Abstract
The aim of this study is to develop concrete composites that are resistant to armor-piercing projectiles for defense structures. Different reinforcement configurations have been tested, such as short steel fibers, long steel fibers, and steel mesh reinforcement. Three different concrete mix designs were prepared as “Ultra High Performance (UHPFRC), High Performance (HPFRC) and Conventional (CFRC) Fiber Reinforced Concrete”. The content of hybrid steel fibers was approximately 5% in the UHPFRC and HPFRC mixtures, while the steel fiber content was approximately 2.5% in the CFRC mixture. In addition, a plain state of each mixture was produced. Mechanical properties of concrete were determined in experimental studies. In addition to the fracture energy and impact strength, two important indicators of ballistic performance of concrete are examined, which are the penetration depth and damage area. The results of the study show that the depth of penetration in UHPFRC was around 35% less than that in HPFRC. It was determined that the mixtures of UHPFRC and HPFRC containing 5% by volume of hybrid steel fibers showed superior performance (smaller crater diameter and the less projectile penetration depth) against armor-piercing projectiles in ballistic tests and could be used in defense structures.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Yazici S, Sezer G I. Effect of aggregate maximum size on impact resistance of steel fiber reinforced concrete. Pamukkale University Journal of Engineering Sciences, 2008, 14: 237–245
Dancygier A N, Yankelevsky D Z. High strength concrete response to hard projectile impact. International Journal of Impact Engineering, 1996, 18(6): 583–599
Xia Y, Wu C, Liu Z X, Yuan Y. Protective effect of graded density aluminium foam on RC slab under blast loading—An experimental study. Construction & Building Materials, 2016, 111: 209–222
Hu D, Zhang Y, Shen Z, Cai Q. Investigation on the ballistic behavior of mosaic SiC/UHMWPE composite armor systems. Ceramics International, 2017, 43(13): 10368–10376
Banthia N, Mindess S, Trottier J F. Impact resistance of steel fiber reinforced concrete. ACI Materials Journal, 1996, 93(5): 472–479
Tasdemir M A Bayramov F. Mechanical behavior of high performance cement based composites. ITU Journal/Engineering, 1(2): 125–144
Maalej M, Quek S T, Zhang J. Behavior of hybrid-fiber engineered cementitious composites subjected to dynamic tensile loading and projectile impact. Journal of Materials in Civil Engineering, 2005, 17(2): 143–152
Dancygier A N, Yankelevsky D Z, Jaegermann C. Response of high performance concrete plates to impact of non-deforming projectiles. International Journal of Impact Engineering, 2007, 34(11): 1768–1779
Akcay B, Tasdemir M A. Mechanical behavior and fiber dispersion of hybrid steel fiber reinforced self-compacting concrete. Construction & Building Materials, 2012, 28(1): 287–293
Akcay B, Ozsar D S. Do polymer fibers affect the distribution of steel fibers in hybrid fiber reinforced concretes? Construction & Building Materials, 2019, 228(20): 116732
Ozalp F. Mechanical behavior of ultra-high-performance concrete. Thesis for the Master’s Degree. Istanbul: Istanbul Technical University, 2006
Ozalp F, Akkaya Y, Sengül C, Akçay B, Taşdemir M A. Curing effects on fracture of high-performance cement based composites with hybrid steel fibers. In: International Association of Fracture Mechanics for Concrete and Concrete Structures (Framcos-6). Catania: Taylor & Francis, 2007
Zhang M H, Shim V P W, Lu G, Chew C W. Resistance of high-strength concrete to projectile impact. International Journal of Impact Engineering, 2005, 31(7): 825–841
Luo X, Sun W, Chan S Y N. Characteristics of high-performance steel fiber-reinforced concrete subject to high velocity impact. Cement and Concrete Research, 2000, 30(6): 907–914
Clifton J R, Knab L I. Impact test of concrete. Cement and Concrete Research, 1983, 13(4): 541–548
Liu J. Penetration response of ultra-high-performance concrete (UHPC) under projectile impact. Dissertation for the Doctoral Degree. Sydney: University of Technology Sydney, 2018
Habel K. Impact response of post-tensioned and reinforced concrete members with an UHPFRC overlay. Fracture Mechanics of Concrete and Concrete Structures—Recent Advances in Fracture Mechanics of Concrete. Proceedings of FraMCoS, 2010, 7: 437–444
Yoo D Y, Banthia N. Impact resistance of fiber-reinforced concrete—A review. Cement and Concrete Composites, 2019, 104: 103389
