Abstract
Overtempering characteristics of Mn-Cr steel used in retaining rings have been considered. The microstructures of the steel at various tempering temperatures have been determined. Mechanical properties at room temperature along with fractographic characteristics of the tensile and impact test specimens have been evaluated. The metallographic results show that massive carbide precipitation begins at 450‡ C onwards on stress relief. The mechanical test results indicate that the determination of the percentage reduction in area in tensile test, energy absorbed in impact test, and both tensile and impact fractographs give an accurate picture of the health of a retaining ring forging.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
S. Stein: Manufacture of Retaining Rings. M.O. Speidel and A. Strens (eds.),Corrosion in Power Generating Equipment, Plenum Press, 1984.
N.L. Kilpatrick, J.S. Habib, L.C. Nottingham, and S.K. Hwang: Electric Power Research Institute Workshop on Retaining Rings, 1982.
V. Scalise, G. Benucci, and G. Rossi: The Manufacture of Nonmagnetic End Bells for Turbogenerators, Conference on Heavy Forging, Terni, 1961: BISI Trans 2518, 1961.
R.B. Scarlin and J. Albrecht: Environment Induced Cracking of Generator Rotor Retaining Ring. M.O. Speidel and A. Atrens (eds.),Corrosion in Power Generating Equipment, Plenum Press, 1984.
V. Chihal, F. Poboril, A.V. Rjabcenkov, and V.I. Gerasimov:Werkstoffe Korrosion, 1980, Vol. 31, p. 34.
M.O. Speidel:V.G.B. Kraffwerktechnik (English), 1982, Vol. 5, p. 362.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Mukhopadhyay, N., Somasundaram, R. Influence of overtempering on the micromechanical aspects of a Mn-Cr steel used in turbogenerator. J. Materials Engineering 11, 177–184 (1989). https://doi.org/10.1007/BF02834466
Issue Date:
DOI: https://doi.org/10.1007/BF02834466