Abstract
The effect of the material of the alloying electrode on formation of electrospark coatings on blade cutting tools and equipment parts produced from high-speed steel is studied.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
E. V. Shemegon and V. I. Shemegon, “Electrospark hardening of pipe-bending mandrels,” Metalloved. Term. Obrab. Met., No. 7, 37–38 (2003).
V. I. Shemegon and M. V. Zhuk, “Experience in the commercial use of electrospark alloying for raising the wear resistance of blade and die tools,” in: Protective Coatings on Metals [in Russian], Issue 23, Naukova Dumka, Kiev (1999), pp. 96–99.
V. I. Shemegon, “Surface hardening of twist drills,” Metalloved. Term. Obrab. Met., No. 6, 23–30 (1998).
A. E. Gitlevich, A. V. Mikhailov, et al., Electrospark Alloying of Metallic Surfaces [in Russian], Shtinitsa, Kishinev (1985).
A. D. Verkhoturov, I. A. Podchernyaeva, and L. N. Kurilenko, “Formation of secondary structure on the anode in the process of electrospark alloying,” Élektron. Obrab. Mater., No. 1, 26–32 (1987).
V. I. Andreev, V. I. Derevyanko, et al., “Increasing the life of parts by repeated electrospark alloying,” Élektron. Obrab. Mater., No. 1, 84–85 (1975).
V. I. Shemegon, “Increasing the life of punches by electrospark alloying,” Tekhnol. Sudostr., No. 1, 42–46 (1989).
V. I. Shemegon, “Effect of electrospark coatings on the cutting properties of twist drills,” Élektron. Obrab. Mater., No. 5, 85–87 (1990).
Author information
Authors and Affiliations
Additional information
__________
Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 9, pp. 34–39, September, 2007.
Rights and permissions
About this article
Cite this article
Shemegon, V.I. Effect of electrode material on formation of electrospark coatings on cutting tools and equipment parts. Met Sci Heat Treat 49, 457–461 (2007). https://doi.org/10.1007/s11041-007-0086-6
Issue Date:
DOI: https://doi.org/10.1007/s11041-007-0086-6