Abstract
Research shows that, in the machining of plane surfaces and mating contours by opposed end mills, the mill diameter must be taken into account in selecting the cutting depth so as to improve the machining precision.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Ignatov, M.G., Babin, S.V., and Perminov, A.E., Variation in the vertical cutting force in opposed milling, Vestn. Mashinostr., 2006, no. 1, pp. 75–76.
Ignatov, M.G., Perminov, A.E., and Prokof’ev, E.Yu., Influence of the vertical cutting force on the surface precision and roughness in opposed milling, Russ. Eng. Res., 2008, vol. 28, no. 9, pp. 864–865.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © A.E. Perminov, S.V. Babin, E.Yu. Prokof’ev, 2017, published in Vestnik Mashinostroeniya, 2017, No. 12, pp. 57–58.
About this article
Cite this article
Perminov, A.E., Babin, S.V. & Prokof’ev, E.Y. Machining with End Mills. Russ. Engin. Res. 38, 180–181 (2018). https://doi.org/10.3103/S1068798X18030164
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X18030164