Abstract
Positioning drag anchors in seabed soils are strongly influenced not only by the properties of the anchor and soil, but also by the characteristics of the installation line. The investigation on the previous prediction methods related to anchor positioning demonstrates that the prediction of the anchor position during dragging has inevitably introduced some key and unsubstantiated hypotheses and the applicability of these methods is limited. In the present study, the interactional system between the drag anchor and installation line is firstly introduced for the analysis of anchor positioning. Based on the two mechanical models for embedded lines and drag anchors, the positioning equations for drag anchors have been derived both for cohesive and noncohesive soils. Since the drag angle at the shackle is the most important parameter in the positioning equations, a novel analytical method that can predict both the variation and the exact value of the drag angle at the shackle is proposed. The analytical method for positioning drag anchors which combines the interactional system between the drag anchor and the installation line has provided a reasonable theoretic approach to investigate the anchor behaviors in soils. By comparing with the model flume experiments, the sensitivity, effectiveness and veracity of the positioning method are well verified.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Aubeny, C. P., Kim, B. M. and Murff, J. D., 2005. Proposed upper bound analysis for drag embedment anchors in soft clay, Proc. Int. Symp. Front. Offshore Geotech., ISFOG 2005, London, Taylor & Francis Group, 179–183.
Aubeny, C. P. and Murff, J. D., 2005. Suction Caissons and Vertical Loaded Anchors: Design Analysis Method, Final Report, Texas A & M University.
Aubeny, C. P., Murff, J. D. and Kim, B. M., 2008. Prediction of anchor trajectory during drag embedment in soft clay, Int. J. Offshore Polar Eng., 18(4): 314–319.
Dahlberg, R., 1998. Design procedures for deepwater anchors in clay, Proc. 30th Annual Offshore Tech. Conf., Houston, OTC 8837.
Degenkamp, G. and Dutta, A., 1989. Soil resistances to embedded anchor chain in soft clay, J. Geotech. Eng., 115(10): 1420–1438.
Det Norshke Veritas (DNV), 2000. Design and Installation of Fluke Anchors in Clay, DNV RP E301, Oslo, Det Norshke Veritas.
Kim, B. M., 2005. Upper Bound Analysis for Drag Anchors in Soft Clay, Ph. D. Thesis, Texas A & M University.
LeLievre, B. and Tabatabaee, J., 1979. Holding capacity of marine anchors in sand, Proceedings of the 1st Canadian Conference on Marine Geotechnical Engineering, Calgary, 301–311.
LeLievre, B. and Tabatabaee, J., 1981. The performance of marine anchors with planar flukes in sand, Can. Geotech. J., 18(4): 520–534.
Li, Y., 2010. Reverse Catenary Equations of Drag Lines and Application to the Kinematic Model of Drag Anchors, M. S. Thesis, Tianjin University. (in Chinese)
Liu, H. X., Zhang, W., Zhang, X. W. and Liu, C. L., 2010. Experimental investigation on the penetration mechanism and kinematic behavior of drag anchors, Appl. Ocean Res., 32(4): 434–442.
Liu, H. X., Liu, C. L., Yang, H. T., Li, Y., Zhang, W. and Xiao, Z. J., 2012a. A novel kinematic model for drag anchors in seabed soils, Ocean Eng., 49, 33–42.
Liu, H. X., Zhang, W., Liu, C. L. and Hu, C., 2012b. Movement direction of drag anchors in seabed soils, Appl. Ocean Res., 34, 78–95.
Miedema, S. A., Lagers, G. H. G. and Kerkvliet, J., 2007. An overview of drag embedded anchor holding capacity for dredging and offshore applications, Proceedings of the 18th World Dredging Congress, Orlando, 1–28.
Murff, J. D., Randolph, M. F., Elkhatib, S., Kolk, H. J., Ruinen, R. M., Strom, P. J. and Thorne, C. P., 2005. Vertically loaded plate anchors for deepwater applications, Proceedings of International Symposium on Frontiers in Offshore Geotechnics, ISFOG 2005, London, Taylor & Francis Group, 31–48.
Naval Civil Engineering Laboratory (NCEL), 1987. Drag Embedment Anchors for Navy Moorings, Techdata Sheet 83-08R (NCEL 83-08R), California, USA.
Neubecker, S. R. and Randolph, M. F., 1995. Profile and frictional capacity of embedded anchor chains, J. Geotech. Eng., 121(11): 797–803.
Neubecker, S. R. and Randolph, M. F., 1996a. The performance of drag anchor and chain system in cohesive soil, Mar. Geores. Geotechnol., 14(2): 77–96.
Neubecker, S. R. and Randolph, M. F., 1996b. The static equilibrium of drag anchors in sand, Can. Geotech. J., 33(4): 574–583.
Neubecker, S. R. and Randolph, M. F., 1996c. The kinematic behavior of drag anchors in sand, Can. Geotech. J., 33(4): 584–594.
O’Neill, M. P. and Randolph, M. F., 2001. Modelling drag anchors in a drum centrifuge, Int. J. Phys. Model Geotech., 1(2): 29–41.
O’Neill, M. P., Bransby, M. F. and Randolph, M. F., 2003. Drag anchor fluke-soil interaction in clays, Can. Geotech. J., 40(1): 78–94.
Ruinen, R. M., 2004. Penetration analysis of drag embedment anchors in soft clay, Proc. 14th Int. Offshore Polar Eng. Conf., ISOPE, Toulon, 531–537.
Skempton, A. W., 1951. The bearing capacity of clays, Proceedings of the Building Research Congress, London, 180–189.
Stewart, W. P., 1992. Drag embedment anchor performance prediction in soft soils, Proc. 24th Annual Offshore Tech. Conf., Houston, OTC 6970.
Terzaghi, K. and Peck, R. B., 1967. Soil Mechanics in Engineering Practice, Hoboken, John Wiley and Sons.
Thorne, C. P., 1998. Penetration and load capacity of marine drag anchors in soft clay, J. Geotech. Geoenviron. Eng., 124(10): 945–953.
Vivatrat, V., Valent, P. J. and Ponterio, A. A., 1982. The influence of chain friction on anchor pile design, Proc. 14th Annual Offshore Tech. Conf., Houston, 153–163.
Vryhof Anchors, 2005. Anchor Manual, Zuid-Holland, Krimpen ad Yssel.
Zhang, W., 2011. Penetration Mechanism and Kinematic Behavior of Drag Anchor, Ph. D. Thesis, Tianjin University.
Zhang, W., Liu, H. X., Zhou, H. F. and Sheng, Z. G., 2011. A new technique to measure the trajectory of drag anchors in soils, Geotech. Test. J., 34(4): 279–287.
Author information
Authors and Affiliations
Corresponding author
Additional information
This paper was financially supported by the National Basic Research Program of China (973 Program, Grant No. 2009CB219507), the National Natural Science Foundation of China (Grant Nos. 50639030 and 50979070), and the National Science and Technology Major Project of China (Grant Nos. 2011ZX05056-002 and 2011ZX05026-004).
Rights and permissions
About this article
Cite this article
Zhang, W., Liu, Hx., Li, Xz. et al. An analytical method for positioning drag anchors in seabed soils. China Ocean Eng 29, 49–64 (2015). https://doi.org/10.1007/s13344-015-0004-4
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s13344-015-0004-4