Abstract
Natural ventilation (NV) is a relevant passive strategy for the design of buildings in seek of energy savings and the improvement of the indoor air quality and the thermal comfort. The main aim of this work is to present a comprehensive NV modeling study of a non-rectangular floor-plan dwelling. Given the arbitrary shape of the building, recourse is made to computational fluid dynamics (CFD) to determine the surface-averaged pressure coefficients (\(\overline {{C_p}} \)). The CFD model was calibrated to match experimental data from an extensive wind tunnel database for low-rise buildings. Then, \(\overline {{C_p}} \) computation via CFD is used to feed the building performance simulation software EnergyPlus, in replacement of the built-in Swami and Chandra parametric model that is only valid for estimating \(\overline {{C_p}} \) in rectangular floor-plan buildings. This computational tool is used to investigate the effect of NV on the thermal performance and the airflow rate in a social housing located in the Argentine Littoral region. Simulation results of the considered building show that NV enables to reduce even more than 65% of the cooling degree-hours. Furthermore, regarding to the \(\overline {{C_p}} \) source (either CFD or Swami and Chandra’s), it is also found that this data has a considerable effect on the airflow rates, but a little effect on the thermal performance.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
ANSI/ASHRAE (2013). American National Standards Institute (ANSI) and American Society of Heating, Refrigerating and Air-Conditioning Engineers (ASHRAE) Standard 55–2013. Thermal Environmental Conditions for Human Occupancy.
ASHRAE (2009). ASHRAE Handbook—Fundamentals. Atlanta, GA, USA: American Society of Heating, Refrigerating and Air-Conditioning Engineers.
Blocken B, Stathopoulos T, Carmeliet J (2007). CFD simulation of the atmospheric boundary layer: Wall function problems. Atmospheric Environment, 41: 238–252.
Bre F, Fachinotti VD (2016). Generation of typical meteorological years for the Argentine Littoral Region. Energy and Buildings, 129: 432–444.
Bre F, Fachinotti VD (2017). A computational multi-objective optimization method to improve energy efficiency and thermal comfort in dwellings. Energy and Buildings, 154: 283–294.
Bre F, Gimenez JM, Fachinotti VD (2018). Prediction of wind pressure coefficients on building surfaces using artificial neural networks. Energy and Buildings, 158: 1429–1441.
Breesch H, Janssens A (2010). Performance evaluation of passive cooling in office buildings based on uncertainty and sensitivity analysis. Solar Energy, 84: 1453–1467.
Chen Y, Tong Z, Malkawi A (2017). Investigating natural ventilation potentials across the globe: Regional and climatic variations. Building and Environment, 122: 386–396.
Cóstola D, Blocken B, Hensen JLM (2009). Overview of pressure coefficient data in building energy simulation and airflow network programs. Building and Environment, 44: 2027–2036.
Cóstola D, Blocken B, Ohba M, Hensen J (2010). Uncertainty in airflow rate calculations due to the use of surface-averaged pressure coefficients. Energy and Buildings, 42: 881–888.
Cóstola D, Alucci MP (2011). Aplicação de CFD para o cálculo de coeficientes de pressão externos nas aberturas de um edifício. Ambiente Construído, 11: 145–158.
Crawley DB, Lawrie LK, Winkelmann FC, Buhl WF, Huang YJ, Pedersen CO, Strand RK, Liesen RJ, Fisher DE, Witte MJ, et al. (2001). EnergyPlus: Creating a new-generation building energy simulation program. Energy and buildings, 33: 319–331.
de Dear RJ, Brager GS (2002). Thermal comfort in naturally ventilated buildings: Revisions to ASHRAE Standard 55. Energy and Buildings, 34: 549–561.
Ferziger JH, Peric M (2002). Computational Methods for Fluid Dynamics, 3rd edn. New York: Springer.
Filippín C, Ricard F, Flores Larsen S, Santamouris M (2017). Retrospective analysis of the energy consumption of single-family dwellings in central Argentina. Retrofitting and adaptation to the climate change. Renewable Energy, 101: 1226–1241.
