Abstract
The oxidation of K3[MoCl6] with air oxygen in aqueous solutions of HX (X = Cl, Br) in the presence of n-tetrabutylammonium salts affords mononuclear heteroligand complexes (Bu4N)[MoOCl4(H2O)] (I) and (Bu4N)[MoOBr4(H2O)] (II). The complexes are characterized by X-ray diffraction analysis (СIF files CCDC nos. 1812657 (I) and 1812658 (II).
Similar content being viewed by others
Avoid common mistakes on your manuscript.
INTRODUCTION
The most part of low-valence molybdenum halide complexes known today are clusters [1–4]. The exception is the Mo(III) derivatives: the majority of structurally characterized compounds of this type are mononuclear ([MoX6]3–) (X = Cl, Br, I) [5–9]. Single examples of the bi- and trinuclear complexes are also known [10–12]. Although this class of compounds has been known long ago, their chemical properties are studied rather weakly. Based on the general concepts of the chemistry of halometallates [13–15], one can assume the ability of [MoX6]3– to act as “building blocks” for the synthesis of heterometallic complexes of higher nuclearity.
The initial purpose of this work was to obtain tetrabutylammonium salts [MoX6]3– (X = Cl, Br) that are hypothetically highly soluble in polar organic solvents, which would allow us to use them for the synthesis of heterometallic derivatives. We found that the exchange reactions K3[MoCl6] + tetrabutylammonium salt in solutions of HX (X = Cl, Br) in air did not give desirable products: in the presence of air oxygen, [MoX6]3– undergoes oxidation to form the mononuclear heteroligand complexes of Mo(V). Salts (Bu4N)[MoOCl4(H2O)] (I) and (Bu4N)[MoOBr4(H2O)] (II) were also isolated and structurally characterized.
EXPERIMENTAL
The reactions were carried out in air. The starting reagents (HCl, HBr, and tetrabutylammonium chloride and bromide) were purchased from commercial sources and used as received. Salt K3[MoCl6] were prepared according to a previously published procedure [16].
Synthesis of complex I. A weighed sample of K3[MoCl6] (100 mg, 0.23 mmol) was dissolved on heating (70°С) in concentrated HCl (5 mL). A dark red solution was gradually formed, and an excess of Bu4NCl (326 mg, 1.2 mmol) in H2O (3 mL) was added. The resulting mixture was cooled down to room temperature and kept for 24 h at 6°С. Green crystals of compound I were formed, filtered off, and dried in air. The yield was 89% (based on Mo).
For C16H38NO2Cl4Mo | |||
Anal. calcd., % | C, 37.4 | H, 7.4 | N, 2.7 |
Found, % | C, 37.2 | H, 7.5 | N, 2.7 |
Synthesis of complex II was carried out similarly to compound I using HBr instead of HCl and Bu4NBr instead of Bu4NCl (378 mg in 3 mL of H2O). Yellow-brown crystals of compound II were formed. The yield was 91% (based on Мо).
For C16H38Br4NO2Mo | |||
Anal. calcd., % | C, 27.8 | H, 5.5 | N, 2.0 |
Found, % | C, 27.6 | H, 5.6 | N, 2.0 |
X-ray diffraction analysis. The structures of compounds I and II were determined using a standard procedure on an Xcalibur (Agilent Technologies) diffractometer at 130 K (MoKα, λ = 0.71073 Å, graphite monochromator). The reflection intensities were measured using φ scan of narrow (0.5°) frames. An absorption correction was applied using the SCALE3 ABSPACK algorithm [17]. The structures were solved by a direct method and refined by full-matrix least squares in the anisotropic (for non-hydrogen atoms) approximation using the SHELX 2017/1 algorithm [18] in the ShelXle program package [19]. The coordinates of the hydrogen atoms of the coordinated water molecule in the crystal structure of compound I were found experimentally and refined with the thermal parameter –1.2. In the crystal structure of complex II, the {OMo(H2O)} group is orientationally disordered due to location on the crystallographic axis 4. Therefore, the direct localization of the hydrogen atoms of the coordinated water molecule is impossible. The crystallographic data and the results of refinement for the structures of compounds I and II are presented in Table 1.
The coordinates of atoms and other parameters of the structures were deposited with the Cambridge Crystallographic Data Centre (CIF files CCDC nos. 1812657 (I) and 1812658 (II); deposit@ccdc. cam.ac.uk or http://www.ccdc.cam.ac.uk/data_request/cif).
RESULTS AND DISCUSSION
It has earlier been mentioned that the Mo(III) halide complexes in solutions in the presence of air oxygen are unstable. For example, trinuclear (PPh4)3[Mo3I12] undergoes oxidation to form (PPh4)[MoOI4] in a yield of 50% for 5 h [20]. A similar behavior was observed for the binuclear Mo(II) carboxylates in solutions of HX [21]. Thus, the formation of compounds I and II cannot be considered unusual. It is most likely that the tetrabutylammonium salts [MoX6]3– should be prepared by the reaction in an inert atmosphere.
