Abstract
The damping properties of an Mg alloy foam and its composite foams were investigated using a dynamic mechanical thermal analyzer. The results show that the loss factors of both the Mg alloy and its composite foams are insensitive to temperature and loading frequency when the temperature is less than a critical temperature T crit. However, it increases when the temperature exceeds the T crit values, which are 200 and 250°C for the Mg alloy foam and the Mg alloy/SiCp composite foams, respectively. The Mg alloy/SiCp composite foams exhibit a higher damping capacity than the Mg alloy foam when the temperature is below 200°C. By contrast, the Mg alloy foam exhibits a better damping capacity when the temperature exceeds 250°C. The variation in the damping capacity is attributed to differences in the internal friction sources, such as the characteristics of the matrix material, abundant interfaces, and interfacial slipping caused by SiC particles, as well as to macrodefects in the Mg alloy and its composite foams.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
J.H. Gu, X.N. Zhang, Y.F. Qiu, and M.Y. Gu, Damping behaviors of magnesium matrix composites reinforced with Cu-coated and uncoated SiC particulates, Compos. Sci. Technol., 65(2005), No. 11-12, p. 1736.
K.K. Deng, J.C. Li, K.B. Nie, X.J. Wang, and J.F. Fan, High temperature damping behavior of as-deformed Mg matrix influenced by micron and submicron SiCp, Mater. Sci. Eng. A, 624(2015), p. 62.
X.H. Liu, H.Y. Huang, and J.X. Xie, Effect of strain rate on the compressive deformation behaviors of lotus-type porous copper, Int. J. Miner. Metall. Mater., 21(2014), No. 7, p. 687.
D.R. Tian, Y.H. Pang, L. Yu, and L. Sun, Production and characterization of high porosity porous Fe-Cr-C alloys by the space holder leaching technique, Int. J. Miner. Metall. Mater., 23(2016), No. 7, p. 793.
C.S. Liu, Z.G. Zhu, F.S. Han, and J. Banhart, Internal friction of foamed aluminium in the range of acoustic frequencies, J. Mater. Sci., 33(1998), No. 7, p. 1769.
F.S. Han, Z.G. Zhu, C.Y. Shi, and Y. Wang, Study on the damping characteristics of foamed aluminum, Acta Phys. Sin., 47(1998), No. 7, p. 1161.
J. Banhart, J. Baumeister, and M. Weber, Damping properties of aluminium foams, Mater. Sci. Eng. A, 205(1996), No. 1-2, p. 221.
J.N. Wei, C.L. Gong, H.F. Cheng, Z.C. Zhou, Z.B. Li, J.P. Shui, and F.S. Han, Low-frequency damping behavior of foamed commercially pure aluminum, Mater. Sci. Eng. A, 332(2002), No. 1-2, p. 375.
J.J Wu, C.G Li, D.B Wang, and M.C Gui, Damping and sound absorption properties of particle reinforced Al matrix composite foams, Compos. Sci. Technol., 63(2003), No. 3-4, p. 569.
M.C. Gui, D.B. Wang, J.J. Wu, G.J. Yuan, and C.G. Li, Deformation and damping behaviors of foamed Al-Si-SiCp composite, Mater. Sci. Eng. A, 286(2000), No. 2, p. 282.
Y.L. Mu, G.C. Yao, and H.J. Luo, The dependence of damping property of fly ash reinforced closed-cell aluminum alloy foams on strain amplitude, Mater. Des., 31(2010), No. 2, p. 1007.
N. Ma, Q.M. Peng, J.L. Pan, H. Li, and W.L. Xiao, Effect of microalloying with rare-earth on recrystallization behaviour and damping properties of Mg sheets, J. Alloys Compd., 592(2014), p. 24.
D.H. Yang, S.R. Yang, H. Wang, A.B. Ma, J.H. Jiang, J.Q. Chen, and D.L. Wang, Compressive properties of cellular Mg foams fabricated by melt-foaming method, Mater. Sci. Eng. A, 527(2010), No. 21-22, p. 5405.
L. Chen, C.L. Liu, Q.M. Zhang, Z.G. Xu, and Y.S. Yang, Mechanical properties and energy absorption characteristic of magnesium foam under static and dynamic compression, Acta Armamentarii, 30(2009), Suppl. 2, p. 197.
Z.G. Xu, J.W. Fu, T.J. Luo, and Y.S. Yang, Effects of cell size on quasi-static compressive properties of Mg alloy foams, Mater. Des., 34(2012), p. 40.
Y. Yamada, K. Shimojima, Y. Sakaguchi, M. Mabuchi, M. Nakamura, T. Asahina, T. Mukai, H. Kanahashi, and K. Higashi, Effects of heat treatment on compressive properties of AZ91 Mg and SG91A Al foams with open-cell structure, Mater. Sci. Eng. A, 280(2000), No. 1, p. 225.
X.S. Hu, K. Wu, M.Y. Zheng, W.M. Gan, and X.J. Wang, Low frequency damping capacities and mechanical properties of Mg–Si alloys, Mater. Sci. Eng. A, 452-453(2007), p. 374.
X.S. Hu, Y.K. Zhang, M.Y. Zheng, and K. Wu, A study of damping capacities in pure Mg and Mg–Ni alloys, Scripta Mater., 52(2005), No. 11, p. 1141.
X.S. Hu, X.D. He, M.Y. Zheng, and K. Wu, Effect of small tensile deformation on damping capacities of Mg–1%Al alloy, Trans. Nonferrous Met. Soc. China, 20(2010), Suppl. 2, p. s444.
Y.W. Wu, K. Wu, K.K. Deng, K.B. Nie, X.J. Wang, X.S. Hu, and M.Y. Zheng, Damping capacities and tensile properties of magnesium matrix composites reinforced by graphite particles, Mater. Sci. Eng. A, 527(2010), No. 26, p. 6816.
Y.L. Mu, G.C. Yao, G.Y. Zu, and Z.K. Cao, Influence of strain amplitude on damping property of aluminum foams reinforced with copper-coated carbon fibers, Mater. Des., 31(2010), No. 9, p. 4423.
I.S. Golovin and H.R. Sinning, Damping in some cellular metallic materials, J. Alloys Compd., 355(2003), No. 1-2, p. 2.
Acknowledgments
This work was financially supported by the National Natural Science Foundation of China (Nos. 51174060 and 51301109), the Science and Technology Department of Liaoning Province of China (No. 2013223004), and the Fundamental Research Funds for the Central Universities (No. 140203004).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Huang, Wz., Luo, Hj., Mu, Yl. et al. Low-frequency damping behavior of closed-cell Mg alloy foams reinforced with SiC particles. Int J Miner Metall Mater 24, 701–707 (2017). https://doi.org/10.1007/s12613-017-1453-y
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12613-017-1453-y