Abstract
The elastic hysteresis and residual deflections of samples made of steel 20, which correspond to the model of a thin rigid round plate pinched over the contour, have been investigated. It has been shown that annealing of the samples at 470 and 670 K weakly affects these characteristics, while after complete annealing (1170 K), the aging of steel 20 for three days is accompanied by a decrease in amplitude ωh of the elastic hysteresis by ∼20%. A postulate that there is no elasticity limit of metals, below which residual deformation would be absent, has been confirmed experimentally. It has been shown that, based on the values of ω h , the ultimate strength of metals can be estimated acting on the samples by stresses smaller than the yield stress by an order of magnitude. A giant increase (by a factor of ∼2.5) in ω h has been found after a prolonged (for 2 months) aging of steel 20 after the diffusion of hydrogen from it, which indicates the corresponding decrease in its cyclic longevity.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
B. G. Mytsyk, Ya. P. Kost’, and N. M. Demyanyshyn, Phys. Solid State 56(11), 2227 (2014).
B. G. Mytsyk and N. M. Demyanyshyn, Fiz. Khim. Mekh. Mater. 45(3), 83 (2009).
G. S. Pisarenko, A. P. Yakovlev, and V. V. Matveev, in Handbook on Resistance of Materials, Ed. by G. S. Pisarenko (Naukova Dumka, Kiev, 1988) [in Russian].
Yu. Yu. Zhiguts, Metallurgiya 2(30), 48 (2013).
M. N. Ruditsyn, P. Ya. Artemov, and M. I. Lyuboshits, in Reference Book on Resistance of Materials, Ed. by M. N. Ruditsyn (Vyshaya Shkola, Minsk, 1970) [in Russian].
G. S. Pisarenko, V. A. Agarev, A. L. Kvitka, V. G. Popkov, and E. S. Umanskii, Resistance of Materials (Vyshcha Shkola, Kiev, 1986) [in Russian].
O. A. Ageev, V. M. Mamikonova, V. V. Petrov, V. N. Kotov, and O. N. Negodenko, Microelectronic Transducers Non-Electrical Quantities (Taganrog State Radio Engineering University, Taganrog, 2000) [in Russian].
T. A. Obolenskaya, L. A. Evsyukova, V. I. Lazarenko, and N. V. Sereda, Mashinostroenie 6, 143 (2010).
R. K. Mozberg, Materials Science (Vysshaya Shkola, Moscow, 1991) [in Russian].
Yu. M. Lakhtin, Metallography and Heat Treatment of Metals (Metallurgiya, Moscow, 1983) [in Russian].
B. S. Natapov, Heat Treatment of Metals (Vyshcha Shkola, Kiev, 1980) [in Russian].
V. G. Zubchaninov, Fundamentals of the Theory of Elasticity and Plasticity (Vysshaya Shkola, Moscow, 1990) [in Russian].
V. T. Troshchenko, Deformation and Fracture of Metals under Multicycle Loading (Naukova Dumka, Kiev, 1981) [in Russian].
Z. T. Nazarchuk, V. R. Skal’s’kyi, B. P. Klym, V. P. Rudavs’kyi, P. P. Velykyi, and Ya. P. Tolopko, Mater. Sci. 45, 665 (2009).
T. Michler and J. Naumann, Int. J. Hydrogen Energy 35, 1485 (2010).
A. N. Chukanov and A. A. Yakovenko, Kondens. Sredy Mezhfaznye Granitsy 14, 100 (2012).
I. M. Dmytrakh, R. L. Leshchak, A. M. Syrotyuk, and O. L. Lutyts’kyi, Fiz. Khim. Mekh. Mater. 50(2), 16 (2014).
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © B.G. Mytsyk, Ya.P. Kost’, B.I. Turko, G.I. Gas’kevich, 2015, published in Fizika Tverdogo Tela, 2015, Vol. 57, No. 8, pp. 1539–1543.
Rights and permissions
About this article
Cite this article
Mytsyk, B.G., Kost’, Y.P., Turko, B.I. et al. Mechanical properties of steel 20 at small deformations. Phys. Solid State 57, 1569–1573 (2015). https://doi.org/10.1134/S106378341508020X
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S106378341508020X