According to the data in the Cambridge Structural Database, the most number of compounds containing an anion of the [MoOX4(H2O)]– type was described for X = Cl (16, including the monoclinic polymorphous modification of (Bu4N)[MoOCl4(H2O)] [22]), whereas the bromide and iodide complexes are presented to a lower extent (8 [21, 23–28] and 2 [21, 29], respectively). The structure of the anionic moieties of complexes I and II (including the Mo–O and Mo–X bond lengths, where X = Cl, Br; Table 2) is consistent with published data. In both cases, the coordination sphere of Mo(V) is a strongly distorted octahedron. In the case of complex I, the Cl···H–C contacts play a substantial role in crystal packing formation. Some types of Cl···H–C contacts are shown in Fig. 1. The difference in energies of these interactions leads to the appearance of two types of intermolecular Мо–Мо distances along the crystallographic axis с: 9.5 and 9.3 Å, respectively. The crystal packing of complex I is shown in Fig. 2. The orientational disordering of the {OMo(H2O)} fragment is observed in the structure of compound II (Fig. 3).
REFERENCES
Stewart, D.F. and O’Donnell, T.A., Science, 1966, vol. 210, p. 836.
Johnston, D.H., Stern, C.L., and Shriver, D.F., Inorg. Chem., 1993, vol. 32, p. 5170.
Ramirez-Tagle, R. and Arratia-Perez, R., Chem. Phys. Lett., 2009, vol. 45, p. 232.
Bain, R.L., Shriver, D.F., and Ellis, D.E., Inorg. Chim. Acta, 2001, vol. 325, р. 171.
Bartalucci, N., Bortoluzzi, M., Marchetti, F., et al., New J. Chem., 2017, vol. 41, p. 4329.
Cotton, F.A. and Vidyasagar, F., Polyhedron, 1995, vol. 14, p. 3077.
Kazin, P.E., Bel’skii, V.K., Zhirov, A.I., et al., Russ. J. Inorg. Chem., 1985, vol. 30, p. 1426.
Spitsyn, V.I., Kazin, P.E., Felin, M.G., et al., Russ. J. Inorg. Chem., 1987, vol. 32, p. 2392.
Herbowski, A. and Lis, T., Polyhedron, 1985, vol. 4, p. 127.
Fettinger, J.C., Gordon, J.C., Mattamana, S.P., et al., Inorg. Chem., 1996, vol. 35, p. 7404.
Atwood, J.L. and Junk, P.C., J. Coord. Chem., 2000, vol. 51, p. 379.
Spitsin, V.I., Kazin, P.E., Subbotin, M.Yu., et al., Dokl. Akad. Nauk SSSR, 1986, vol. 287, p. 134.
Sevastianiova, T.N., Davydova, E.I., Kazakov, I.V., et al., Russ. Chem. Bull., 2015, vol. 64, p. 2523.
Torubaev, Y., Pasynskii, A., and Mathur, P., Coord. Chem. Rev., 2012, vol. 256, p. 709.
Davydova, E.I., Sevastianova, T.N., Suvorov, A.V., et al., Coord. Chem. Rev., 2010, vol. 254, p. 2031.
Handbuch der Präparativen Inorganische Chemie, Brauer, G., Ed., Stuttgart: Ferdidand Enke, 1981, vol. 5.
CrysAlisPro. Agilent Technologies. Version 1.171.37.35 (release 13-08-2014 CrysAlis171. NET).
Sheldrick, G.M., Acta Crystallogr., Sect C: Struct. Chem., 2015, vol. 71, p. 3.
Hübschle, C.B., Sheldrick, G.M., Dittrich, B., J. Appl. Crystallogr., 2011, vol. 44, p. 1281.
Gordon, J.C., Mattamana, S.P., and Poli, R., Polyhedron, 1995, vol. 14, p. 1339.
Bino, A. and Cotton, F.A., Inorg. Chem., 1979, vol. 18, p. 2710.
Wu, C.-D., Zhang, Q.-Z., Lu, C.-Z., et al., Acta Crystallogr., Sect. E: Struct. Rep. Online, 2001, vol. 57, p. m511.
Chivu, H., Braun, B., Micu, O., et al., Rev. Chim., 2011, vol. 62, p. 283.
Honzicek, J., Mukhopadhay, A., Santos-Silva, T., et al., Organometallics, 2009, vol. 28, p. 2871.
Sergienko, V.S., Minacheva, L.K., Sagikov, G.G., et al., Russ. J. Inorg. Chem., 1992, vol. 37, p. 346.
Neumann, R. and Assael, I., J. Chem. Soc., Chem. Commun., 1989, p. 547.
Scane, J.G., Acta Crystallogr., 1967, vol. 23, p. 85.
Mohammed, A.K., Fronczek, F.R., and Maverick, A.W., Inorg. Chim. Acta., 1994, vol. 226, p. 25.
Fettinger, J.C., Mattamana, S.P., and Poli, R., Acta Crystallpgr., Sect. C: Cryst. Struct. Commun., 1998, vol. 54, p. 184.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by E. Yablonskaya
Rights and permissions
About this article
Cite this article
Adonin, S.A., Udalova, L.I., Abramov, P.A. et al. Mononuclear Molybdenum Oxohalide Complexes (Bu4N)[MoOCl4(H2O)] and (Bu4N)[MoOBr4(H2O)]: Synthesis and Crystal Structures. Russ J Coord Chem 44, 673–677 (2018). https://doi.org/10.1134/S1070328418110015
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S1070328418110015