Abstract
As an efficient and energy-saving heat exchange technology, horizontal tube falling film evaporation has a great application prospect in refrigeration and air conditioning. The three-dimensional models of falling film flow evaporation outside horizontal single tube and inside evaporator were established, and the accuracy of flow and heat transfer simulation process was verified by comparison. For horizontal single tube, the results showed that total heat transfer coefficient was low and increased with larger spray density and evaporation temperature. The thickness of liquid film outside tube decreased gradually with the increase of tube diameter, and the total heat transfer coefficient of small tube diameter was significantly greater than that of the large tube diameter. The total heat transfer coefficient presented an increasing trend with larger liquid distribution height and density. In addition, the fluctuation of tube axial liquid film thickness distribution decreased with larger liquid distribution density. For evaporator, the results indicated that part of liquid refrigerant was carried into the vapor outlet. The temperature of tube wall and fluid presented a gradually rising trend in vertical downward direction, while tube wall temperature within the same horizontal and transverse row had little difference. The high-temperature zone on the outer wall of heat exchange tube moved towards the inlet and gradually decreased, and the outlet temperature of water in the tube also gradually decreased with the increase of refrigerant spray density. The local heat transfer coefficient of heat exchanger tube in the vertical direction presented a downward trend which was more obvious with the smaller spray density and it was obviously higher located in the middle of upper tube row and both sides of lower tube row for horizontal tube rows.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Jiao Y.H., Horizontal falling-film evaporator spray uniformity analysis and small mass flow falling-film numerical simulation. Huazhong University of Science and Technology, Wuhan, China, 2012.
People Republic of China. China statistical yearbook. China statistical publisher, 2015.
Ribatski G., Jacobi A.M., Falling-film evaporation on horizontal tubes-a critical review. International Journal of Refrigeration, 2005, 28(5): 635–653.
Wang X.F., He M.G., Zhang Y., Numerical simulation of the liquid flowing outside the rube of the horizontal-tube falling film evaporator. Journal of Engineering Thermophysics, 2008, 29(8): 1347–1350.
He M.G., Wang X.F., Zhang Y., et al., Study of flow regime and numerical simulation of film thickness on horizontal-tube falling film evaporator. Journal of Thermal Science and Technology, 2007, 6(4): 319–325.
Qiu Q., Zhu X., Mu L., et al., Numerical study of falling film thickness over fully wetted horizontal round tube. International Journal of Heat and Mass Transfer, 2015, 84: 893–897.
Yang L., Wang W., Zhou J.Q., Numerical simulation of the structural optimization of tube bundles in horizontal-tube falling film evaporators. Journal of Shandong Jianzhu University, 2012, 27(2): 193–197.
Yang L., Liu Y., Yang Y., et al., Microscopic mechanisms of heat transfer in horizontal-tube falling film evaporation. Desalination, 2016, 394: 64–71.
Yang L.P., Zhou Z.Y., Li H.Y., Numerical simulation of the heat transfer characteristics of the falling-film vaporization outside a horizontal tube. Journal of Engineering for Thermal Energy and Power, 2017, 32(10): 24–28.
Jafar F., Thorpe G., Turan Ö., Liquid film falling on horizontal plain cylinders: numerical study of heat transfer in unsaturated porous media. International Journal for Computational Methods in Engineering Science & Mechanics, 2014, 15(2): 101–109.
Zhou Y., Cai Z., Ning Z., et al., Numerical simulation of double-phase coupled heat transfer process of horizontal-tube falling film evaporation. Applied Thermal Engineering, 2017, 118: 33–40.
Gstoehl D., Roques J.F., Crisinel P., et al., Measurement of falling film thickness around a horizontal tube using a laser measurement technique. Heat Transfer Engineering, 2004, 25(8): 28–34.
He M.G., Fan H.L., Wang X.F., et al., Experimental study and numerical simulation on falling film thickness outside a horizontal tube. Journal of Xi’an Jiaotong University, 2010, 44(9): 1–5.