Malvar L J, Crawford J E, Wesevich J W, Simons D. A plasticity concrete material model for DYNA3D. International Journal of Impact Engineering, 1997, 19(9–10): 847–873
Tai Y S, Tang C C. Numerical simulation: The dynamic behavior of reinforced concrete plates under normal impact. Theoretical and Applied Fracture Mechanics, 2006, 45(2): 117–127
Vegt I, Breugel V K, Weerheijm J. Failure mechanisms of concrete under impact loading. Fracture Mechanics of Concrete and Concrete Structures, 2007, 1: 579–587
Yu R, Spiesz P, Brouwers H J H. Energy absorption capacity of a sustainable Ultra-High-Performance Fiber Reinforced Concrete (UHPFRC) in quasi-static mode and under high velocity projectile impact. Cement and Concrete Composites, 2016, 68: 109–122
Máca P, Sovják R, Konvalinka P. Mix design of UHPFRC and its response to projectile impact. International Journal of Impact Engineering, 2014, 63: 158–163
Máca P, Sovják R. Resistance of ultra high performance fiber reinforced concrete to projectile impact. Structures Under Shock and Impact XII, 2013, 126: 261
Maalej M, Zhang J, Quek S T, Lee S C. High-velocity impact resistance of hybrid-fiber engineered cementitious composites. Fracture Mechanics of Concrete Structures, 2004: 1051–1058
Yu R, Spiesz P, Brouwers H J H. Static properties and impact resistance of a green Ultra-High Performance Hybrid Fiber Reinforced Concrete (UHPHFRC): Experiments and modeling. Construction & Building Materials, 2014, 68: 158–171
Oh R O, Park C G. Mechanical properties and impact resistance of hybrid fiber reinforced concrete with type of reinforcing fibers for precast concrete. Journal of the Korean Society of Agricultural Engineers, 2013, 55(4): 29–35
He D, Wu M, Jie P. Study on mechanical properties of hybrid fiber reinforced concrete. IOP Conference Series. Earth and Environmental Science, 2017, 100(1): 012111
Nam J, Shinohara Y, Atou T, Kim H, Kim G. Impact resistant performance of ductile fiber reinforced cementitious composites (DFRCCs). In: The 9th International Conference on Fracture Mechanics of Concrete and Concrete Structures. Berkeley: IA-FraMCoS, 2016
Murali G, Abid S R, Amran Y M, Abdelgader H S, Fediuk R, Susrutha A, Poonguzhali K. Impact performance of novel multi-layered prepacked aggregate fibrous composites under compression and bending. Structures, 2020, 28: 1502–1515
Haridharan M K, Matheswaran S, Murali G, Abid S R, Fediuk R, Amran Y M, Abdelgader H S. Impact response of two-layered grouted aggregate fibrous concrete composite under falling mass impact. Construction & Building Materials, 2020, 263: 120628
Zhang F, Poh L H, Zhang M H. Critical parameters for the penetration depth in cement-based materials subjected to small caliber non-deformable projectile impact. International Journal of Impact Engineering, 2020, 137: 103471
Li P P, Brouwers H J H, Yu Q. Influence of key design parameters of ultra-high performance fiber reinforced concrete on in-service bullet resistance. International Journal of Impact Engineering, 2020, 136: 103434
RILEM 50-FMC. Determination of fracture energy of mortar and concrete by means of three-point bend tests on notched beams. Materials and Structures, 1985, 18(106): 285–290
ACI Committee 544. Measurement of Properties of Fiber Reinforced Concrete. ACI Report 544.2R-89. 1999
EN 1063. Security Glazing Testing and Classification of Resistance against Bullet Attack. London: BSI, 1999
Badr A, Ashour A F, Platten A K. Statistical variations in impact resistance of polypropylene fiber-reinforced concrete. International Journal of Impact Engineering, 2006, 32(11): 1907–1920
Banthia N, Trottier J F. Concrete reinforced with deformed steel fibers, part ii: toughness characterization. ACI Materials Journal, 1995, 92(2): 146–154
Barros J A O, Figueiras J A. Flexural behavior of SFRC: Testing and modeling. Journal of Materials in Civil Engineering, 1999, 11(4): 331–339
Acknowledgements
This work was completed when the first author was R&D Manager at ISTON. The authors would like to thank ISTON Corporation and its R&D employees for their contributions.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Özalp, F., Yilmaz, H.D. & Akcay, B. Mechanical properties and impact resistance of concrete composites with hybrid steel fibers. Front. Struct. Civ. Eng. 16, 615–623 (2022). https://doi.org/10.1007/s11709-022-0828-y
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11709-022-0828-y