Abstract.
A thermal model of the interaction of pulsed near-infrared laser radiation from a Nd:YAG laser was made, taking the measured powder properties such as reflectance, optical penetration depth and thermal conductivity into account. It allows an estimation of the evolution of two different temperatures: the average temperature of the powder (taken over the grains in a volume given by the laser beam diameter and the optical penetration depth) and the temperature distinction within a single grain. It showed that in pulsed mode consolidation can be achieved at much lower average power as the surface of the powder particles are molten but their cores remain at nearly room temperature. This leads to a much lower average temperature and therefore a dramatic decrease in residual thermal stresses in the finished piece. The results of the model were experimentally tested and confirmed.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
Author information
Authors and Affiliations
Additional information
Received: 26 July 2001 / Accepted: 23 November 2001 / Published online: 23 January 2002
Rights and permissions
About this article
Cite this article
Fischer, P., Karapatis, N., Romano, V. et al. A model for the interaction of near-infrared laser pulses with metal powders in selective laser sintering . Appl Phys A 74, 467–474 (2002). https://doi.org/10.1007/s003390101139
Issue Date:
DOI: https://doi.org/10.1007/s003390101139