Abstract
Concrete-filled double-skin steel tube (CFDST) attracts attention from researchers for it exhibits high strength, good ductility and energy dissipation capacity. In this paper, CFDST frame with beam-only-connected precast reinforced concrete shear wall system is proposed, and all the joints used high-strength bolt connection to realize fully-prefabricated construction. Three specimens were tested to obtain the seismic performance and cooperative mechanism of such proposed systems, and the contribution of beam-only-connected precast reinforced concrete shear wall (BRW) was quantified by comparing the results of these specimens. The results show that: (1) the BRW cooperated well with the CFDST frames, and it significant enhanced the lateral stiffness and strength of the CFDST frame; (2) all specimens tolerated more than 4% inter-story drift ratio, indicating that the specimens have good lateral deformation capacity; (3) the specimen with two pieces of BRW (BF-BRW-B) exhibited better ductility ratio by comparing with the specimen without BRW (BF) and with only one piece of BRW (BF-BRW-A); (4) relative brittle failure was occurred on the BRW in BF-BRW-A due to the shear force, which resulted in significant strength degradation and ductility reduction of the specimen, but two BRWs in BF-BRW-B could mitigate such situations. Lastly, equations were proposed to predict the lateral resistance of the test specimens.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
L.H. Han, W. Li, R. Bjorhovde, Developments and advanced applications of concrete-filled steel tubular (CFST) structures: members, Journal of Constructional Steel Research 100 (2014) 211–228.
L.H. Han, H. Huang, Z. Tao, X.L. Zhao, Concrete-filled double skin steel tubular (CFDST) beam-columns subjected to cyclic bending, Engineering Structures 28 (12) (2006) 1698–1714.
Y.F. Zhang, J.H. Zhao, W.F. Yuan, Study on compressive bearing capacity of concrete-filled square steel tube column reinforced by circular steel tube inside, Journal of Civil Engineering and Management 19 (2013) 787–795.
M.F. Hassanein, O.F. Kharoob, L. Gardner, Behavior and design of square concrete-filled double skin tubular columns with inner circular tubes, Engineering Structures 100 (2015) 410–424.
Y.H. Wang, G.B. Lu, X.H. Zhou, Experimental study of the cyclic behavior of concrete-filled double skin steel tube columns subjected to pure torsion, Thin-walled Structures 122 (2018) 425–438.
K. Uenaka, Concrete filled double skin tubular deep beam having outer circular and inner square sections under bending-shear, Structures 14 (2018) 313–321.
M. Ahmed, Q.Q. Liang, V.I. Patel, M.N.S. Hadi, Nonlinear analysis of rectangular concrete-filled double steel tubular short columns incorporating local buckling, Engineering Structures 175 (2018) 13–26.
L.H. Han, W.D. Wang, X.L. Zhao, Behaviour of steel beam to concrete-filled SHS column frames: finite element model and verifications, Engineering Structures 30 (2008) 1647–1658.
K.C. Tsai, P.C. Hsiao, K.J. Wang, Y.T. Weng, M.L. Lin, K.C. Lin, C.H. Chen, J.W. Lai, S.L. Lin, Pseudo-dynamic tests of a fullscale CFT/BRB frame—Part I: Specimen design, experiment and analysis, Earthquake Engineering and Structural Dynamic 37 (7) (2008) 1081–1098.
J.M. Castro, A.Y. Elghazouli, B.A. Izzuddin, Modeling of the panel zone in steel and composite moment frames, Engineering Structures 27 (2013) 129–144.
KA. Skalomenos, G.D. Hatzigeorgiou, D.E. Beskos, Modeling level selection for seismic analysis of concrete-filled steel tube/moment-resisting frames by using fragility curves, Earthquakes Engineering and Structural Dynamics 44 (2015) 199–220.
J.F. Wang, J.X. Wang, H.T. Wang, Seismic behavior of blind bolted CFST frames with semi-rigid connections, Structures 9 (2017) 91–104.
F.X. Ding, G.A. Yin, L.Z. Jiang, Y. Bai, Composite frame of circular CFST column to steel-concrete composite beam under lateral cyclic loading, Thin-walled Structures 122 (2018) 137–146.
L.H. Guo, R. Li, S.M. Zhang, Cyclic behavior of SPSW and CSPSW in composite frame, Thin-walled Structures 51 (2012) 39–52.
Y.F. Zhang, J.H. Zhao, C.S. Cai, Seismic behavior of ring beam joints between concrete-filled twin steel tubes columns and reinforced concrete beams, Engineering Structures 39 (2012) 1–10.
