Abstract
In the present study, preparation of acrylonitrile-butadiene-styrene (ABS) membrane was investigated via phase inversion method. ABS membrane is sensitive to preparation conditions. Therefore, the effect of solvent/nonsolvent type and concentration of additive and ABS was evaluated on the morphology, tensile strength and car wash wastewater treatment. Polyethylene glycol was used as an additive. The results show that nonsolvent type significantly affects the morphology and consequently the flux and rejections of the pollution indices. Increasing concentration of additive and ABS in the casting solution leads to formation of denser and thinner membranes that have lower flux and higher rejections of the pollution indices.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
M. Yousefi, F. Gholamian, D. Ghanbari and M. Salavati-Niasari, Polyhedron, 30, 1055 (2011).
A.G. Boricha and Z.V. P. Murthy, J. Membr. Sci., 339, 239 (2009).
Z.V. P. Murthy, A.A. Mungray and J. Singh, WCECS, 2, 808 (2012).
S. M. Hosseini, S. S. Madaeni and A. R. Khodabakhshi, J. Membr. Sci., 351, 178 (2010).
H. Sanaeepur, A. Ebadi Amooghin, A. Moghadassi, A. Kargari, S. Moradi and D. Ghanbari, Polym. Adv. Technol., 23, 1207 (2012).
H. Sanaeepur, A. Ebadi Amooghin, A. Moghadassi and A. Kargari, Sep. Purif. Technol., 80, 499 (2011).
S. S. Madaeni, N. Arast, F. Rahimpour and Y. Arast, Desalination, 280, 305 (2011).
M. Anson, J. Marchese, E. Garis, N. Ochoa and C. Pagliero, J. Membr. Sci., 243, 19 (2004).
J. Marchese, M. Anson, N. A. Ochoa, P. Pradanos, L. Palacio and A. Hernandez, Chem. Eng. Sci., 61, 5448 (2006).
E. Saljoughi, M. Amirilargani and T. Mohammadi, J. Appl. Polym. Sci., 111, 2537 (2009).
T.D. Lickly, D.A. Markham and M. L. Rainey, Food Chem. Toxicol., 29, 25 (1991).
J. G. Bokria and S. Schlick, Polymer, 43, 3239 (2002).
E. Saljoughi and S. M. Mousavi, Sep. Purif. Technol., 90, 22 (2012).
V. Ratta, Crystallization, morphology, thermal stability and adhesive properties of novel high performance semicrystalline polyimides, PhD Thesis, Virginia Polytechnic Institute and State University, Blacksburg, US (1999).
M. A. M. Beerlage, Polyimide ultrafiltration membranes for nonaqueous systems, PhD Thesis, University of Twente, Enschede, Netherlands (1994).
T. Young and L. Chen, Desalination, 103, 233 (1995).
H. R. Mortaheb, M. Mafi, B. Mokhtarani, K. Khosravi and F. Mashkini, Ecl. Quím., 35(1), 85 (2010).
T. Mohammadi and E. Saljoughi, Desalination, 243, 1 (2009).
E. Saljoughi, M. Amirilargani and T. Mohammadi, Desalination, 262, 72 (2010).
E. Saljoughi, M. Sadrzadeh and T. Mohammadi, J. Membr. Sci., 326, 627 (2009).
N. Leblanc, D. Le Cerf, C. Chappey, D. Langevin, M. Metayer and G. Muller, Sep. Purif. Technol., 22–23, 277 (2001).
M. Amirilargani, E. Saljoughi, T. Mohammadi and M. R. Moghbeli, Polym. Eng. Sci., 50, 885 (2010).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Kamelian, F.S., Mousavi, S.M., Ahmadpour, A. et al. Preparation of acrylonitrile-butadiene-styrene membrane: Investigation of solvent/nonsolvent type and additive concentration. Korean J. Chem. Eng. 31, 1399–1404 (2014). https://doi.org/10.1007/s11814-014-0068-5
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11814-014-0068-5