Abstract
An axial dispersion of gas in a circulating fluidized bed was investigated in a fluidized bed of 4.0 cm I.D. and 279 cm in height. The axial dispersion coefficient of gas was determined by the stimulus-response method of trace gas of CO2. The employed particles were 0.069 mm and 0.147 mm silica-sand. The results showed that axial dispersion coefficients were increased with gas velocity and solid circulation rates as well as suspension density. The experimentally determined axial dispersion coefficients in this study were in the range of 1.0-3.5 m2/s.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
Abbreviations
- C(t):
-
concentration of tracer gas [voltage]
- Da :
-
axial dispersion coefficient [m2/sec]
- dp :
-
particle diameter [mm]
- Gs :
-
solid circulation rate [kg/m2·sec]
- Pe:
-
Peclet number [-]
- Ug :
-
fluidizing gas velocity [m/sec]
- ρsus :
-
suspension density [kg/m3]
References
Bai, D., Yi, J. and Yu, Z., “Residence Time Distributions of Gas and Solids in a Circulating Fluidized Bed”, Fluidization VII, Potter, O. E. and Nicklin, D. J., eds., Engineering Foundation, New York (1992).
Brereton, C. M., Grace, J. R. and Yu, J., “Axial Gas Mixing in a CFB” CFB Technology II, Basu, P. and Large, J. F., eds., Pergamon Press, New York (1988).
Cankurt, N T. and Yerushalmi, J., “Gas Backmixing in High Velocity Fluidized Beds”, Fluidization, Davison, J. F. and Keairns, D. L., eds., Cambridge Univ. Press, London (1978).
Cho, H. I., Chung, C. H., Han, G. Y., Ahn, G. R. and Kong, J. S., “Axial Gas Dispersion in a Fluidized Bed of Polyethylene Particles”,Korean J. Chem. Eng.,17, 292 (2000).
Gayan, P., Diego, L. F. and Adanez, J., “Radial Gas Mixing in a Fast Fluidized Bed”,Powder Technology,94, 163 (1997).
Kim, S. W., Ahn, J. Y., Lee, D. H. and Kim, S. D., “Continuous Measurement of Solids Flow in a Circulating Fluidized Bed”,Korean J. Chem. Eng.,18, 555 (2001).
Li, J. and Weinstein, H., “An Experimental Comparison of Gas Mixing in Fluidized Beds Across the Regime Spectrum”,Chem. Eng. Sci.,44, 1697 (1989).
Li, Y. and Wu, P., “A Study on Axial Gas Mixing in a Fast Fluidized Bed”, CFB Technology III, Basu, O., Horio, M. and Hasatani, M., eds., Pergamon Press, New York (1991).
Namung, W. and Kim, S.D., “Gas Backmixing in the Dense Region of a Circulating Fluidized Bed”,Korean J. Chem. Eng.,16, 456 (1999).
Patience, G. S. and Chaouki, J., “Gas Phase Hydrodynamics in the Riser of a Circulating Fluidized Bed”,Chem. Eng. Sci.,48, 3195 (1993).
Sterneus, J., Johnsson, E and Lecker, B., “Gas Mixing in Circulating Fluidized Bed Risers”,Chem. Eng. Sci.,55, 129 (2000).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Kim, J., Han, G. & Yi, C. Axial dispersion of gas in a circulating fluidized bed. Korean J. Chem. Eng. 19, 491–494 (2002). https://doi.org/10.1007/BF02697162
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF02697162