Abstract
The sensitivity and stability by frequency response of the final filament to several sinusoidal disturbances have been investigated in viscoelastic spinning by using various novel numerical algorithms. Amplitudes, or gains of the spinline cross-sectional area at the take-up, show resonant peaks, which are frequently encountered in hyperbolic systems. To effectively solve the complex system of the frequency response equation, alternative ways have been performed and compared. Interestingly, in the one-dimensional systems considered, integrating the linearized equations over the spinline length to shoot at the take-up boundary condition using two initial guesses (“two-shot” method) proved far more efficient than modal analysis using eigenfunction data or solving the matrix problem from the entire length by a direct method or an iterative one (GMRES). Also, the methodology to determine the stability of the system by using frequency response data, as suggested in Kase and Araki [1982], has been revamped to viscoelastic spinning system.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Chen, K. S., “Studies of Multilayer Slide Coating and Related Processes,” Ph.D. Thesis, University of Minnesota (1992).
Claeyssen, J. C. R., “On Predicting the Response of Non-Conservative Linear Vibrating Systems by Using Dynamical Matrix Solutions,”J. Sound & Vibr.,140, 73 (1990).
Devereux, B.M. and Denn, M. M., “Frequency Response Analysis of Polymer Melt Spinning,”Ind. Eng. Chem. Res.,33, 2384 (1994).
Fawzy, I. and Bishop, R. E.D., “On the Nature of Resonance in Non-Conservative Systems,”J. Sound & Vibr.,55, 475 (1977).
Fisher, R. J. and Denn, M. M., “A Theory of Isothermal Melt Spinning and Draw Resonance,”AIChE J.,22, 236 (1976).
Friedly, J. C., “Dynamic Behavior of Processes,” Prentice-Hall, Englewood Cliffs, New Jersey (1972).
Gates, I.D., “Slot Coating Flows: Feasibility, Quality,” Ph.D. Thesis, University of Minnesota (1999).
Gelder, D., “The Stability of Fiber Drawing Processes,”Ind. Eng. Chem. Fundam.,10, 534 (1971).
Hyun, J.C., “Theory of Draw Resonance: I. Newtonian Fluids,”AIChE J.,24, 418 (1978), also, “Part II. Power-law and Maxwell Fluids,”24, 423 (1978).
Jung, H.W., Choi, S. M. and Hyun, J. C., “Approximate Method for Determining the Stability of the Film-Casting Process,”AIChE J.,45, 1157 (1999a).
Jung, H.W., Song, H.-S. and Hyun, J. C., “Analysis of the Stabilizing Effect of Spinline Cooling in Melt Spinning,”J. Non-Newtonian Fluid Mech.,87, 165 (1999b).
Jung, H.W., Song, H.-S. and Hyun, J. C., “Draw Resonance and Kinematic Waves in Viscoelastic Isothermal Spinning,”AIChE J.,46, 2106 (2000).
Jung, H.W. and Scriven, L. E., “Simplified Modeling of Curtain Coating: Stability and Frequency Response,” The National AIChE Meeting, Reno, Nevada (2001).
Jung, H.W., Lee, J. S. and Hyun, J. C., “Sensitivity Analysis of Melt Spinning Process by Frequency Response,”Korea-Australia Rheol. J.,14, 57 (2002).
Kase, S., “Studies on Melt Spinning. IV. On the Stability of Melt Spinning,”J. Appl. Polym. Sci.,18, 3279 (1974).
Kase, S. and Araki, M., “Studies on Melt Spinning. VIII. Transfer Function Approach,”J. Appl. Polym. Sci.,27, 4439 (1982).
Kim, B.M., Hyun, J. C., Oh, J. S. and Lee, S. J., “Kinematic Waves in the Isothermal Melt Spinning of Newtonian Fluids,”AIChE J.,42, 3164 (1996).
Khan, S. A. and Larson, R. G., “Comparison of Simple Constitutive Equations for Polymer Melt in Shear and Biaxial and Uniaxial Extensions,”J. Rheol.,31, 207 (1987).
Kwon, Y. and Leonov, A. I., “Stability Constraints in the Formulation of Viscoelastic Constitutive Equations,”J. Non-Newtonian Fluid Mech.,58, 25 (1995).
Larson, R.G., “Instabilities in Viscoelastic Flows,”Rheol. Acta,31, 213 (1992).
Lee, J. S., Jung, H.W., Kim, S. H. and Hyun, J. C., “Effect of Fluid Viscoelasticity on the Draw Resonance Dynamics of Melt Spinning,”J. Non-Newtonian Fluid Mech.,99, 159 (2001).
Lee, J. S., Jung, H.W. and Hyun, J. C., “Frequency Response of Film Casting Process,”Korea-Australia Rheol. J.,15, 91 (2003a).
Lee, D.-Y., Lee, M., Lee, Y. and Park, S. “Mp Criterion Based Multiloop PID Controllers Tuning for Desired Closed Loop Responses,”Korean J. Chem. Eng.,20, 8 (2003b).
Liu, B. and Beris, A.N., “Time-dependent Fiber Spinning Equations. 2. Analysis of the Stability of Numerical Approximations,”J. Non-Newtonian Fluid Mech.,26, 363 (1988).
Park, I.-S., Kwak, C. and Hwang, Y.-G., “Frequency Response of Adsorption of a Gas onto Bidisperse Pore-Structured Solid with Modulation of Inlet Molar Flow-Rate,”Korean J. Chem. Eng.,18, 330 (2001).
Pearson, J. R.A. and Matovich, M.A., “Spinning a Molten Threadline: Stability,”Ind. Eng. Chem. Fundam.,8, 605 (1969).
Petrie, C. J. S., “Some Remarks on the Stability of Extensional Flows,” Progress and Trends in Rheology II, 9 (1988).
Saad, Y., “Numerical Methods for Large Eigenvalue Problems,” Manchester University Press, Manchester, U. K. (1992).
Saad, Y., “Iterative Methods for Sparse Linear Systems,” PWS Publishing Company, Boston (1996).
Saad, Y. and Schultz, M.H., “GMRES: A Generalized Minimal Residual Algorithm for Solving Nonsymmetric Linear Systems,”SIAM J. Sci. Stat. Comp.,7, 856 (1986).
Wahed, I. F.A. and Bishop, R.E.D., “On the Equations Governing The Free and Forced Vibrations of a General Non-Conservative System,”J. Mech. Eng. Sci.,18, 6 (1976).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Jung, H.W., Lee, J.S., Scriven, L.E. et al. The sensitivity and stability of spinning process using frequency response method. Korean J. Chem. Eng. 21, 20–26 (2004). https://doi.org/10.1007/BF02705376
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF02705376