Abstract
In this paper, we demonstrate the self-Q-switched (SQS) operation of a Nd:GdTaO4 laser with different output couplers. The SQS pulse trains are obtained by slightly adjusting the output coupler (OC) under stable continuous wave (CW) operation. In the SQS operation, we observe an output laser with the laser line at 1,066 nm. Under a pump power of 3.8 W, the laser designed shows the following results: (1) with an OC of 5%, the average output power is 0.249 W, the pulse width is 2.83 μs, and the repetition rate is 48.9 kHz, (2) with an OC of 10%, the average output power is 0.299 W, the pulse width is 3.62 μs, and the repetition rate is 53.0 kHz. In a word, the laser system designed is quite stable and suitable for generation of subnanosecond pulses.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
I. Freund, Appl. Phys. Lett., 12, 388 (1968).
A. A. Fotiadi and P. M´egret, Opt. Lett., 31, 1621 (2006).
J. Dong, K. Ueda, H. Yagi, and A. A. Kaminskii, Opt. Rev., 15, 57 (2008).
Z. B. Pan, B. Yao, H. H. Yu, et al., Opt. Express, 20, 2178 (2012).
E. Beyatli, A. Sennaroglu, and U. Demirbas, J. Opt. Soc. Am. B, 30, 914 (2013).
M. Jiang, Q. L. Zhang, K. S. Qiu, et al., Opt. Commun., 285, 3684 (2012).
Q. Song, G. J. Wang, B. Y. Zhang, et al., J. Mod. Opt., 62, 1655 (2015).
M. X. Li, G. Y. Jin, and Y. Li, Infrared Phys. Technol., 90, 195 (2018).
Author information
Authors and Affiliations
Corresponding author
Additional information
Manuscript submitted by the authors in English on April 16, 2019.
Rights and permissions
About this article
Cite this article
Zhang, W., Guo, L.P. & Xie, B.M. Self-Q-Switched Operation in a Nd:GdTaO4 Crystal at 1,066 nm. J Russ Laser Res 40, 255–258 (2019). https://doi.org/10.1007/s10946-019-09798-0
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10946-019-09798-0