Abstract
A spouted bed with an impermeable draft tube was employed to obtain fundamental data of binary mixtures of glass beads for both the operating conditions and the design factors. These data were compared with those for the coarser particle system only. From this view point, minimum spouting velocity, pressure drop, hold-up of solid particles within a draft tube, upward gas flow rate within the annulus and solids circulation rate were determined by changing the total gas flow rate and mass fraction of finer particles as operating parameters and by changing distance of entrainment zone and draft tube diameter as geometric parameters.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Anabtawi, M. Z., “Minimum Spouting Velocity for Binary Mixture of Particles in Rectangular Spouted Beds,”Can. J. Chem. Eng.,76,132 (1998).
Fukumori, Y. and Ichikawa, H., “Microencapsulation of Pharmaceuticals by Fluidized Bed Process,”J. Soc. Powder Technol, Japan,34, 536 (1997).
Grace, J. R., Kutluoglu, E., Murchie, K. W. and Cavanagh, P. H., “Particle Segregation in Spouted Beds,”Can. J. Chem. Eng.,61, 308 (1983).
Hatate, Y, Mihara, H., Ijichi, K., Yoshimi, T., Arimizu, S., Uemura, Y. and King, D. F., “Catalytic Coal Gasification Using a Draft Tube Spouted Bed Gasifier,”Kagaku Kogaku Ronbunshu,22, 1180 (1996).
Hatate, Y, Ijichi, K. and Uemura, Y, “Flow Characteristics of Draft Tube Spouted Bed and Its Application,”J. Soc. Powder Technol., Japan,34, 343 (1997).
Hattori, H. and Nagai, T, “Spouted Bed with a Draft-Tube without Gas Inlet Nozzle or Orifice,”J. Chem. Eng. Japan,29, 484 (1996).
Ijichi, K., Uemura, Y, Hatate, Y. and Tanaka, Y, “Fluidization of Fine Particles in a Spouted Bed with a Draft-tube,”J. Soc. Powder Technol, Japan,33, 706 (1996).
Ijichi, K., Uemura, Y, Yoshizawa, H., Hatate, Y. and Yoshida, K., “Conveying Characteristics of Fine Particles Using Converging Nozzle,”Kagaku Kogaku Ronbunshu,24, 365 (1998).
Ishikura, T, Shinohara, H. and Funatsu, K., “Minimum Spouting Velocity for Binary Mixtures of Particles,”Can. J. Chem. Eng.,60,697 (1982).
Ishikura, T., Nagashima, H. and Ide, M., “Minimum Spouting Velocity of Binary Particle Systems in a Spouted Bed with a Draft Tube,”Kagaku Kogaku Ronbunshu,24, 346 (1998).
Khoe, G. K. and Brakel, J. V., “Drying Characteristics of a Draft Tube Spouted Bed,”Can J. Chem. Eng.,61,411 (1983).
Kim, S. J. and Ha, J. H., “Flow in the Annulus of a Water Spouted Bed of Small Glass Particles at Minimum Spouting,”J. Chem. Eng. Japan,19, 319 (1986).
Kim, S. J., “Fluid and Particle Flow Characteristics in a Draft Tube Spouted Bed with Modified Fluid Outlet,”Korean J. Chem. Eng.,7,74(1990).
Kim, S. J., “Spouting Characteristics of Small Glass Particles with Water,”Korean J. Chem. Eng.,2,189 (1985).
Kim, S. J., “The Characteristics of Fluid Flow in Bed of Small Glass Particles Spouted with Water,”Korean J. Chem. Eng.,1, 35 (1984).
Liftman, H., Morgan, M. H. and Morgan, C. B., “A New Computer Controlled Wurster-type Particle Coating Apparatus,”AIChE Symp. Series, No. 317,93,125 (1997).
Mathur, K. B. and Epstein, N., “Spouted Beds,” Academic Press, New York, USA (1974).
Milne, B. J., Berruti, F., Behie, L. A. and De Bruijn, T. J. W, “The Internally Circulating Fluidized Bed (ICFB): A Novel Solution to Gas Bypassing in Spouted Beds,”Can. J. Chem. Eng.,70, 910 (1992).
Song, B. H., Ahn, H. S., Lee, W J. and Kim, S. D., “Gas-Solids Behavior in an Internally Circulating Fluidized Bed with an Orifice-Type Draft Tube,” Proc. of the 6th Asian Conference on Fluidized-Bed and Three-Phase Reactors, Korea, 103 (1998).
Uemaki, O., Yamada, R. and Kugo, M., “Particle Segregation in a Spouted Bed of Binary Mixtures of Particles,”Can. J. Chem, Eng.,61, 303 (1983).
Yoshida, K., Ji, H. and Tsutsumi, A., “Characteristics of Particle Circulation in a Spouted Bed with a Draft Tube,”AIChE Symp. Series No. 317,93,131 (1997).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Nagashima, H., Ishikura, T. & Ide, M. Hydrodynamics of a spouted bed with an impermeable draft tube for binary particle systems. Korean J. Chem. Eng. 16, 688–693 (1999). https://doi.org/10.1007/BF02708153
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF02708153