Abstract
To verify the performance of a basalt fiber reinforced polymer (BFRP) fiber-encapsulated long-gauge strain sensor in railway bridge health monitoring, this paper studies the fatigue resistance and durability of the BFRP fiber-encapsulated FBG sensor under train loads. First, the influences of the length of the anchorage section and the length ratio of the sensing section on the accuracy of the sensor were studied. Then, the BFRP sensor was applied to a sleeper for 2 million cycles of tension fatigue testing. The strain-time history of the whole fatigue test was monitored and compared. After the test, a calibration test was carried out to verify the accuracy and repeatability of the sensor. Finally, the slip and fatigue cracking of the fiber in the anchorage section of the sensor were observed by electron microscopy. The results show that the gap between the anchoring section and the bare optical fiber was filled with epoxy resin, and there was no slip behavior. No fatigue cracking occurred in the fiber, and the strain coefficient and linearity of the sensor showed no obvious changes after 2 million cycles of loading. The long-gauge strain sensor encapsulated by BFRP fibers exhibited good fatigue resistance and can meet long-term monitoring requirements under train loads.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Ang J, Li H, Herszberg I, Bannister M, Mouritz A (2010) Tensile fatigue properties of fibre Bragg grating optical fibre sensors. International Journal of Fatigue 32(4):762–768, DOI: https://doi.org/10.1016/j.ijfatigue.2009.11.002
Calderón PA, Glisic B (2012) Influence of mechanical and geometrical properties of embedded long-gauge strain sensors on the accuracy of strain measurement. Measurement Science Technology 23(6):065604, DOI: https://doi.org/10.1088/0957-0233/23/6/065604
Chen S-Z, Wu G, Feng D-C (2019a) Damage detection of highway bridges based on long-gauge strain response under stochastic traffic flow. Mechanical Systems Signal Processing 127:551–572, DOI: https://doi.org/10.1016/j.ymssp.2019.03.022
Chen S-Z, Wu G, Feng D-C (2019b) Development of a bridge weigh-in-motion method considering the presence of multiple vehicles. Engineering Structures 191:724–739, DOI: https://doi.org/10.1016/j.engstruct.2019.04.095
Fanelli P, Biscarini C, Jannelli E, Ubertini F, Ubertini S (2017) Structural health monitoring of cylindrical bodies under impulsive hydrodynamic loading by distributed FBG strain measurements. Measurement Science and Technology 28(2):024006, DOI: https://doi.org/10.1088/1361-6501/aa4eac
Frieling G, Walther F (2013) Tensile and fatigue properties of fiber-bragg-grating (FBG) sensors. Sensors & Transducers 154(7):143–148
Glisic B (2011) Influence of the gauge length on the accuracy of long-gauge sensors employed in monitoring of prismatic beams. Measurement Science Technology 22(3):035206, DOI: https://doi.org/10.1088/0957-0233/22/3/035206
Górriz BT, García PC, Payá-Zaforteza IJ, Maicas SS (2014) Experimental and numerical analysis of a hybrid FBG long gauge sensor for structural health monitoring. Measurement Science and Technology 25(12):125107, DOI: https://doi.org/10.1088/0957-0233/25/12/125107
Gy R (2003) Stress corrosion of silicate glass: A review. Journal of Non-Crystalline Solids 316(1):1–11, DOI: https://doi.org/10.1016/s0022-3093(02)01931-2
Herszberg I, Bannister M, Li H, Qi B, Marsden J (2007) Durability under fatigue loading of optical fibres applied to fibre reinforced plastic composites. The International Society for Optical Engineering 6619, DOI: https://doi.org/10.1117/12.738395
Li S, Chen S (2018) Structural health monitoring of maglev guideway PC girders with distributed long-gauge FBG sensors. Structural Control and Health Monitoring 25(1):e2046, DOI: https://doi.org/10.1002/stc.2046
Matthewson MJ, Padiyar V (2001) Cyclic fatigue of high-strength optical fibers in bending. International Society for Optics and Photonics 53–59, DOI: https://doi.org/10.1117/12.424383
Moyo P, Brownjohn J, Suresh R, Tjin S (2005) Development of fiber Bragg grating sensors for monitoring civil infrastructure. Engineering Structures 27(12):1828–1834, DOI: https://doi.org/10.1016/j.engstruct.2005.04.023
