Abstract
The (Mg0.75Zn0.25)TiO3 ceramics with Ta2O5 additive were prepared with solid-state reaction method. Ta2O5 as an additive effectively lowered the sintering temperature to 1100 °C and improved the microstructure of the ceramics. Ta5+ was completely incorporated into the (Mg0.75Zn0.25)TiO3 lattice to form the ilmenite phase (R-3), alongside the emergence of a second phase, MgTi2O5. The increasing content of the second phase caused the cell volume of the main phase to increase. When the Ta2O5 content is less than 5 wt%, the density of the ceramics has the main effect on the εr, while above 5 wt%, the second phase plays a dominant role in the εr of the ceramics. The results showed that when the additive of Ta2O5 is 2 wt%, the ceramics sintered at 1100 °C for 3 h exhibited the excellent microwave dielectric properties of Q × f ~ 108,726 (at 7.9 GHz), εr ~ 18.73 and τf ~ − 59.76 ppm/°C.
Similar content being viewed by others
Data Availability Statements
No data was used for the research described in the article. Data will be made available on request.
References
M.T. Sebastian, H. Jantunen, Low loss dielectric materials for LTCC applications: a review. Int. Mater. Rev. 53, 57–90 (2008)
Q.B. Du, J.H. Duan, L.Z. Ma, L.X. Jiang, H. Li, Sintering temperature, microwave dielectric properties and structural characteristics of Li2Zn6MgTi6O20 ceramic with high configuration entropy. J. Eur. Ceram. Soc. 44, 5639–5645 (2024)
X. Zhang, B. Tang, Z. Fang, H. Yang, Z. Xiong, L. Xue, S. Zhang, Structural evolution and microwave dielectric properties of a novel Li3Mg2−x/3Nb1−2x/3TixO6 system with a rock salt structure. Inorg. Chem. Front. 5, 3113–3125 (2018)
M.R. Mohammadi, D.J. Fray, Low temperature nanostructured zinc titanate by an aqueous particulate sol–gel route: optimisation of heat treatment condition based on Zn: Ti molar ratio. J. Eur. Ceram. Soc. 30, 947–961 (2010)
F.H. Dulin, D.E. Rase, Phase equilibria in the system ZnO–TiO2. J. Am. Ceram. Soc. 43, 125–131 (1960)
S.H. Lei, H.Q. Fan, X.H. Ren, J.W. Fang, L.T. Ma, Z.Y. Liu, Novel sintering and band gap engineering of ZnTiO3 ceramics with excellent microwave dielectric properties. J. Mater. Chem. C 5, 4040–4047 (2017)
L. Li, X.M. Chen, X.C. Fan, Microwave dielectric characteristics and finite element analysis of MgTiO3–CaTiO3 layered dielectric resonators. J. Eur. Ceram. Soc. 26, 3265–3271 (2006)
Z.P. Xu, L.X. Li, S.H. Yu, M.K. Du, W.J. Luo, Magnesium fluoride doped MgTiO3 ceramics with ultra-high Q value at microwave frequencies. J. Alloy. Compd. 802, 1–5 (2019)
J. Zhang, Z.X. Yue, Y. Luo, L.T. Li, MgTiO3/TiO2/MgTiO3: An ultrahigh-Q and temperature-stable microwave dielectric ceramic through cofired trilayer architecture. Ceram. Int. 44, 21000–210003 (2018)
H.T. Kim, Y. Kim, Titanium incorporation in Zn2TiO4 spinel ceramics. J. Am. Ceram. Soc. 84, 1081–1086 (2004)
L. Li, C.Y. Shen, C. Qiu, Study on microwave dielectric properties of (Mg1-xZnx)TiO3 system ceramics. Electronic Components Mater. 10, 38–40 (2008)
Y. Chen, Microwave dielectric properties of x(Mg0.7Zn0.3)0.95Co0.05TiO3 -(1-x)Ca0.8Sm0.4/3TiO3 ceramics with a zero temperature coefficient of resonant frequency, J. Alloy Compd. 507, 286–289 (2010)
X. Chen, J. Yang, Dielectric characteristics of ceramics in BaO-Nd2O3-TiO2-Ta2O5 system. J. Eur. Ceram. Soc. 19, 139–142 (1999)
C. Huang, C. Shen, Phase evolution and dielectric properties of (Mg0.95M0.05 2+)Ti2O5 (M2+ = Co, Ni, and Zn) ceramics at microwave frequencies. J. Am. Ceram. Soc. 92, 384–388 (2009)
V.M. Goldschmidt, Die gesetze der krystallochemie. Naturwissenschaften 14, 477–485 (1926)
A.E. Ringwood, The principles governing trace element distribution during magmatic crystallization Part I: The influence of electronegativity. Geochim. Cosmochim. Acta 7, 189–202 (1955)
T. Shi, F. Zhang, W. Sun, J. Li, Y. Bai, C. Wang, X. Wang, Y.H. Yang, Z.J. Wang, Fabrication, sinterability and microwave dielectric properties of MgTiO3−(Ca0.8Sr0.2)TiO3 composite ceramics from nanosized powders. Vacuum. 201, 111107 (2022)
L. Giordano, M. Viviani, C. Bottino, M.T. Buscaglia, V. Buscaglia, P. Nanni, Microstructure and thermal expansion of Al2TiO5–MgTi2O5 solid solutions obtained by reaction sintering. J. Eur. Ceram. Soc. 11, 1811–1822 (2002)
Funding
This work was supported by the National Natural Science Foundation of China (No.52102129).
Author information
Authors and Affiliations
Contributions
Tao Yu: Conceptualization, Methodology, Investigation, Data curation, Writing—original draft. Zhicong Chen: Methodology, Investigation, Data curation. Chang Jiang: Formal analysis, Investigation. Hongkang Liang: Conceptualization, Methodology. Hongzhi Xiao: Conceptualization, Formal analysis. Qianbiao Du: Conceptualization, Methodology, Formal analysis, Investigation, Data curation, Writing—original draft, Writing—review & editing. Li Hao: Writing—review & editing, Investigation, Funding acquisition.
Corresponding authors
Ethics declarations
Conflict of interest
The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Yu, T., Chen, Z., Jiang, C. et al. Effect of Ta2O5 additive on the properties of (Mg0.75Zn0.25)TiO3 ceramics with high frequency and high Q-value. J Mater Sci: Mater Electron 35, 1718 (2024). https://doi.org/10.1007/s10854-024-13477-5
Received:
Accepted:
Published:
DOI: https://doi.org/10.1007/s10854-024-13477-5