Abstract
The performance of a commercial circulating fluidized bed boiler in the Yeosu thermal power plant, which has been operating since October 2011 by KOSEP, has been evaluated by using the IEA-CFBC model. To validate the calculation procedure of the model, the calculated results were compared with the operation values such as the temperatures, pressures, emissions of SO2 and NO, particles size distribution and unburned carbon fraction of the CFB boiler at a certain actual condition. The calculated results were comparable to measured values from the CFB boiler, so these could conform to acceptable formats with a good accuracy. The effect of the primary to secondary air ratio on the performance of the CFB boiler was also determined. As the primary air ratio increased, the solid fraction and temperature in the furnace freeboard increased. As a result, the solid circulation rate and the heat absorption in the furnace increased with increasing the PA ratio. In the case of the amount of heat absorption, the wall tube of the furnace absorbed much more generation heat in the furnace than the wing wall tube. The SO2 emission decreased due to increase of the limestone hold up in the furnace, and the combustion efficiency somewhat increased with increasing the PA ratio. Therefore, from these results, we could expect to control the boiler performance such as the furnace temperature, steam temperatures of superheater or reheater, gaseous emissions and combustion efficiency through the changing the PA ratio of the CFB boiler.
Article PDF
Similar content being viewed by others
Explore related subjects
Discover the latest articles, news and stories from top researchers in related subjects.Avoid common mistakes on your manuscript.
References
B. Leckner, Therm. Sci., 11, 5 (2007).
J. Koornneef, M. Junginger and A. Faaij, Progress in Energy Combus. Sci., 33, 19 (2007).
B. Leckner, Developments in fluidized bed conversion during 2005–2010, IEA-FBC Report, Chalmers University of Technology Press, Sweden (2011).
M. Zhan, H. Wu, Y. Sun and Q. Lu, 21st International Conference on Fluidized Bed Combustion, Naples, Italy, 107 (2012).
J. Utt and R. Giglio, Power-Gen India & Central Asia Conference, New Delhi, India, 3 (2012).
W. Nowak, R. Walkowiak, T. Ozimowski, J. Jablonski and J. Wyszynski, 9 th International Conference on Circulating Fluidized Beds, Hamburg, Germany, 1057 (2008).
T. Jantti and R. Parkkonen, Power Gen Asia, Bangkok, Thailand (2009).
J. M. Lee, D. W. Kim and J. S. Kim, Korean J. Chem. Eng., 28(8), 1791 (2011).
D. W. Kim, J. M. Lee, K. I. Park, T. H. Lee and J. S. Kim, Proceedings of 2012 KIChE Spring Meeting, 311 (2012).
J. W. Pritchett, T.R. Blake and S. K. Garg, AIChE Symp. Ser., 74, 134 (1978).
A. Boemer, H. Qi and U. Renz, Proceedings of the 29th IEA-FBC Meeting, Paris, France (1994).
D. Pallares, M. Palonen, V. Yla-Outinen and F. Johnsson, Proceedings of the 21th International Conference on FBC, Naples, Italy, 867 (2012).
S. Mori, K. Narukawa, I. Yamada, T. Takebayashi, H. Tanii, Y. Tomoyasu and T. Mii, Proceedings of the 11 th International Conference on FBC, Montreal, Canada, 1261 (1991).
L. Zhang, T. D. Li, Q.Y. Zhen and C. D. Lu, Proceedings of the 11 th International Conference on FBC, Montreal, Canada, 1289 (1991).
J. P. Hannes, Mathematical modeling of circulating fluidized bed combustion, PhD Thesis, Delft University of Technology, The Netherlands (1996).
J. M. Lee and J. S. Kim, Korean J. Chem. Eng., 16(5), 640 (1999).
J. M. Lee, J. S. Kim and J. J. Kim, Energy, 28, 575 (2003).
Y. C. Wen and L. H. Chen, AIChE J., 6, 117 (1982).
K. E. Wirth, Chem. Eng. Technol., 11, 11 (1988).
J. P. Hannes, C. M. Bleek and U. Renz, Proceedings of the 13 th International Conference on Fluidized Bed Combustion, Orlando, Florida, 287 (1995).
J. M. Lee and J. S. Kim, Korean Chem. Eng. Res., 38(1), 53 (2000).
S. Ergun, Chem. Eng. Prog., 48, 89 (1952).
D. Merrick and J. Highley, AIChE Symp. Ser., 70(137), 366 (1974).
D. Bellgardt, F. Hembach, M. Schoessler and J. Werther, Proceedings of the 9th International Conference on FBC, Boston, 713 (1987).
I. W. Smith, Fuel, 57, 409 (1978).
E. H. P. Wolff, Regenerative sulfur capture in fluidized bed combustion of coal, PhD Thesis, Delft University of Technology, The Netherlands (1991).
D. Kunii and O. Levenspiel, Fluidization Engineering 2nd Ed., Butterworth-Heinemann (1991).
M. Seiter, Radial solid concentration and axial solid concentration in near wall areas circulating fluidized bed, PhD Thesis, Erlangen, Germany (1990).
C. M. H. Brereton and J. R. Grace, Chem. Eng. Sci., 48(14), 2565 (1993).
A. Glatzer, Solid distribution and heat transfer by radiation in circulating fluidized bed, PhD Thesis, Vienna University, Austria (1994).
J. M. Lee, D. W. Kim and J. S. Kim, Operation analysis and guide for the Yeosu CFB boiler, Technical Report (TM K02P2011), KEPRI, Korea (2011).
E. J. Gottung and S. L. Darling, Proceedings of the 10 th International Conference on FBC, New York, 617 (1989).
P. Basu, Combustion and gasification in fluidized beds, CRC Press, Taylor & Francis Group, New York (2006).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Lee, JM., Kim, DW., Kim, JS. et al. Evaluation of the performance of a commercial circulating fluidized bed boiler by using IEA-CFBC model: Effect of primary to secondary air ratio. Korean J. Chem. Eng. 30, 1058–1066 (2013). https://doi.org/10.1007/s11814-012-0206-x
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11814-012-0206-x