Y.F. Zhang, D.F. Zhang, Experimental study on the seismic behaviour of the connection between concrete-filled twin steel tubes column and steel beam, European Journal of Environmental and Civil Engineering 19 (3) (2015) 347–365.
Y. Hu, J.H. Zhao, D.F. Zhang, Y.F. Zhang, Seismic risk assessment of concrete-filled double-skin steel tube/ moment-resisting frames, Earthquakes and Structures 14 (3) (2018) 249–259.
Y. Hu, J.H. Zhao, D.F. Zhang, C. Chen, Experimental seismic performance of concrete-filled double-skin steel tube moment-resisting frames with different construction details, Journal of Constructional Steel Research (2018) (under review).
J.H. Ye, L.Q. Jiang, Collapse mechanism analysis of a steel moment frame based on structural vulnerability theory, Archives of Civil and Mechanical Engineering 18 (3) (2018) 833–843.
A. Dall’Asta, G. Leoni, F. Morelli, W. Salvatore, A. Zona, An innovative seismic-resistant steel frame with reinforced concrete infill walls, Engineering Structures 141 (2017) 144–158.
S.J. Hashemi, J. Razzaghi, A.S. Moghadam, P.B. Lourenco, Cyclic testing of steel frames infilled with concrete sandwich panels, Archives of Civil and Mechanical Engineering 18 (2) (2018) 557–572.
G.H. Sun, Q. Gu, Q.C. Li, Y.Z. Fang, Experimental and numerical study on the hysteretic behavior of composite partially restrained steel frame-reinforced concrete infill walls with vertical slits, Bulletin of Earthquake Engineering 16 (3) (2018) 1245–1272.
B. Qu, M. Bruneau, Design of steel plate shear walls considering boundary frame moment resisting action, Journal of Structural Engineering 135 (2009) 1511–1521.
P.M. Clayton, J.W. Berman, L.N. Lowes, Seismic performance of self-centering steel plate shear walls with beam-only-connected web plates, Journal of Constructional Steel Research 106 (2015) 198–208.
L.Q. Jiang, H. Zheng, Y. Hu, Experimental seismic performance of steel- and composite steel-panel wall strengthened steel frames, Archives of Civil and Mechanical Engineering 17 (3) (2017) 520–534.
R.S. Ju, H.J. Lee, C.C. Chen, C.C. Tao, Experimental study on separating reinforced concrete infill walls from steel moment frames, Journal of Constructional Steel Research 71 (4) (2012) 119–128.
L.Q. Jiang, H. Zheng, Y. Hu, Seismic behaviour of a steel frame partially infilled with precast reinforced concrete wall, Advances in Structural Engineering 19 (10) (2016) 1637–1649.
Y. Ozcelik, P.M. Clayton, Behavior of columns of steel plate shear walls with beam-connected web plates, Engineering Structures 172 (2018) 820–832.
B. Shekastehband, A.A. Azaraxsh, H. Showkati, Experimental and numerical study on seismic behavior of LYS and HYS steel plate shear walls connected to frame beams only, Archives of Civil and Mechanical Engineering 17 (2017) 154–168.
L.H. Guo, Q. Rong, B. Qu, J.P. Liu, Testing of steel plate shear walls with composite columns and infill plates connected to beams only, Engineering Structures 136 (2017) 165–179.
L.Q. Jiang, H. Zheng, Y. Hu, Effects of various uncertainties on seismic risk of steel frame equipped with steel panel wall, Bulletin of Earthquake Engineering 16 (12) (2018) 5995–6012.
JGJ 101, Specification of Testing Methods for Earthquake Resistant Building, Chinese Architecture & Building Press, Beijing, China, 1996.
GB 50010, Code for Design for Concrete Structures, Architecture & Building Press, China, 2010.
FEMA 356, NEHRP Guidelines for the Seismic Rehabilitation of Buildings, Federal Emergency Management Agency, Washington (DC), 2000.
GB 50011, Code for Seismic Design of Buildings, Chinese Architecture & Building Press, Beijing, China, 2010.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Hu, Y., Zhao, J., Zhang, D. et al. Seismic behavior of concrete-filled double-skin steel tube/moment-resisting frames with beam-only-connected precast reinforced concrete shear walls. Archiv.Civ.Mech.Eng 19, 967–980 (2019). https://doi.org/10.1016/j.acme.2019.04.009
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1016/j.acme.2019.04.009