Abstract
Fixed bed reactors are among the most important equipment in chemical industries as these are used in chemical processes. An accurate insight into the fluid flow in these reactors is necessary for their modeling. The pressure drop and heat transfer coefficient have been studied for the fixed bed reactor with tube to particle diameter ratio (N) of 4.6 and comprising 130 spherical particles using computational fluid dynamics (CFD). The simulations were carried out in a wide range of Reynolds number: 3.85≤Re≤611.79. The RNG k-ɛ turbulence model was used in the turbulent regime. The CFD results were compared with empirical correlations in the literature. The predicted pressure drop values in laminar flow were overestimated compared with the Ergun’s [27] correlation and underestimated in the turbulent regime due to the wall friction and the flow channeling in the bed, respectively. It was observed that the CFD results of the pressure drop are in good agreement with the correlations of Zhavoronkov et al. [28] and Reichelt [29] because the wall effects have been taken into account in these correlations. Values of the predicted dimensionless heat transfer coefficient showed better agreement with the Dixon and Labua’s [32] correlation. This is explained by the fact that this correlation is a function of the particle size and shape in the bed.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
H. A. Jakobsen, Chemical reactor modeling multiphase reactive flows, Springer-Verlag, Berlin Heidelberg, 954 (2008).
V.V. Ranade, Computational flow modeling for chemical reactor engineering, Academic Press, New York, 403 (2002).
J. B. Joshi and V.V. Ranade, Ind. Eng. Chem. Res., 42, 1115 (2003).
P. C. Carman, Trans. Inst. Chem. Eng., 15, 150 (1937).
J.M. Coulson, Trans. Inst. Chem. Eng., 27, 237 (1949).
B. Eisfeld and K. Schnitzlein, Chem. Eng. Sci., 56, 4321 (2001).
D. Mehta and M. C. Hawley, Ind. Eng. Chem., 8, 280 (1969).
E. A. Foumeny, F. Benyahia, J. A. A. Castro, H. A. Moallemi and S. Roshani, Int. J. Heat Mass Transfer, 36, 536 (1993).
M. Nijemeisland and A. G. Dixon, AIChE J., 50, 906 (2004).
M. T. Dalman, J. H. Merkin and C. McGreavy, Computers and Fluids, 14, 267 (1986).
B. Lloyd and R. Boehm, Numer. Heat Trans. A, 26, 237 (1994).
O. R. Derkx and A.G. Dixon, Numer. Heat Trans. A, 29, 777 (1996).
H. P. A. Calis, J. Nijenhuis, B. C. Paikert, F. M. Dautzenberg and C. M. van den Bleek, Chem. Eng. Sci., 56, 1713 (2001).
M. Nijemeisland and A.G. Dixon, Chem. Eng. J., 82, 231 (2001).
A. Guardo, M. Coussirat, M.A. Larrayoz, F. Recasens and E. Egusquiza, Ind. Eng. Chem. Res., 43, 7049 (2004).
A. Guardo, M. Coussirat, M.A. Larrayoz, F. Recasens and E. Egusquiza, Chem. Eng. Sci., 60, 1733 (2005).
P. R. Gunjal, V.V. Ranade and R.V. Chaudhari, AIChE J., 51, 365 (2005).
A.G. Dixon, M. Nijemeisland and E.H. Stitt, Ind. Eng. Chem. Res., 44, 6342 (2005).
D. Wen and Y. Ding, Chem. Eng. Sci., 61, 3532 (2006).
R. K. Reddy and J. B. Joshi, Chem. Eng. Res. Des., 86, 444 (2008).
T. Atmakidis and E. Y. Kenig, Chem. Eng. J., 155, 404 (2009).
R. K. Reddy and J. B. Joshi, Particuology, 8, 37 (2010).
T. Suekane, Y. Yokouchi and Sh. Hirai, AIChE J., 49, 10 (2003).
A. Dybbs and R.V. Edwards, fundamentals of transport phenomena in porous media, J. Bear and M. Corapcioglu, Eds., Martinus Nijhoff, Dordrecht, 201 (1984).
A.G. Dixon, M. Nijemeisland and E. H. Stitt, Adv. Chem. Eng., 31, 307 (2006).
ANSYS FLUENT 12.0, User’s Guide, 12.6.2 Modeling Turbulence, ANSYS, Inc. (2009).
S. Ergun, Chem. Eng. Prog., 48, 89 (1952).
N. M. Zhavoronkov, M. E. Aerov and N. N. Umnik, J. Phys. Chem., 23, 342 (1949).
W. Reichelt, Chem. Ing. Tech., 44, 1068 (1972).
S. Yagi and N. Wakao, AIChE J., 5, 79 (1959).
C. H. Li and B. A. Finlayson, Chem. Eng. Sci., 32, 1055 (1977).
A.G. Dixon and L. A. LaBua, Int. J. Heat Mass Transfer, 28, 879 (1985).
Y. Demirel, R. N. Sharma and H. H. Al-Ali, Int. J. Heat Mass Transfer, 43, 327 (2000).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Miroliaei, A.R., Shahraki, F. & Atashi, H. Computational fluid dynamics simulations of pressure drop and heat transfer in fixed bed reactor with spherical particles. Korean J. Chem. Eng. 28, 1474–1479 (2011). https://doi.org/10.1007/s11814-010-0507-x
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11814-010-0507-x