Avoid common mistakes on your manuscript.
Correction to: The International Journal of Advanced Manufacturing Technology (2017) 92: 1185–1200
The acceleration signals of different milling states. b Condition B. c Condition C
The milling state diagrams (top view, ap = 4 mm)
The original version of this article contained mistakes.
-
1.
In Fig. 7b and Fig. 7c, the data after 3.9 s are redundant. These errors are caused by mistakenly importing the same data segment during the process of plotting these two figures. The correct images of Fig. 7b and Fig. 7c are shown below.
-
2.
In the schematic diagram of Fig. 14, the number of cutter teeth is 3, and the axial depth of cut is ap = 4 mm. The correct image is shown below.
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher’s note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
The online version of the original article can be found at https://doi.org/10.1007/s00170-017-0183-7
Rights and permissions
About this article
Cite this article
Ji, Y., Wang, X., Liu, Z. et al. Correction to: EEMD-based online milling chatter detection by fractal dimension and power spectral entropy. Int J Adv Manuf Technol 111, 2401–2402 (2020). https://doi.org/10.1007/s00170-020-06244-3
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00170-020-06244-3