Abstract
Extensional rheological properties are important in characterization and processing of polymeric liquids. The use of entrance pressure drop to obtain extensional viscosity is particularly attractive because it can be applied to both low and high viscosity liquids using the Bagley correction obtained from a conventional capillary rheometer.
Low density polyethylene of three different melt index values, including IUPAC-X (a different batch of IUPAC-A), and a high density polyethylene were tested using a commercial capillary rheometer. The entrance pressure drop (ΛP en ) was obtained with a “zero-length” orifice die with an abrupt contraction. The contraction ratio was 12:1. Predictions from several approximate analyses to calculate the uniaxial extensional viscosity ηu (using an axisymmetric contraction) from ΔP en were compared. These comparisons are summarized in the appendices.
Due to the transient nature of contraction flows, η u is also a function of the strain (ɛ). This was examined by comparing η u from ΔP en (Cogswell's analysis was chosen for convenience) with transient extensional viscosity (η u +) at different magnitudes of ɛ from fiber-windup technique (Padmanabhan et al., 1996). η + u at ɛ≈ 3 was found to be close to η u from ΔP en (using Cogswell's analysis) for two LDPE samples that had fiber-windup data available. The magnitude of the strain in the contraction did not vary with strain rate.
Article PDF
Similar content being viewed by others
Explore related subjects
Discover the latest articles, news and stories from top researchers in related subjects.Avoid common mistakes on your manuscript.
References
Balakrishnan C, Gordon RJ (1976) Extensional flow of dilute polymer solutions. In: Klason C, Kubat J (eds) Proceedings of the VIIth International Congress on Rheology. Gothenberg, Sweden, pp 265–267
Banfill PFG (1991) Extensional viscosity determination for the test polymer solution A1. British Soc Rheol Bulletin 34:13–16
Binding DM (1988) An approximate analysis for contraction and converging flows. J Non-Newtonian Fluid Mech 27:173–189
Binding DM (1991) Further considerations of axisymmetric contraction flows. J Non-Newtonian Fluid Mech 41:27–42
Binding DM (1993) Contraction flows and new theories for estimating extensional viscosity. In: Collyer AA (ed) Techniques in rheological measurement. Chapman & Hall, New York, pp 1–32
Binding DM, Jones DM (1989) On the interpretation of data from converging flow rheometers. Rheol Acta 28:215–222
Binding DM, Walters K (1988) On the use of flow through a contraction in estimating the extensional viscosity of mobile polymer solutions. J Non-Newtonian Fluid Mech 30:233–250
Boger DV (1987) Viscoelastic flows through contractions. Ann Rev Fluid Mech 19:157–182
Cogswell FN (1972) Converging flow of polymer melts in extrusion dies. Polym Eng Sci 12:64–73
Cogswell FN (1978) Converging flow and stretching flow: A compilation. J Non-Newtonian Fluid Mech 4:23–38
Feigl K, Ottinger HC (1994) The flow of a LDPE melt through an axisymmetric contractions: A numerical study and comparison to experimental results. J Rheol 38:847–874
Ferguson J, Hudson NE (1993) Transient elongational rheology of polymeric fluids. Eur Polym J 29:141–147
Gibson AG (1988) Converging dies. In: Collyer AA, Clegg DW (eds) Rheological measurement. Elsevier Applied Science, London, pp 49–92
Gibson AG (1989) Die entry flows of reinforced polymers. Composites 20:57–64
James DF (1990) Extensional viscosity and its measurement. In: DeKee D, Kaloni PN (eds) Recent developments in structured continua, vol. 2. Wiley, New York
James DF, Walters K (1994) A critical appraisal of available methods for the measurement of extensional properties of mobile systems. In: Collyer AA (ed) Techniques in rheological measurement. Chapman & Hall, New York
Laun HM, Schuch H (1989) Transient elongational viscosities and drawability of polymer melts. J Rheol 33:119–175
Macosko CW (1994) Rheology: Principles, measurements, and applications. VCH, New York
McKinley GH, Raiford WP, Brown RA, Armstrong RC (1991) Nonlinear dynamics of viscoelastic flow in axisymmetric abrupt contractions. J Fluid Mech 223:411–456
Meissner J, Raible T, Stephenson SE (1981) Rotary clamp in uniaxial and biaxial extensional rheometry of polymer melts. J Rheol 25:1–28
Metzner AB, Metzner AP (1970) Stress levels in rapid extensional flows of polymeric fluids. Rheol Acta 9:174–181
Padmanabhan M (1992) In-line measurement of shear-elastic and extensional rheological material functions of food doughs. Ph. D. Dissertation, University of Minnesota (available from University Microfilms International, Ann Arbor, MI)
Padmanabhan M (1993) Evaluation of the entrance pressure drop method to estimate extensional viscosity. M.S. Thesis, Department of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis
Padmanabhan M, Bhattacharya M (1994) In-line measurement of rheological properties of polymer melts. Rheol Acta 33:71–87
Padmanabhan M, Kasehagen LJ, Macosko C (1996) Transient extensional viscosity from a rotational shear rheometer using fiber-windup technique. J Rheol 40:473–481
Tremblay B (1989) Estimation of the elongational viscosity of polyethylene blends at high deformation rates. J Non-Newtonian Fluid Mech 33:137–164
Walters K (1992) Recent developments in rheometry. In: Moldenaers P, Keunings R (eds) Theoretical and applied rheology, vol. 1. Elsevier, New York
White SA, Gotsis AD, Baird DG (1987) Review of the entry flow problem: Experimental and numerical. J Non-Newtonian Fluid Mech 24:121–160
Author information
Authors and Affiliations
Additional information
Dedicated to the memory of Tasos Papanastasiou
Rights and permissions
About this article
Cite this article
Padmanabhan, M., Macosko, C.W. & Padmanabhan, M. Extensional viscosity from entrance pressure drop measurements. Rheola Acta 36, 144–151 (1997). https://doi.org/10.1007/BF00366820
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF00366820