Abstract
Micro gas turbine (MGT) is widely used in small-scale distributed power systems because of its low emissions and fuel flexibility. However, the under-utilization of its exhaust heat and the low electric efficiency are the main bottlenecks that restrict its application. Additionally, the flexible switching between the power generated by the MGT and the power grid is also a key factor for keeping the secure operation of a distributed power station. Therefore, this paper conducted some experimental investigations of a 30 kW MGT to provide reference solutions for the above issues. This MGT is located at Shanghai Jiao Tong University (SJTU), which is designed by the Gas Turbine Research Institute of SJTU, and is manufactured by a turbo-machinery factory in Chongqing, China. The demonstration prototype is mainly composed of a single stage centrifugal compressor, a radial turbine, a combustor, a high-speed permanent magnet generator, and a control system. The results show that the MGT can achieve steady operation at a low rotational speed from 10000 r/min to 34000 r/min in the case of using oil lubricated bearings, which can greatly reduce the economic cost compared with the use of air bearings. At the same time, the ignition success rate of combustion chamber (CC) reaches 98% at a low rotational speed, and a wide range of stable combustion area can be obtained, because of the novel design method of combustor by referencing the way applied in an axial flow aero-engine. The MGT generating set can achieve functions, such as starting up, ignition, stable operation, loaded operation, grid-connection and stopping. This system also can realize flexibly switching from the start motor mode to the generator mode, and from grid-connected mode to off-grid mode, because the innovative multi-state switching control system is adopted. The above research work can make our state master independent intellectual property rights of micro gas turbine, rather than continue to be subject to the technological monopoly of the developed states, which can provide theoretical and experimental support for the industrialization of MGT in China.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Li Y, Xia Y. DES/CCHP: the best utilization mode of natural gas for China’s low carbon economy. Energy Policy, 2013, 53: 477–483
Carvalho M, Lozano M A, Serra L M. Multi-criteria synthesis of trigeneration systems considering economic and environmental aspects. Applied Energy, 2012, 91(1): 245–254
Sheikhi A, Ranjbar A M, Oraee H. Financial analysis and optimal size and operation for a multicarrier energy system. Energy and Buildings, 2012, 48: 71–78
Weng S L, Weng Y W. Distributed energy system in the Yangtze River delta region. Technical report, Shanghai Consulting & Academic Activities Center for Academicians of Chinese Academy of Engineering, 2018
Jon L. Run up to the millennium: state of the power generation gas industry. Global Gas Turbine News, 2000, 40(1): 9–12
Lee S L. Gas turbine industry overview. Global Gas Turbine News, 2000, 40(1): 5–8
Capstone Turbine Corporation. Capstone low emissions micro turbine technology. White Paper, 2000, available at the website of bioturbine
Datasheets P. Capstone Turbine Corporation. 2020, available at the website of capstoneturbine
Energy Office of the Ministry of Science and Technology. Key Project Feasibility Report of National High-tech Research and Development Plan of Distributed Energy System in Yangtze River Delta Region. Beijing, 2002
Eleni A, Thomas M, Andreas H, Manfred A. Experiment investigation of an inverted Brayton Cycle Micro Gas Turbine for CHP application. In: Proceedings of ASME Turbo Expo 2017: Turbomachinery Technical Conference and Exposition, Charlotte, North Carolina, USA, 2017
Inoue K, Harada E, Kitajima J, Tanaka K. Construction and performance evaluation of prototype atmospheric pressure turbine (APT). In: Proceedings of ASME Turbo Expo 2006: Power for Land, Sea and Air, Barcelona, Spain, 2006
Tanaka K, Inoue K, Kitajima J. The development of 50 kW output power atmospheric pressure turbine (APT). In: Proceedings of ASME Turbo Expo 2007: Power for Land, Sea and Air, Montreal, Canada, 2007
Ward D P, Marina M C, Alessandro P. Toward higher micro gas turbine efficiency and flexibility—humidified micro gas turbines: a review. Journal of Engineering for Gas Turbines and Power, 2018, 140(8): 081702
Alireza N, Shervin S, Masoud B, Abolghasem M T. Experimental investigation of inlet distortion effect on performance of a micro gas turbine. Journal of Engineering for Gas Turbines and Power, 2018, 140(9): 092604
Krummrein T, Henke M, Kutne P. A highly flexible approach on the steady-state analysis of innovative micro gas turbine cycles. ASME Journal of Engineering for Gas Turbines and Power, 2018, 140(12): 121018
Wang Z, Qin R. Theory of Turbomachinery. Beijing: China Machine Press, 1988 (in Chinese)
Saravanamuttoo H I H, Rogers G F C, Cohen H. Gas Turbine Theory. 5th ed. London: Longman, 2001
Acknowledgements
The work was supported by the National Natural Science Foundation of China (Grant No. 51806137), and Shanghai Sailing Program (Grant No. 20QA1404700).
Author information
Authors and Affiliations
Corresponding authors
Rights and permissions
About this article
Cite this article
Lv, X., Zeng, W., Ding, X. et al. Experimental investigation of a novel micro gas turbine with flexible switching function for distributed power system. Front. Energy 14, 790–800 (2020). https://doi.org/10.1007/s11708-020-0691-2
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11708-020-0691-2