Abstract.
A combined elastic–Raman lidar system based on a tripled Nd:YAG laser is used for the separate detection of elastic backscatter and Raman signals from atmospheric nitrogen, water vapor and liquid water and for their depolarization measurement. Vertical profiles of water-vapor and liquid-water content measured under clear-sky conditions behave differently: inside the boundary layer the ratio of liquid-water to water-vapor Raman backscatters rises with altitude. The depolarization measurements bring additional information about atmospheric scattering. The observed depolarization ratio of the water-vapor Raman signal is about 14%, while for liquid water this ratio varies in the 30–75% range, which exceeds the depolarization of bulk water and is attributed to the water-aerosol effects. Raman contours of water vapor and liquid water are partially overlapped, and bleed-through of liquid-water Raman backscatter leads to enhancement of depolarization of the water-vapor Raman signal. This parameter may be used as a convenient indicator of liquid-water interference in water-vapor measurements.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
Author information
Authors and Affiliations
Additional information
Received: 12 December 2000 / Revised version: 27 September 2001 / Published online: 7 November 2001
Rights and permissions
About this article
Cite this article
Veselovskii, I., Cha, H., Kim, D. et al. Study of atmospheric water in gaseous and. liquid state by using combined elastic–Raman. depolarization lidar. Appl Phys B 73, 739–744 (2001). https://doi.org/10.1007/s003400100732
Issue Date:
DOI: https://doi.org/10.1007/s003400100732