The effect is considered of such operating properties as the design of a molding unit and the method of drying gypsum molds, on the life of the forming surface of molding units. Avoidance of the disadvantages revealed combined with results obtained in part 1 (E. I. Sudal’tsev, D. V. Kharitonov, and A. A. Anashkina, “Increase in the service life of forming surfaces of molding units. Part 1. Study of the improvement of molding unit forming surface material quality,” Novye Ogneupory, No. 2, 30 – 38 (2010).) of this work make it possible to increase the service life of molds by more than a factor of three
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
Author information
Authors and Affiliations
Additional information
Translated from Novye Ogneupory, No. 3, pp. 35 – 38, March 2010.
Rights and permissions
About this article
Cite this article
Suzdal’tsev, E.I., Kharitonov, D.V. & Anashkina, A.A. Increase in the service life of forming surfaces of molding units. Part 2. Study of the effect of operating properties of molding units on their operating life. Refract Ind Ceram 51, 95–98 (2010). https://doi.org/10.1007/s11148-010-9266-9
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11148-010-9266-9