Abstract
A non-classical Mindlin plate model is developed using a modified couple stress theory. The equations of motion and boundary conditions are obtained simultaneously through a variational formulation based on Hamilton’s principle. The new model contains a material length scale parameter and can capture the size effect, unlike the classical Mindlin plate theory. In addition, the current model considers both stretching and bending of the plate, which differs from the classical Mindlin plate model. It is shown that the newly developed Mindlin plate model recovers the non-classical Timoshenko beam model based on the modified couple stress theory as a special case. Also, the current non-classical plate model reduces to the Mindlin plate model based on classical elasticity when the material length scale parameter is set to be zero. To illustrate the new Mindlin plate model, analytical solutions for the static bending and free vibration problems of a simply supported plate are obtained by directly applying the general forms of the governing equations and boundary conditions of the model. The numerical results show that the deflection and rotations predicted by the new model are smaller than those predicted by the classical Mindlin plate model, while the natural frequency of the plate predicted by the former is higher than that by the latter. It is further seen that the differences between the two sets of predicted values are significantly large when the plate thickness is small, but they are diminishing with increasing plate thickness.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Lam D.C.C., Yang F., Chong A.C.M., Wang J., Tong P.: Experiments and theory in strain gradient elasticity. J. Mech. Phys. Solids 51, 1477–1508 (2003)
McFarland A.W., Colton J.S.: Role of material microstructure in plate stiffness with relevance to microcantilever sensors. J. Micromech. Microeng. 15, 1060–1067 (2005)
Lazopoulos K.A.: On the gradient strain elasticity theory of plates. Euro. J. Mech. A Solids 23, 843–852 (2004)
Altan B.S., Aifantis E.C.: On some aspects in the special theory of gradient elasticity. J. Mech. Behav. Mater. 8(3), 231–282 (1997)
Gao X.-L., Park S.K.: Variational formulation of a simplified strain gradient elasticity theory and its application to a pressurized thick-walled cylinder problem. Int. J. Solids Struct. 44, 7486–7499 (2007)
Gao X.-L., Ma H.M.: Solution of Eshelby’s inclusion problem with a bounded domain and Eshelby’s tensor for a spherical inclusion in a finite spherical matrix based on a simplified strain gradient elasticity theory. J. Mech. Phys. Solids 58, 779–797 (2010)
Papargyri-Beskou S., Beskos D.E.: Static, stability and dynamic analysis of gradient elastic flexural Kirchhoff plates. Arch. Appl. Mech. 78, 625–635 (2008)
Papargyri-Beskou S., Giannakopoulos A.E., Beskos D.E.: Variational analysis of gradient elastic flexural plates under static loading. Int. J. Solids Struct. 47, 2755–2766 (2010)
Eringen A.C.: On differential equations of nonlocal elasticity and solutions of screw dislocation and surface waves. J. Appl. Phys. 54, 4703–4710 (1983)
Lu P., Zhang P.Q., Lee H.P., Wang C.M., Reddy J.N.: Non-local elastic plate theories. Proc. R. Soc. A 463, 3225–3240 (2007)
Tsiatas G.C.: A new Kirchhoff plate model based on a modified couple stress theory. Int. J. Solids Struct. 46, 2757–2764 (2009)
Jomehzadeh E., Noori H.R., Saidi A.R.: The size-dependent vibration analysis of micro-plates based on a modified couple stress theory. Phys. E 43, 877–883 (2011)
Yang F., Chong A.C.M., Lam D.C.C., Tong P.: Couple stress based strain gradient theory for elasticity. Int. J. Solids Struct. 39, 2731–2743 (2002)
Park S.K., Gao X.-L.: Variational formulation of a modified couple stress theory and its application to a simple shear problem. Z. Angew. Math. Phys. 59, 904–917 (2008)
