Abstract
For the first time under the auspices of the Bureau International des Poids et Mesures (BIPM), seven national metrology institutes (NMIs) participated in an international interlaboratory comparison on thermal-conductivity measurements by the guarded hot-plate method. Measurements were conducted successively by all participants on the same set of specimens of insulating materials (mineral wool and expanded polystyrene) at temperatures ranging from 10 °C to 40 °C, according to the International Standard ISO 8302. This protocol aims to minimize issues of material variability by circulating the same pairs of specimens among the laboratories following the strict format of a round-robin test program. This comparison is a pilot study which is intended as a first stage for future key comparisons between NMIs. The descriptive analysis of obtained results shows good agreement between laboratories for the mineral wool (MW) specimens and the thicker specimens of expanded polystyrene (EPS), with relative deviations within the uncertainties of measurement. A positive drift of thermal-conductivity values, which has appeared progressively during the comparison process, seems to be correlated with the size of the metering area of the guarded hot plates used. A statistical analysis was applied to repeated thermal-conductivity measurements at 23 °C, to identify anomalous and outlying data, to assess the within- and between-laboratory variability, and to evaluate the participant laboratories’ performance.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
ISO 8302, Thermal Insulation—Determination of Steady-State Thermal Resistance and Related Properties—Guarded Hot Plate Apparatus (2001)
ASTM C 177, Standard Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded Hot Plate Apparatus (2004)
Quin S., Hameury J.: High Temp. High Press. 29, 649 (1997)
Smith D.R.: Int. J. Thermophys. 18, 1557 (1997)
R.R. Zar, J.J. Filliben, International Comparison of Guarded Hot Plate Apparatus Using National and Regional Reference Materials. NIST Technical Note 1444 (2002)
B. Hay, L. Cortes, B. Doucey, J.-R. Filtz, U. Hammerschmidt, N. Sokolov, C. Stacey, R. Zarr, J. Zhang, International Comparison on Thermal Conductivity Measurements of Insulating Materials by Guarded Hot Plate Preliminary Results, Thermal Conductivity, vol. 30 (DEStech Publications, Lancaster, PA, 2010), pp. 378–385, IBSN 978-1-60595-015-0
JCGM 100:2008 (GUM 1995 with Minor Corrections), Evaluation of Measurement Data—Guide to the Expression of Uncertainty in Measurement (2008)
S. Quin, G. Venuti, F. DePonte, A. Lamberty, Certification of a Resin-Bonded Glass Fibre Board for Thermal Conductivity Between −10°C and + 50°C—IRMM440, Report EUR 19572 EN (2000)
EN 13163, Thermal Insulation Products for Buildings—Factory Made Products of Expanded Polystyrene (EPS)—Specification (2008)
W. Woodside, A.G. Wilson, Unbalance Errors in Guarded Hot Plate Measurements, Special Technical Publication No. 217 (ASTM, West Conshohocken, PA, 1957), pp. 32–46
W. Woodside, Analysis of Errors due to Edge Heat Loss in Guarded Hot Plates, Special Technical Publication No. 217 (ASTM, West Conshohocken, PA, 1957), pp. 49–62
H.W. Orr, A Study of the Effects of Edge Insulation and Ambient Temperatures on Errors in Guarded Hot Plate Measurements, NRCC 10680, Research Paper No. 398, reprinted from Proceedings of 7th Conference on Thermal Conductivity, in NBS Special Publication No. 302 (1969), pp. 521–526
Pham Q.T., Smith C.G.: Rev. Sci. Instrum. 57, 99 (1986)
ISO 5725-2, Accuracy (Trueness and Precision) of Measurement Methods and Results—Basic Method for the Determination of Repeatability and Reproducibility of a Standard Measurement Requirements Method (1994)
ISO 17043, General for Proficiency Testing (2010)
ISO 13528, Statistical Methods for use in Proficiency Testing by Interlaboratory Comparisons (2005)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Hay, B., Zarr, R., Stacey, C. et al. Analysis of Thermal-Conductivity Measurement Data from International Comparison of National Laboratories. Int J Thermophys 34, 737–762 (2013). https://doi.org/10.1007/s10765-012-1225-x
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10765-012-1225-x