Abstract
Development of vulnerable high-angle grain boundaries (and cracks) from low-angle boundaries during thermal cycling by means of continuous recrystallization was examined in fine-pitch ball grid array (BGA) packages with Sn-3.0Ag-0.5Cu (wt.%) (SAC305) lead-free solder joints. Electron backscatter diffraction (EBSD) and differential-aperture x-ray microscopy (DAXM or 3D-XRD) were used for surface and subsurface characterization. A large number of subgrain boundaries were observed in the parent orientation using both techniques. However, unlike studies of anisotropic deformation in noncubic metals at much lower homologous temperatures, no streaked diffraction peaks were observed in DAXM Laue patterns within each 1 μm3 voxel after thermal cycling, suggesting that geometrically necessary dislocations (GNDs) are effectively absorbed by the preexisting subgrain boundaries. Storage at room temperature (0.6T m) prior to DAXM measurement may also facilitate recovery processes to reduce local GND contents. Heterogeneous residual elastic strains were found near the interface between a precipitated Cu6Sn5 particle and the Sn grain, as well as near particular subgrain boundaries in the parent orientation. Grain boundary migration associated with recrystallization resulted in regions without internal strains, subgrain boundaries, or orientation gradients. Development of new grain orientations by continuous recrystallization and subsequent primary recrystallization and grain growth occurred in the regions where the cracks developed. Orientation gradients and subgrain structure were observed within newly formed recrystallized grains that could be correlated with slip systems having high Schmid factors.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
J.W. Elmer, E.D. Specht, and M. Kumar, J. Electron. Mater. 39, 273 (2010).
G.J. Jackson, H. Lu, R. Durairaj, N. Hoo, C. Bailey, N.N. Ekere, and J. Wright, J. Electron. Mater. 33, 1524 (2004).
B. Zhou, T.R. Bieler, G. Wu, S. Zaefferer, T.-K. Lee, and K.-C. Liu, J. Electron. Mater. 41, 262 (2012).
A. Pietrikova, J. Bednarcik, and J. Durisin, J. Alloy. Compd. 509, 1550 (2011).
K.-J. Wang, Y.-C. Lin, J.-G. Duh, C.-Y. Cheng, and J.-J. Lee, J. Mater. Res. 25, 972 (2010).
J.O. Suh, K.N. Tu, and N. Tamura, JOM 58, 63 (2006).
D. Mu, J. Read, Y. Yang, and K. Nogita, J. Mater. Res. 26, 2660 (2011).
T.R. Bieler, B. Zhou, L. Blair, A. Zamiri, P. Darbandi, F. Pourboghrat, T.-K. Lee, and K.-C. Liu, J. Electron. Mater. 41, 283 (2012).
W.J. Choi, T.Y. Lee, K.N. Tu, N. Tamura, R.S. Celestre, A.A. MacDowell, Y.Y. Bong, and L. Nguyen, Acta Mater. 51, 6253 (2003).
M. Sobiech, M. Wohlschlögel, U. Welzel, E.J. Mittemeijer, W. Hügel, A. Seekamp, W. Liu, and G.E. Ice, Appl. Phys. Lett. 94, 221901 (2009).
K.N. Tu, C. Chen, and A.T. Wu, J. Mater. Sci.-Mater. Electron. 18, 269 (2007).
T.-K. Lee, W. Xie, B. Zhou, T.R. Bieler, and K.-C. Liu, J. Electron. Mater. 40, 1967 (2011).
G.E. Ice, J.D. Budai, and J.W.L. Pang, Science 334, 1234 (2011).
G.E. Ice and R.I. Barabash, Dislocations in Solids, ed. F.R.N. Nabarro and J.P. Hirth (Amsterdam: Elsevier, 2007), p. 500.
B.C. Larson, W. Yang, G.E. Ice, J.D. Budai, and J.Z. Tischler, Nature 415, 887 (2002).
W. Liu, G.E. Ice, B.C. Larson, W. Yang, and J.Z. Tischler, Ultramicroscopy 103, 199 (2005).
W. Liu, G.E. Ice, B.C. Larson, W. Yang, J.Z. Tischler, and J.D. Budai, Metall. Mater. Trans. A 35A, 1963 (2004).
L. Yin, L. Wentlent, L. Yang, B. Arfaei, A. Oasaimeh, and P. Borgesen, J. Electron. Mater. 41, 241 (2012).
D.W. Henderson, J.J. Woods, T.A. Gosselin, J. Bartelo, D.E. King, T.M. Korhonen, M.A. Korhonen, L.P. Lehman, E.J. Cotts, S.K. Kang, P. Lauro, D.-Y. Shih, C. Goldsmith, and K.J. Puttlitz, J. Mater. Res. 19, 1608 (2004).
H. Chen, J. Han, and M. Li, J. Electron. Mater. 40, 2470 (2011).
G.E. Ice, B.C. Larson, J.Z. Tischler, W. Liu, and W. Yang, Mater. Sci. Eng. A-Struct. 399, 43 (2005).
R.D. Doherty, D.A. Hughes, F.J. Humphreys, J.J. Jonas, D.J. Jensen, M.E. Kassner, W.E. King, T.R. McNelley, H.J. McQueen, and A.D. Rollett, Mater. Sci. Eng. A-Struct. 238, 219 (1997).
J. Li, H. Xu, T.T. Mattila, J.K. Kivilahti, T. Laurila, and M. Paulasto-Kröckel, Comput. Mater. Sci. 50, 690 (2010).
A.-K. Larsson, L. Stenberg, and S. Lidin, Acta Crystall. B-Struct. B50, 636 (1994).
A.U. Telang and T.R. Bieler, JOM 57, 44 (2005).
B. Zhou, T.R. Bieler, T.-K. Lee, and K.-C. Liu, J. Electron. Mater. 39, 2669 (2010).
T.-K. Lee, B. Zhou, L. Blair, K.-C. Liu, and T.R. Bieler, J. Electron. Mater. 39, 2588 (2010).
M.A. Matin, E.W.C. Coenen, W.P. Vellinga, and M.G.D. Geers, Scripta Mater. 53, 927 (2005).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Zhou, B., Bieler, T.R., Lee, TK. et al. Characterization of Recrystallization and Microstructure Evolution in Lead-Free Solder Joints Using EBSD and 3D-XRD. J. Electron. Mater. 42, 319–331 (2013). https://doi.org/10.1007/s11664-012-2307-z
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11664-012-2307-z