Abstract
A mathematical model to represent the expansion and fragmentation of copper matte particles oxidized under flash converting conditions is presented. The model assumes that the particles are initially nonporous, have a constant mass prior to fragmentation and travel at a constant velocity throughout the reaction chamber. The model requires the specification of the following five parameters: the particle expansion rate, a fragmentation diameter factor, a fragmentation size distribution parameter and the fractions of the finest and the coarsest particles in the feed that undergo fragmentation. The model predictions show good agreement with the experimental data collected in a laboratory furnace over a wide range of experimental conditions. The evolution of the size distribution of the particles along the reactor length was computed, and the model parameters were correlated with the experimental operating variables. Model predictions indicate that particle residence time is an important factor in the generation of dust. The presence of two maxima in the particle density function may be attributed to turbulent conditions prevailing in the furnace, which cause particles to follow different trajectories within the furnace even if they are injected at the same location.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Jokilaakso, A.T., Suominen, R.O., Taskinen, P.A., and Lilius, K.R., 1991, “Oxidation of chalcopyrite in simulated suspension smelting,” Transactions of the Institution of Mining and Metallurgy, Section C — Mineral Processing and Extractive Metallurgy, Vol. 100, pp. C79–C90.
Kim, Y.H., and Themelis, N.J., 1986, “Effect of phase transformation and particle fragmentation on the flash reaction of complex metal sulfides,” The Reinhardt Schuhmann International Symposium on Innovative Technology and Reactor Design in Extractive Metallurgy, D.R. Gaskell, Hager, J.P., Hoffman, J.E., Mackey, P.J., eds., Nov. 9–12, 1986, Colorado Springs, Colorado, TMS, Warrendale, Pennsylvania, pp. 349–369.
King, R. P., 1973, “An analytical solution to the batch comminution equation,” Journal of South African Institute of Mining and Metallurgy, Vol. 73, pp. 127.
Perez-Tello, M., Sohn, H.Y., St Marie, K., and Jokilaakso, A., 2001a, “Experimental investigation and three-dimensional computational fluid-dynamics modeling of the flash-converting furnace shaft: Part I. Experimental observation of copper converting reactions in terms of converting rate, converting quality, changes in particle size, morphology, and mineralogy,” Metallurgical and Materials Transactions B — Process Metallurgy and Materials Processing Science, Vol. 32, No. 5, pp. 847–868.
Perez-Tello, M., Sohn, H.Y., and Smith, P.J., 2001b, “Experimental investigation and three-dimensional computational fluid-dynamics modeling of the flash-converting furnace shaft: Part II. Formulation of three-dimensional computational fluid-dynamics model incorporating the particle-cloud description,” Metallurgical and Materials Transactions B — Process Metallurgy and Materials Processing Science, Vol. 32, No. 5, pp. 869–886.
Perez-Tello, M., Tirado-Ochoa, J.A., Sohn, H.Y., and Sanchez-Corrales, V.M., 2002, “Size distribution analysis of copper matte particles oxidized under flash converting conditions,” JOM, Vol. 54, No. 10, pp. 27–30.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Pérez-Tello, M., Madrid-Ortega, I.M. & Sohn, H.Y. Model for the fragmentation of copper matte particles during flash converting. Mining, Metallurgy & Exploration 25, 53–60 (2008). https://doi.org/10.1007/BF03403386
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/BF03403386