Mrad N, Sparling S, Laliberte J (1999) Strain monitoring and fatigue life of Bragg grating fiber optic sensors. The International Society for Optical Engineering 3670:82–91, DOI: https://doi.org/10.1117/12.349717
Prohaska JD, Snitzer E, Chen B, Maher MH, Nawy E, Morey WW (1993) Fiber optic Bragg grating strain sensor in large-scale concrete structures. The International Society for Optical Engineering 1798(1798):286–294, DOI: https://doi.org/10.1117/12.141330
Saccomandi P, Oddo CM, Zollo L, Formica D, Romeo RA, Massaroni C, Caponero MA, Vitiello N, Guglielmelli E, Silvestri S (2015) Feedforward neural network for force coding of an MRI-compatible tactile sensor array based on fiber Bragg grating. Journal of Sensors 2015, DOI: https://doi.org/10.1155/2015/367194
Tang Y (2013) Research on structural intelligence based on distributed optical fiber sensing and self-sensing FRP. PhD Thesis, Southeast University, Nanjing, China, DOI: https://doi.org/10.7666/d.Y2511461
Tang Y, Wu Z, Yang C, Shen S, Wu G, Hong W (2009) Development of self-sensing BFRP bars with distributed optic fiber sensors, smart sensor phenomena, technology, networks, and systems 2009. International Society for Optics and Photonics 729317, DOI: https://doi.org/10.1117/12.815767
TB/T 1878-2002 (2002) Fatigue test method for prestressed concrete sleepers. TB/T 1878-2002, Ministry of Railways of the people’s Republic of China, Beijing, China
Torres Górriz B, Rinaudo P, Calderón García PA (2017) Comparison between point and long-gage FBG-based strain sensors during a railway bridge load test. Strain 53(4):e12230, DOI: https://doi.org/10.1111/str.12230
Villalba S, Casas JR (2013) Application of optical fiber distributed sensing to health monitoring of concrete structures. Mechanical Systems Signal Processing 39(1–2):441–451, DOI: https://doi.org/10.1016/j.ymssp.2012.01.027
Wang H, Xiang P, Jiang L (2019) Strain transfer theory of industrialized optical fiber-based sensors in civil engineering: A review on measurement accuracy, design and calibration. Sensors Actuators A: Physical 285:414–426, DOI: https://doi.org/10.1016/j.sna.2018.11.019
Wang H, Xiang P, Li X (2016) Theoretical analysis on strain transfer error of FBG sensors attached on steel structures subjected to fatigue load. Strain 52(6):522–530, DOI: https://doi.org/10.1111/str.12195
Wu B, Wu G, Lu H, Feng D-C (2017) Stiffness monitoring and damage assessment of bridges under moving vehicular loads using spatially-distributed optical fiber sensors. Smart Materials Structures 26(3): 035058, DOI: https://doi.org/10.1088/1361-665x/aa5c6f
Wu B, Wu G, Yang C, He Y (2016) Damage identification and bearing capacity evaluation of bridges based on distributed long-gauge strain envelope line under moving vehicle loads. Journal of Intelligent Material Systems Structures 27(17):2344–2358, DOI: https://doi.org/10.1177/1045389x16629571
Wu B, Wu G, Yang C, He Y (2018) Damage identification method for continuous girder bridges based on spatially-distributed long-gauge strain sensing under moving loads. Mechanical Systems Signal Processing 104:415–435, DOI: https://doi.org/10.1016/j.ymssp.2017.10.040
Zhang J, Guo S, Wu Z, Zhang Q (2015) Structural identification and damage detection through long-gauge strain measurements. Engineering Structures 99:173–183, DOI: https://doi.org/10.1016/j.engstruct.2015.04.024
Zhou Z, Graver TW, Hsu L, Ou JP (2003) Techniques of advanced FBG sensors: Fabrication, demodulation, encapsulation and their application in the structural health monitoring of bridges. Pacific Science Review 5(1):116–121
Zhou Z, Wang Z, Shao L (2016) Fiber-reinforced polymer-packaged optical fiber Bragg grating strain sensors for infrastructures under harsh environment. Journal of Sensors, DOI: https://doi.org/10.1155/2016/3953750
Acknowledgments
This paper is supported by the National Natural Science Foundation of China (Grant No. 51808219), Natural Science Foundation of Jiangxi Province (Grant No. 20202BAB214024, 20212BAB204010), and China Postdoctoral Foundation (Grant No. 2018M640607).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Wu, B., Zhou, Y., Lu, H. et al. Fatigue Resistance of a BFRP-Encapsulated Long-Gauge FBG Strain Sensor under Cyclic Train Loads. KSCE J Civ Eng 26, 3945–3953 (2022). https://doi.org/10.1007/s12205-022-1355-z
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12205-022-1355-z