Grosso M (1992). Wind pressure distribution around buildings: A parametrical model. Energy and Buildings, 18: 101–131.
Gu L (2007). Airflow network modeling in EnergyPlus. In: Proceedings of the 10th International IBPSA Building Simulation Conference, Beijing, China.
Hargreaves DM, Wright NG (2007). On the use of the k-e model in commercial CFD software to model the neutral atmospheric boundary layer. Journal of Wind Engineering and Industrial Aerodynamics, 95: 355–369.
Hong T, Langevin J, Sun K (2018). Building simulation: Ten challenges. Building Simulation, https://doi.org/10.1007/s12273-018-0444-x.
Intergovernmental Panel on Climate Change (2014). Climate Change 2014: Impacts, Adaptation, and Vulnerability. Part B: Regional Aspects. Contribution of Working Group IIto the Fifth Assessment Report of the Intergovernmental Panel on Climate Change. Cambridge, UK: Cambridge University Press.
Invidiata A, Ghisi E (2016). Impact of climate change on heating and cooling energy demand in houses in Brazil. Energy and Buildings, 130: 20–32.
Jones WP, Launder BE (1972). The prediction of laminarization with a two-equation model of turbulence. International Journal of Heat and Mass Transfer, 15: 301–314.
Kato M, Launder BE (1993). The modeling of turbulent flow around stationary and vibrating square cylinders. In: Proceedings of the 9th Symposium on Turbulent Shear Flows, pp. 10-4-1–10-4-6.
Menter FR (1992). Two-equation eddy-viscosity turbulence models for engineering applications. AIAA Journal, 32: 1598–1605.
Montazeri H, Blocken B (2013). CFD simulation of wind-induced pressure coefficients on buildings with and without balconies: Validation and sensitivity analysis. Building and Environment, 60: 137–149.
Muehleisen RT, Patrizi S (2013). A new parametric equation for the wind pressure coefficient for low-rise buildings. Energy and Buildings, 57:245–249.
Murakami S (1998). Overview of turbulence models applied in CWE-1997. Journal of Wind Engineering and Industrial Aerodynamics, 74: 1–24.
Murakami S, Mochida A, Hayashi Y (1990). Examining the k-ϵ model by means of a wind tunnel test and large-eddy simulation of the turbulence structure around a cube. Journal of Wind Engineering and Industrial Aerodynamics, 35: 87–100.
Ntinas GK, Shen X, Wang Y, Zhang G (2018). Evaluation of CFD turbulence models for simulating external airflow around varied building roof with wind tunnel experiment. Building Simulation, 11: 115–123.
OpenCFD (2004). OpenFOAM Programmer’s Guide. Springer.
Orme M, Leksmono N (2002). AIVC Guide 5: Ventilation modelling data guide. International Energy Agency, Air Infiltration Ventilation Center. AIC-GUI, 5.
Oropeza-Perez I, Østergaard PA (2014). The influence of an estimated energy saving due to natural ventilation on the Mexican energy system. Energy, 64: 1080–1091.
Pirayú (2015). Pirayú cluster. Available at https://doi.org/www.cimec.org.ar/ c3/pirayu. Accessed 15 May 2015.
Quan Y, Tamura Y, Matsui M, Cao S, Yoshida A (2007). TPU aerodynamic database for low-rise buildings. In: Proceedings of the 12th International Conference on Wind Engineering.
Rackes A, Melo AP, Lamberts R (2016). Naturally comfortable and sustainable: Informed design guidance and performance labeling for passive commercial buildings in hot climates. Applied Energy, 174: 256–274.
Ramponi R, Angelotti A, Blocken B (2014). Energy saving potential of night ventilation: Sensitivity to pressure coefficients for different European climates. Applied Energy, 123: 185–195.
Richards PJ, Hoxey RP, Connell BD, Lander DP (2007). Wind-tunnel modelling of the Silsoe Cube. Journal of Wind Engineering and Industrial Aerodynamics, 95: 1384–1399.
