Abstract
According to the direct reading thermometric method the concentration of the component to be determined is established from the temperature variation of the sample solution obtained on adding to it an excess of a reagent which reacts selectively with the respective component. Under suitably chosen experimental conditions the concentration of the respective component is determined from a single measured value. Since the established measurement technique requires little manual work and the respective components may be determined from the sample solution directly without any separations, the method in its present form is chiefly suitable for rapid serial analyses.
Résumé
Selon la méthode thermométrique à lecture directe, on détermine la concentration du constituant cherché d'après la variation de température de la solution échantillon que l'on additionne d'un excès de réactif sélectif de celui-ci. Dans les conditions expérimentales appropriées, une seule mesure suffit pour déterminer la concentration du constituant cherché. Comme la technique de mesure qui a été mise au point demande peu de travail et comme on peut doser sans aucune séparation les constituants étudiés, la méthode dans sa forme actuelle se prête en premier lieu aux dosages en séries industriels.
Zusammenfassung
Bei der thermometrischen Methode mit Direktablesung wird die Konzentration der gesuchten Komponente aus der Temperaturänderung der Probelösung bestimmt, die nach Zugabe eines Überschusses von einem selektiv reagierenden Reagens wahrnehmbar ist.Unter geeigneten Versuchsbedingungen kann man die Konzentration der gesuchten Komponente aus einem einzigen Meßwert, nämlich der Temperaturänderung der Probelösung bestimmen. Da die ausgearbeitete Meßtechnologie wenig Arbeit erfordert und die gesuchten Komponenten ohne jede Trennung direkt bestimmt werden können, ist die Methode in ihrer jetzigen Ausführungsart hauptsächlich zu betriebsmäßigen Serien-Schnellanalysen geeignet.
Резюме
По термометрическом у методу визуального отсчета можно опреде лить концентрацию компонента измерени ем изменения темпера туры пробного раствора, по лученного добавлением к нему из бытка реагента, реаги рующего избирательно с иссле дуемым компонентом. При соот ветствующих условия х эксперимента концен трация компонента определяется однокр атным измерением. Изм ерение описанным методом тр ебует мало ручных операций. Можн о определить исследу емый компонент непосредс твенно, не выделяя его из пробного раств ора. В описанном виде м етод можно применять в лаборато риях при проведении серий ных анализов.
Article PDF
Similar content being viewed by others
Explore related subjects
Discover the latest articles, news and stories from top researchers in related subjects.Avoid common mistakes on your manuscript.
References
H. Howard: Chem. Zentralblatt, I (1910) 1452.
I. Sajó: Kohászati Lapok, 7 (1957) 287.
J. C. Wasilewski, P. T. S. Pey, I. Jordan: Anal. Chem., 36 (1964) 2131.
I. Sajó, J. Ujváry: Z. anal. Chem., 202 (1964) 177.
I. Sajó, B. Sipos: Z. anal. Chem., 222 (1966) 23.
I. Sajó, B. Sipos: Talanta, 14 (1967) 203.
L. H. Greathouse, H. J. Janssen, C. M. Haydel: Anal. Chem., 28 (1956) 257.
H. W. Linde, L. B. Rogers, D. M. Hume: Anal. Chem., 25 (1953) 404.
I. Sajó, B. Sipos: Mikrochim. Acta, (1967) 2, 248.
I. Sajó: Hungarian Scientific Instruments, 12 (1967) 1.
I. Sajó: Communications of the Research Institute of Ferrous Metallurgy, 2 (1965) 684.
I.Sajó: Dissertation (1965).
I. Sajó: Magy. Tud. Akad. Kém. Közlemény. 26 (1966) 119.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Sajó, I. Direct reading thermometric analysis. Journal of Thermal Analysis 1, 221–225 (1969). https://doi.org/10.1007/BF01909672
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF01909672