Abstract
In this paper, a wind energy conversion system, which consists of a variable speed wind turbine with doubly-fed induction generator (DFIG) fed by a matrix converter is considered. The stator of the wind turbine driven generator is directly connected to the grid, while the rotor is connected via slip-rings to the output of a matrix converter. The matrix converter is supplied from the grid and replaces the conventional two back-to-back converters used for the control of a DFIG. Modeling of the energy conversion system considers super-synchronous and sub-synchronous operating conditions, which are achieved by means of the matrix converter. In order to decouple the active and reactive power, stator field oriented control is applied. Speed mode control is adopted for maximum wind energy extraction, provided that the wind speed and pitch angle of the turbine are known for each sampling period. Consequently, a 2-D lookup table calculating the reference speed by means of interpolation/extrapolation is introduced. Reactive power control is performed so that the stator reactive power is kept to zero. Promising simulation results demonstrating the control performance of the wind energy conversion system are presented.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Cirricione M, Pucci M, Vitale G (2011) Growing neural gas (GNG)-based maximum power point tracking for high-performance wind generator with an induction machine. Proc IEEE Trans Ind Appl 47: 861–872
Agarwal V, Aggarwal RK, Patidar P, Patki C (2010) A novel scheme for rapid tracking of maximum power point in wind energy generation systems. Proc IEEE Trans Energy Convers 25: 228–236
Cardenas R, Pena R, Tobar G, Clare J, Wheeler P, Asher G (2009) Stability analysis of a wind energy conversion system based on a doubly fed induction generator fed by a matrix converter. Proc IEEE Trans Ind Electron 56: 4194–4206
Chwa D, Lee K-B (2010) Variable structure control of the active and reactive powers for a DFIG in wind turbines. Proc IEEE Trans Ind Appl 46: 2545–2555
Poitiers F, Bouaouiche T, Machmoum M (2009) Advanced control of a doubly-fed induction generator for wind energy conversion. Elsevier Electr Power Syst Res 79: 1085–1096
Petersson A (2005) Analysis, modeling and control of doubly-fed induction generators for wind turbines. PhD Thesis, Chalmers University of Technology, Göteborg, Sweden
Tapia A, Tapia G, Ostolaza JX, Saenz JR (2003) Modeling and control of a wind turbine driven doubly fed induction generator. Proc IEEE Trans Energy Convers 18: 194–204
Pena R, Clare JC, Asher GM (1996) A doubly fed Induction generator using back-to-back PWM converters supplying an isolated load from variable speed wind turbine. IEEE Proc Trans Electr Power Appl 143: 380–387
Cadirci I, Ermis M (1992) Double-output induction generator operating at subsynchronous and supersynchronous speeds: steady-state performance optimisation and wind-energy recovery. IEEE Proc B 139(5): 429–442
Zhang L, Watthanasarn C (1998) A matrix converter excited doubly-fed induction machine as wind power generator. In: 7th international conference on power electronics and variable speed Drives, IEEE publications issue 456, pp 532–537
Zhang S, Tseng KJ, Nguyen TD (2009) Modeling of AC–AC matrix converter for wind energy conversion system. In: 4th IEEE conference on industrial electronics and applications (ICIEA’09), vol 1–6, pp 184–191
Shapoval I, Clare J, Chekhet E (2008) Experimental study of a matrix converter excited doubly-fed induction machine in generation and motoring. In: 13th international power electronics and motion control conference (EPE-PEMC 2008), pp 307–312
Ghedamsi K, Auzellag D, Berkouk EM (2006) Application of matrix converter for variable speed wind driving an doubly fed induction generator. In: Proceedings of IEEE, SPEEDAM 2006, international symposium on power electronics, electrical drives, automation and motion, pp S3-38–S3-42
Hector A, Painemal P, Sauer PW (2010) Power system modal analysis considering doubly-fed induction generators. In: Proceedings of IEEE-IREP’10, Buzios, RJ, Brazil
Wheeler P, Rodriguez J, Clare J, Empringham E, Weinstein A (2002) Matrix converters: a technology review. Proc IEEE Trans Ind Electron 49: 276–288
Sunter S, Clare JC (1996) A true four quadrant matrix converter induction motor drive with servo performance. In: Proceedings of IEEE-PESC’96, Baveno-Italy, pp 146–151
Altun H, Sunter S (2003) Matrix converter induction motor drive: modeling, simulation and control, electrical engineering, vol 86. Springer, Berlin, pp 25–33
Altun H, Sunter S (2007) Application of matrix converter to doubly-fed induction motor for slip energy recovery with improved power quality. In: Proceedings of IEEE-ACEMP’07, Bodrum-Turkey, pp 485–490
Gonzales FD, Martinez-Rojas M. Sumper A, Gomis-Bellmunt O, Trilla L (2010) Strategies for reactive power control in wind farms with STATCOM. In: EPE wind energy chapter symposium, Stafford, UK, pp 1–10
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Altun, H., Sünter, S. Modeling, simulation and control of wind turbine driven doubly-fed induction generator with matrix converter on the rotor side. Electr Eng 95, 157–170 (2013). https://doi.org/10.1007/s00202-012-0250-x
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00202-012-0250-x