Santamouris M, Sfakianaki A, Pavlou K (2010). On the efficiency of night ventilation techniques applied to residential buildings. Energy and Buildings, 42: 1309–1313.
Sarinelli R, Clucellas P (2015). Boletín Official de la República Argentina [Argentine Official Gazzette] decreto 134/2015: Emergencia energética [Decrete 134/2015: Energy emergency]. (in Spanish)
Seppänen O, Fisk WJ (2002). Association of ventilation system type with SBS symptoms in office workers. Indoor Air, 12: 98–112.
Shih T-H, Liou WW, Shabbir A, Yang Z, Zhu J (1995). A new k-ϵ eddy viscosity model for high Reynolds number turbulent flows. Computers Fluids, 24: 227–238.
Sorgato MJ, Melo AP, Lamberts R (2016). The effect of window opening ventilation control on residential building energy consumption. Energy and Buildings, 133: 1–13.
Spalart P, Allmaras S (1992). A one-equation turbulence model for aerodynamic flows. In: Proceedings of the 30th Aerospace Sciences Meeting and Exhibit, Aerospace Sciences Meetings.
Swami MV, Chandra S (1988). Correlations for pressure distribution on buildings and calculation of natural-ventilation airflow. ASHRAE Transactions, 94 (1): 243–266.
Tominaga Y, Akabayashi S, Kitahara T, Arinami Y (2015). Air flow around isolated gable-roof buildings with different roof pitches: Wind tunnel experiments and CFD simulations. Building and Environment, 84: 204–213.
Tsuchiya M, Murakami S, Mochida A, Kondo K, Ishida Y (1997). Development of a new k-e model for flow and pressure fields around bluff body. Journal of Wind Engineering and Industrial Aerodynamics, 67: 169–182.
Walton GN (1989). AIRNET: A computer program for building airflow network modeling. Gaithersburg, MD, USA: National Institute of Standards and Technology.
Weller HG, Tabor G, Jasak H, Fureby C (1998). A tensorial approach to computational continuum mechanics using object-oriented techniques. Computers in Physics, 12: 620–631.
Wright NG, Easom GJ (2003). Non-linear k-e turbulence model results for flow over a building at full-scale. Applied Mathematical Modelling, 27: 1013–1033.
Yakhot V, Orszag SA, Thangam S, Gatski TB, Speziale CG (1992). Development of turbulence models for shear flows by a double expansion technique. Physics of Fluids A: Fluid Dynamics, 4: 1510–1520.
Yi YK, Feng N (2013). Dynamic integration between building energy simulation (BES) and computational fluid dynamics (CFD) simulation for building exterior surface. Building Simulation, 6: 297–308.
Zhai Z (2014). Computational fluid dynamics applications in green building design. In: Al-Baghdadi MARA (Ed), Computational Fluid Dynamics Applications in Green Design. International Energy and Environment Foundation (IEEF), pp. 1–22.
Zhai Z, Mankibi ME, Zoubir A (2015). Review of natural ventilation models. Energy Procedia, 78: 2700–2705.
Acknowledgements
For funding this work, we would like to thank Universidad Nacional del Litoral via CAI+D 2016 PJ 50020150100018LI. Also, we would like to thank the Agency for Science, Technology and Innovation (ASaCTeI) of the Province of Santa Fe (Argentina) via the Research Project 2010-022-16 “Optimization of the energy efficiency of buildings in the Province of Santa Fe”. The present work uses the computational resources of the Pirayú group, acquired with funds from ASaCTeI through Project AC-00010-18, Resolution N° 117/14. This equipment is part of the National System of High Performance Computing of the Argentine Ministry of Science and Technology.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Gimenez, J.M., Bre, F., Nigro, N.M. et al. Computational modeling of natural ventilation in low-rise non-rectangular floor-plan buildings. Build. Simul. 11, 1255–1271 (2018). https://doi.org/10.1007/s12273-018-0461-9
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12273-018-0461-9