Abstract
The Accuracy of registration between positron emission tomography (PET) and computed tomography (CT) images is one of the important factors for reliable diagnosis in PET/CT examinations. Although quality control (QC) for checking alignment of PET and CT images should be performed periodically, the procedures have not been fully established. The aim of this study is to determine optimal quality control (QC) procedures that can be performed at the user level to ensure the accuracy of PET/CT registration. Two phantoms were used to carry out this study: the American college of Radiology (ACR)-approved PET phantom and National Electrical Manufacturers Association (NEMA) International Electrotechnical Commission (IEC) body phantom, containing fillable spheres. All PET/CT images were acquired on a Biograph TruePoint 40 PET/CT scanner using routine protocols. To measure registration error, the spatial coordinates of the estimated centers of the target slice (spheres) was calculated independently for the PET and the CT images in two ways. We compared the images from the ACR-approved PET phantom to that from the NEMA IEC body phantom. Also, we measured the total time required from phantom preparation to image analysis. The first analysis method showed a total difference of 0.636 ± 0.11 mm for the largest hot sphere and 0.198 ± 0.09 mm for the largest cold sphere in the case of the ACR-approved PET phantom. In the NEMA IEC body phantom, the total difference was 3.720 ± 0.97 mm for the largest hot sphere and 4.800 ± 0.85 mm for the largest cold sphere. The second analysis method showed that the differences in the x location at the line profile of the lesion on PET and CT were (1.33, 1.33) mm for a bone lesion, (−1.26, −1.33) mm for an air lesion and (−1.67, −1.60) mm for a hot sphere lesion for the ACR-approved PET phantom. For the NEMA IEC body phantom, the differences in the x location at the line profile of the lesion on PET and CT were (−1.33, 4.00) mm for the air lesion and (1.33, −1.29) mm for a hot sphere lesion. These registration errors from this study were reasonable compared to the errors reported in previous studies. Meanwhile, the total time required from phantom preparation was 67.72 ± 4.50 min for the ACR-approved PET phantom and 96.78 ± 8.50 min for the NEMA IEC body phantom. When the registration errors and the lead times are considered, the method using the ACR-approved PET phantom was more practical and useful than the method using the NEMA IEC body phantom.
Article PDF
Similar content being viewed by others
Explore related subjects
Discover the latest articles, news and stories from top researchers in related subjects.Avoid common mistakes on your manuscript.
References
R. Rakheja, L. DeMello and H. Chandarana, Ame. J. Roentgen. 201, 1120 (2013).
R. Shekhar, V. Walimbe and S. Raja, J. Nucl. Med. 46, 1488 (2005).
G. El Fakhri, R. Fulton and J. E. Gray, Quality assurance for PET and PET/CT systems (IAEA, Vienna, 2009), p. 40.
A. Rodríguez-Ruano, J. Pascau and J. Chamorro, 2008 IEEE Nuclear Science Symposium Conference Record (Madrid, Spain, November 14, 2008), p. 3832.
P. Zanzonico, J. Nucl. Med. 49, 1114 (2008).
ACR, PET phantom instructions for evaluation of PET image quality (ACR, USA, 2006), p. 3.
Y. S. Lee, J. S. Kim and K. M. Kim, Ann. Nucl. Med. 28, 340 (2014).
C. Cohade, M. Osman and L. T. Marshall, Eur. J. Nucl. Med. Imaging 30, 721 (2003).
T. Chang, G. Chang and J. W. Clark, Med. Phys. 39, 5891 (2012).
M. C. Baños-Capilla, M. A. García and J. Bea, Med. Phys. 34, 1911 (2007).
G. Akamatsu, K. Ishikawa and K. Mitsumoto, J. Nucl. Med. 53, 1716 (2012).
CPI Innovations, ECAT LSO PET/CT 16 with PICO 3D Operator’s Guide (CPS Innovations, Tennessee, USA, 2003).
E. B. Sokole, A. Píachcínska and A. Britten, Eur. J. Nucl. Med. Imaging 37, 662 (2010).
General Electric Company, Optima 560, Discovery 600, 690 Elite PET/CT Service Manual (GE Healthcare, USA, 2013), p. 134.
L. Sing, Int. J. Radiat. Oncol. Biol. Phys. 71, S38 (2008).
A. Isambert, G. Bonniaud and F. Lavielle, Cancer/ Radiotherapie 12, 800 (2008).
M. Sharpe and K. K. Brock, Int. J. Radiation Oncology Biol. Phys. 71, S33 (2008).
Y. Watanabe and E. Y. Han, J. Neurosurg. 109, 21 (2008).
W. V. Vogela, J. A. van Dalena and D. A. X. Schinagl, Nucl. Med. Commun. 27, 515 (2006).
K. J. Nichols, S. L. Bacharach and S. R. Bergmann, J. Nucl. Cardiol. 13, 25 (2006).
A. H. Ng, K. H. Ng and H. Dharmendra, App. Rad. and Isotop. 67, 1864 (2009).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Cha, M.K., Ko, H.S., Jung, W.Y. et al. A comparative study between evaluation methods for quality control procedures for determining the accuracy of PET/CT registration. Journal of the Korean Physical Society 67, 574–580 (2015). https://doi.org/10.3938/jkps.67.574
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3938/jkps.67.574