Xu L., Wang S.C., Wang Y.X., et al., Heat-transfer film coefficients outside tube of falling film horizontal-tube evaporator. Journal of Chemical Industry and Engineering, 2004, 55(1): 19–24.
Xu L., Wang S.C., Wang Y.X., et al., Flowing state of liquid films over horizontal tubes and its influences on heat-transfer characteristics. Journal of Chemical Industry and Engineering, 2002, 53(6): 555–559.
Parken W.H.J., Heat transfer to thin water films on horizontal tubes. Thesis, Rutgers University, 1975.
Parken W.H., Fletcher L.S., Heat transfer in thin liquid films flowing over horizontal tubes. Begel House Inc, 1982, 4: 415–420.
Parken W.H., Fletcher L.S., Han J.C., et al., Heat transfer through falling film evaporation and boiling on horizontal tubes. Journal of Heat Transfer, 1990, 112: 3(3): 744–750.
Jin B.H., Zhao C.Y., Liu Q.X., et al., Experimental study on R410A evaporation with horizontal smooth single tube falling film. 2016, http://www.paper.edu.cn.
Ouldhadda D., Idrissi A.I., Asbik M., Heat transfer in non-Newtonian falling liquid film on a horizontal circular cylinder. Heat and Mass Transfer, 2002, 38(7–8): 713–721.
Zhang N., Shao X., Simulation on the inner flow of different distributors in the falling film evaporator with horizontal tubes. Energy Conservation, 2012, 31(5): 19–24.
Hasanpour B., Irandoost M.S., Hassani M. Numerical investigation of saturated upward flow boiling of water in a vertical tube using VOF model: effect of different boundary conditions. Heat and Mass Transfer, 2018, 54: 1925–1936.
Lee W.H., A pressure iteration scheme for two-phase modeling. Technical Report LA-UR 79-975, Los Alamos Scientific Laboratory, Los Alamos, New Mexico, 1979.
Mohammad B., Abas R., Ali A.R., Numerical simulation of bubble behavior in subcooled flow boilingunder velocity and temperature gradient. Nuclear Engineering and Design, 2015, 293: 238–248.
Jeongmin L., Lucas E.O.N., Seunghyun L., Experimental and computational investigation on two-phase flow and heat transfer of highly subcooled flow boiling in vertical upflow. International Journal of Heat and Mass Transfer, 2019, 136: 1199–1216.
Jin P.H., Zhao C.Y., Liu J.X., et al., An experimental study of falling film evaporation outside a horizontal plain tube with R410. China Science and Technology Papers online, 2016, http://www.paper.edu.cn.
Killion J.D., Garimella S., Gravity-driven flow of liquid films and droplets in horizontal tube banks. International Journal of Refrigeration, 2003, 26(5): 516–526.
Killion J.D., Garimella S., Pendant droplet motion for absorption on horizontal tube banks. International Journal of Heat and Mass Transfer, 2004, 47(19): 4403–4414.
Killion J.D., Garimella S., Simulation of pendant droplets and falling films in horizontal tube absorbers. Journal of Heat Transfer, 2004, 126(6): 597–607.
Ouyang X.P., Qiu X.S., Jiang F., Experimental investigation on the falling film evaporation of R404A outside a horizontal tube. Journal of Refrigeration, 2014, 35(1): 77–81.
Dingel B.E., Larson J.W., Flow distributor and baffle system for a falling film evaporator, US, 6830099.
Acknowledgements
This study is financially supported by National Natural Science Foundation of China (No. 52006031) and international cooperation project of China Manned Space Program (6903001173).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Xu, B., Jiang, C. & Chen, Z. Numerical Study on Flow Heat Transfer Characteristics of Horizontal Tube Falling-Film Evaporator. J. Therm. Sci. 30, 1302–1317 (2021). https://doi.org/10.1007/s11630-021-1478-4
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11630-021-1478-4