Abstract
Stress is believed to be the main driving force for whisker formation in Sn coatings on Cu. This suggests that whiskering can be suppressed by enhancing stress relaxation in the Sn layer, which is believed to be the reason why Sn-Pb alloys do not form whiskers. However, Pb is no longer acceptable for use in electronics manufacturing. As an alternative, we used pulsed plating to create Sn-Bi coatings with an equiaxed microstructure similar to that of Sn-Pb alloys. An optical wafer curvature technique was used to measure stress relaxation kinetics in Sn, Sn-Pb and Sn-Bi alloy thin films during thermal cycles. The results show that Sn-Bi films have significantly enhanced stress relaxation relative to pure Sn films. Comparison between Sn-Bi samples with equiaxed and columnar microstructures shows that both microstructure and alloy composition play a role in enhancing the stress relaxation.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
G.T. Galyon, IEEE Trans. Electron. Packag. Manuf. 28, 94 (2005).
N. Jadhav, E. Buchovecky, E. Chason, and A. Bower, JOM 62, 30 (2010).
S.E. Koonce and S.M. Arnold, J. Appl. Phys. 25, 134 (1954).
U. Lindborg, Met. Trans. A Phys. Metall. Mater. Sci. 6, 1581 (1975).
M. Wickham, D Lea, J. Nottay, and C. Hunt, Processability of Lead-Free Component Termination Materials (National Physical Laboratory, Teddington, Middlesex, UK), http://publications.npl.co.uk/npl_web/pdf/matc47.pdf. Accessed August 2001.
K. Chen and G.D. Wilcox, Phys. Rev. Lett. 94, 66104 (2005).
K.S. Kim, C.H. Yu, and J.M. Yang, Microelectron. Reliab. 46, 1080 (2006).
E. Sandne, M.E. Williams, M.D. Vaudin, and G.R. Stafford, JEM 37, 490 (2008).
K.-S. Kim, S.-S. Kim, S.-J. Kim, K. Suganuma, M. Tsujimoto, and I. Yanad, Prevention of Sn Whisker Formationby Surface Treatment of Sn Plating Part II, Presented at the 137th TMS Annual Meeting, 2008, New Orleans, LA, 2008.
K. Suganuma, K.S. Kim, Y. Yorikado, M. Tsujimoto, and I. Yanada, Prevention of Sn Whisker Formation by Surface Treatment of Sn Plating, Presented at the 136th TMS Annual Meeting & Exhibition, Orlando, FL, 2007.
K.N. Tu, Acta Metall. 21, 347 (1973).
B.Z. Lee and D.N. Lee, Acta Mater. 46, 3701 (1998).
E. Chason, N. Jadhav, W.L. Chan, L. Reinbold, and K.S. Kumar, Appl. Phys. Lett. 92, 171901 (2008).
W.J. Boettinger, C.E. Johnson, L.A. Bendersky, K.W. Moon, M.E. Williams, and G.R. Stafford, Acta Mater. 53, 5033 (2005).
M. Sobiech, U. Welzel, E.J. Mittemeijer, W. Hugel, and A. Seekamp, Appl. Phys. Lett. 93, 3 (2008).
A.E. Pedigo, C.A. Handwerker, and J.E. Blendell, ECTC 58, 1498 (2008).
N. Jadhav, E.J. Buchovecky, L. Reinbold, S. Kumar, A.F. Bower, and E. Chason, IEEE Trans. Electron. Packag. Manuf. 33, 183 (2010).
E. Chason, N. Jadhav, and F. Pei, JOM 63, 62 (2011).
W. Zhang and F. Schwager, J. Electrochem. Soc. 153, C337 (2006).
N. Jadhav, J. Wasserman, F. Pei, and E. Chason, J. Electron. Mater. 41, 588 (2012).
J. Smetana, IEEE Trans. Electron. Packag. Manuf. 30, 11 (2007).
E. Chason and J.A. Floro, Mater. Res. Symp. Proc. 428, 499 (1996).
L.B. Freund and S. Suresh, Thin Film Materials: Stress, Defect Formation and Surface Evolution, 1st ed. (Cambridge, UK: Cambridge University Press, 2009), pp. 86–93.
J.W. Shin and E. Chason, J. Mater. Res. 24, 1522 (2009).
J. Weertman, Trans. Met. Soc. AIME 218, 207 (1960).
J. Weertman and J.E. Breen, J. Appl. Phys. 27, 1189 (1956).
W.D. Callister and D.G. Rethwisch, Materials Science and Engineering: An Introduction, 8th ed. (New York: Wiley, 2009), p. A18.
E. Heyn, Metallographist 6, 37 (1903).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Jadhav, N., Williams, M., Pei, F. et al. Altering the Mechanical Properties of Sn Films by Alloying with Bi: Mimicking the Effect of Pb to Suppress Whiskers. J. Electron. Mater. 42, 312–318 (2013). https://doi.org/10.1007/s11664-012-2267-3
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11664-012-2267-3