Lazopoulos K.A.: On bending of strain gradient elastic micro-plates. Mech. Res. Commun. 36, 777–783 (2009)
Li S.: On the micromechanics theory of Reissner–Mindlin plates. Acta Mech. 142, 47–99 (2000)
Li S.: The micromechanics theory of classical plates: a congruous estimate of overall elastic stiffness. Int. J. Solids Struct. 37, 5599–5628 (2000)
Park S.K., Gao X.-L.: Bernoulli–Euler beam model based on a modified couple stress theory. J. Micromech. Microeng. 16, 2355–2359 (2006)
Ma H.M., Gao X.-L., Reddy J.N.: A microstructure-dependent Timoshenko beam model based on a modified couple stress theory. J. Mech. Phys. Solids 56, 3379–3391 (2008)
Ma H.M., Gao X.-L., Reddy J.N.: A non-classical Reddy–Levinson beam model based on a modified couple stress theory. Int. J. Multiscale Comput. Eng. 8, 167–180 (2010)
Mindlin R.D.: Influence of couple-stresses on stress concentrations. Exp. Mech. 3, 1–7 (1963)
Mindlin R.D., Tiersten H.F.: Effects of couple-stresses in linear elasticity. Arch. Ration. Mech. Anal. 11, 415–448 (1962)
Koiter W.T.: Couple-stresses in the theory of elasticity. Proc. K. Ned. Akad. Wet. B 67, 17–44 (1964)
Timoshenko S.P., Goodier J.N.: Theory of Elasticity, 3rd edn. McGraw-Hill, New York (1970)
Horgan C.O.: On the strain-energy density in linear elasticity. J. Eng. Math. 7, 231–234 (1973)
Fung Y.C., Tong P.: Classical and Computational Solid Mechanics. World Scientific, Singapore (2001)
Chong A.C.M., Yang F., Lam D.C.C., Tong P.: Torsion and bending of micron-scaled structures. J. Mater. Res. 16, 1052–1058 (2001)
Nikolov S., Han C.-S., Raabe D.: On the origin of size effects in small-strain elasticity of solid polymers. Int. J. Solids Struct. 44, 1582–1592 (2007)
Reddy J.N.: Energy Principles and Variational Methods in Applied Mechanics, 2nd edn. Wiley, New York (2002)
Reddy J.N.: Theory and Analysis of Elastic Plates and Shells, 2nd edn. Taylor & Francis, Philadelphia (2007)
Gao X.-L., Mall S.: Variational solution for a cracked mosaic model of woven fabric composites. Int. J. Solids Struct. 38, 855–874 (2001)
Stephen N.G.: Mindlin plate theory: best shear coefficient and higher spectra validity. J. Sound Vib. 202, 539–553 (1997)
Wang C.M., Lim G.T., Reddy J.N., Lee K.H.: Relationships between bending solutions of Reissner and Mindlin plate theories. Eng. Struct. 23, 838–849 (2001)
Liu Y., Soh C.-K.: Shear correction for Mindlin type plate and shell elements. Int. J. Numer. Meth. Eng. 69, 2789–2806 (2007)
Batista M.: An elementary derivation of basic equations of the Reissner and Mindlin plate theories. Eng. Struct. 32, 906–909 (2010)
Mindlin R.D.: Influence of rotatory inertia and shear on flexural motions of isotropic, elastic plates. ASME J. Appl. Mech. 18, 1031–1036 (1951)
Maneschy C.E., Miyano Y., Shimbo M., Woo T.C.: Residual-stress analysis of an epoxy plate subjected to rapid cooling on both surfaces. Exp. Mech. 26, 306–312 (1986)
Cooke D.W., Levinson M.: Thick rectangular plates–II: the generalized Lévy solution. Int. J. Mech. Sci. 25, 207–215 (1983)
Kabir H.R.H., Chaudhuri R.A.: Boundary-continuous Fourier solution for clamped Mindlin plates. ASCE J. Eng. Mech. 118, 1457–1467 (1992)
Naumenko K., Altenbach J., Altenbach H., Naumenko V.K.: Closed and approximate analytical solutions for rectangular Mindlin plates. Acta Mech. 147, 153–172 (2001)
Batista M.: Refined Mindlin–Reissner theory of forced vibrations of shear deformable plates. Eng. Struct. 33, 265–272 (2011)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Ma, H.M., Gao, X.L. & Reddy, J.N. A non-classical Mindlin plate model based on a modified couple stress theory. Acta Mech 220, 217–235 (2011). https://doi.org/10.1007/s00707-011-0480-4
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00707-011-0480-4