicle passing in the wake of a bridge tower in cross wind and its response. Journal of Wind Engineering & Industrial Aerodynamics 92(7–8):609–639, DOI: https://doi.org/10.1016/j.jweia.2004.03.006
Dorigatti F, Sterling M, Baker CJ, Quinn AD (2015) Crosswind effects on the stability of a model passenger train—A comparison of static and moving experiments. Journal of Wind Engineering & Industrial Aerodynamics 138:36–51, DOI: https://doi.org/10.1016/j.jweia.2014.11.009
He X, Zou Y, Wang H, Han Y, Shi K (2014) Aerodynamic characteristics of a trailing rail vehicles on viaduct based on still wind tunnel experiments. Journal of Wind Engineering & Industrial Aerodynamics 135:22–33, DOI: https://doi.org/10.1016/j.jweia.2014.10.004
Huang ZX, Chen L, Zhang WZ (2013) Study on simulation manner of wind tunnel test of high-speed train model. Journal of Railway Science and Engineering 10(3):87–93, DOI: https://doi.org/10.19713/j.cnki.43-1423/u.2013.03.018 (in Chinese)
Jia LR, Zhou D, Niu JQ (2017) Numerical calculation of boundary layers and wake characteristics of high-speed trains with different lengths. PLoS ONE 12(12):e0189798, DOI: https://doi.org/10.1371/journal.pone.0189798
Li Y, Hu P, Cai CS, Zhang M, Qiang S (2013) Wind tunnel study of a sudden change of train wind loads due to the wind shielding effects of bridge towers and passing trains. Journal of Engineering Mechanics 139(9):1249–1259, DOI: https://doi.org/10.1061/(asce)em.1943-7889.0000559
Liu X, Han Y, Cai CS, Levitan M, Nikitopoulos D (2016) Wind tunnel tests for mean wind loads on road vehicles. Journal of Wind Engineering & Industrial Aerodynamics 150:15–21, DOI: https://doi.org/10.1016/j.jweia.2015.12.004
Muld T, Efraimsson G, Hennigson DS (2013) Wake characteristics of high-speed trains with different lengths. Journal of Rail Rapid Transit 228(4):333–342, DOI: https://doi.org/10.1177/0954409712473922
Niu JQ, Liang XF, Zhou D (2016) Experimental study on the effect of Reynolds number on aerodynamic performance of high-speed train with and without yaw angle. Journal of Wind Engineering & Industrial Aerodynamics 157:36–46, DOI: https://doi.org/10.1016/j.jweia.2016.08.007
Pereira I, André JM CS (2013) A semi-analytical model of the 3D boundary layer over the streamlined nose of a train. Journal of Wind Engineering & Industrial Aerodynamics 119:78–88, DOI: https://doi.org/10.1016/j.jweia.2013.05.014
Schober M, Weise M, Orellano A, Deeg P, Wetzel W (2010) Wind tunnel investigation of an ICE 3 end car on three standard ground scenarios. Journal of Wind Engineering & Industrial Aerodynamics 98:345–352, DOI: https://doi.org/10.1016/j.jweia.2009.12.004
Sterling M, Quinn AD, Hargreaves DM, Cheli F, Sabbioni E, Tomasini G, Delaunay D, Baker CJ, Morvan H (2010) A comparison of different methods to evaluate the wind induced forces on a high sided lorry. Journal of Wind Engineering & Industrial Aerodynamics 98:10–20, DOI: https://doi.org/10.1016/j.jweia.2009.08.008
Sun ZX, Guo DL, Yao Y (2013) Numerical study on ground effect of highspeed trains. Journal of Chinese Computation Physics 30(1):61–69 (in Chinese)
Xiang HY, Li YL, Chen SR, Li CJ (2017) A wind tunnel test method on aerodynamic characteristics of movingvehicles under crosswinds. Journal of Wind Engineering & Industrial Aerodynamics 163: 15–23, DOI: https://doi.org/10.1016/j.jweia.2017.01.013
Xiao JP, Huang ZX, Chen L (2013) Review of aerodynamic investigation for high speed train. Journal of Mechanics in Engineering 35(2):1–12 (in Chinese)
Yang QS, Song JH, Yang GW (2016) A moving model rig with a scale ratio of 1/8 for high speed train aerodynamics. Journal of Wind Engineering & Industrial Aerodynamics 152:50–58, DOI: https://doi.org/10.1016/j.jweia.2016.03.002
Zhang L, Yang MZ, Liang XF (2018) Experimental study on the effect of wind angles on pressure distribution of train streamlined zone and train aerodynamic forces. Journal of Wind Engineering & Industrial Aerodynamics 174:330–348, DOI: https://doi.org/10.1016/j.jweia.2018.01.024
Acknowledgments
This work was financially supported by the National Natural Science Foundation of China (Grant No. 51778381 and Grant No. 52078437). We thank LetPub (https://www.letpub.com) for its linguistic assistance.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Huang, Z., Zeng, W., Gai, J. et al. Experimental Study on the Effect of Boundary Layer on High-Speed Train Aerodynamic Forces Measurement. KSCE J Civ Eng 25, 1746–1754 (2021). https://doi.org/10.1007/s12205-021-0670-0
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12205-021-0670-0